VANGOGHROYAL1777VT / BAUR [TV]

• The appliance breaks down after some time. The LED for standby is also off.
• Enter service mode.
• Whistling. No switch on.
• Dead.
• Horizontal interference lines, especially on UHF channels.
• Picture changes with the volume. The 140V is unstable.
• Middle LED flashes at switch on or off. No RC commands.
• Tuning unstable.
• Connection of a loop system to the TV.
• No picture, sound and OSD are OK.
• No colour on SECAM.
• One predominant colour, flyback lines.
• Switches to safety mode at switch on from cold. Orange LED flashing. OK after switching on 3 to 4 times.
• No audio. No picture.
• Transistor TS7618 is intermittent (short circuit).
• Some or all channels are lost.
• No TXT possible, channel display runs sloping over the screen, occasionally stops for a short time.
• Slow start up of raster.
• Sound output stage defective as a result of ESD.
• No vertical synchronization with NV-J35EV.
• No start-up.
• Blank raster when switching on, setting "TV" with remote control.
• Interference on channel 5.
• No function, squeaking.
• No adjustment of contrast.
• No sound via tuner.
• Intermittent slow start of picture. No sound.
• One dominant colour, flyback lines.
• Modification U1008-U1555 AG07 and AG08.
• Tuning drifts.
• No picture. Sound O.K. After using TXT picture O.K.
• Sometimes no synchronization.
• Poor picture.
• Occasionally picture fails. After IF no signal. IF has been replaced. Voltage is ok.
• Safety test after repair.
• No picture.
• Metallic sound. E/W defective, horizontal size too small. (BAUR - VANGOGHROYAL1777VT information)
• Will not tune on some channels. (BAUR - VANGOGHROYAL1777VT information)
• No tuning. (VANGOGHROYAL1777VT tip from BAUR)
• Picture cuts out after 1 min. Grey screen. No tuner signal. Does not stop in channel search. Picture OK via SCART. Picture returns after switching off for two mins and switching on again.
• Picture shrinks at top of screen until TXT lines become visible.
• Brightness too high/flyback line visible.
• Over-voltage circuit active.
• Switches off after a while.
• No picture via EXT1. Sound OK.
• Switches off after approx half an hour operation. Standby LED switches off. Can only be restarted with mains. Functions half an hour, then switches off.
• Tuning is not possible.
• Black horizontal bars in picture.
• No 140 V.
• No E/W correction.
• No picture, sound OK.
• Less contrast in EXT1/EXT2 mode.
• Appliance hiccups.
• Hum in standby with HiFi models. What about IC7210 - there is no verb ?
• Teletext faults. Does not function. (VANGOGHROYAL1777VT tip from BAUR)
• No picture or sound after repeated switch off.
• No functions.
• Teletext faults. Characters wrong.
• Low sound at max volume.
• No function. Power supply OK.
• Fine, black bands on the whole picture.
• No vertical deflection.
• Moire on channel 5 (175 MHz).