2197T / BELSTAR [TV]

• No function, LED blinks after a while from red to green.
• No function. Mains fuse is black.
• Stretched picture. E/W fault.
• Dead.
• Switches to protection mode.
• PSU defective.
• No picture. Audio OK .
• Vertical line tearing by bright-dark vertical picture transition.
• Enter service mode.
• No RC functions.
• No TXT.
• No start-up. LED is red . (2197T tips)
• No start-up. LED is green.
• No start-up. LED blinks . (2197T tip from BELSTAR)
• No standby, crackle at switch on. (service info for BELSTAR -2197T)
• Red LED flashes.
• Protection mode activated.
• No channel storage. No service adjustment storage.
• Switches intermittently on and then switches automatically off.
• E/W fault.
• OSD available only in English. Language cannot be adjusted. (service info for BELSTAR -2197T)
• No picture. Retrace lines. Audio OK .
• Horizontal output failure. (2197T tip from BELSTAR)
• Programmed programme sites only receive S21.
• Dead. Cracking is audible at start-up.
• Transistor (BUZ90) fails.
• Wavy picture.
• No start-up. intermittently. (BELSTAR - 2197T information)
• Does not switch on immediately but after approx 5 min can be started from standby.
• No start-up.
• S/C in PSU.
• Picture edges tear depending on beam current.
• E/W fault. Excessive horizontal size.
• No raster.
• Picture size varies with picture content.
• No picture.
• Line transformer has flash-over. (2197T BELSTAR repair tip)
• No picture. Sound OK. LED green.
• R717 is burnt.
• PSU pulsates. LED blinks orange .
• Vertical ondulating line.
• Geometry changes.
• Mains chopper transistor fails immediately after switch on.
• Slight line tearing when too much white in picture.
• No functions.
• No picture. Audio OK .
• Frayed vertical lines, intermittently no OSD.
• Cycles on/off. after warm-up. Knock sensitive.
• No audio. No picture.
• Vertical fault. Lower third of picture is black, on upper picture edge fine coloured lines.