BT20M07TX EK4000 / AG [TV]

• No AV2.
• Stuck in standby. LED blinks .
• Blue picture. at start-up. No picture. No audio (after a while).
• Spots in picture.
• Picture approx. 3cm vertically. (BT20M07TX AG repair tip)
• Text and OSD run through from top to bottom. Black bar runs through, when OSD not available. (BT20M07TX AG repair tip)
• Low brightness. Low contrast.
• Intermittent red flashes with retrace lines on picture, a few times, then goes to standby.
• Low HT.
• Black horizontal lines in picture. No menu OSD. No TXT.
• Skips channels during tuning.
• Stuck in standby.
• Picture size varies with picture content.
• Poor picture. Snow in picture.
• No picture. Audio OK .
• No picture, only snow. (BT20M07TX AG repair tip)
• Tripping. LED blinks . (BT20M07TX tips)
• Vertical jitter.
• Diagonal line in picture. No OSD.
• Enter service mode. (BT20M07TX AG repair tip)
• Flickers, goes out.
• T601 faulty.
• Picture shifted horizontally.
• Shuts down.
• Basic features.
• No picture. via SCART.
• No line drive. Switches to standby. after a few seconds.
• No or dark picture. (BT20M07TX AG repair tip)
• Shuts down. intermittently.
• No synchronisation.
• No picture. via AV. Audio OK .
• Screen is bright with flyback lines, switches off after a short time.
• Dead.
• Blue line on screen. (BT20M07TX tip from AG)
• Vertical size varies (intermittently).
• No OSD sync.
• Shuts down. after start-up. Standby LED flashes .
• No start-up from standby.
• No OSD.
• No picture.
• Vertical collapse. Horizontal collapse.
• No tuning. No picture, only snow. (BT20M07TX AG repair tip)
• Tripping.
• No switch on. Standby LED becomes darker and switches back to standby.
• Black horizontal lines on picture.
• Flickering picture. Hum bar (when cold).
• No channels.
• At switch on, EHT crackles then appliance trips.
• Blurred picture, with green cast and flyback lines.
• FET keep blowing.
• Picture is only half its size.