ECOM17B / CENTRUM [TV 16:9]

• One colour missing.
• Tuning only on band I, channel 5 and S channel 5. Only moire and no sound when manually tuning to other channels.
• No start-up. (CENTRUM - ECOM17B information)
• Horizontal wavy line.
• Reduced horizontal size.
• No vertical deflection.
• Vertical deflection fails intermittently after appliance has warmed up (top third of the screen is dark). Not knocksensitive.
• Vertical line.
• PSU pulsates.
• Crack on sound.
• No picture. Sound present and CRT heats up. Vertical deflection present.
• Can be switched on. No horizontal deflection.
• PSU doesn't start up at 230V. Starts up at 150V.
• Can be switched on and picture tries to build up. Then switches immediately to standby.
• Ticking noise.
• E/W fault (intermittently). (service info for CENTRUM -ECOM17B)
• No audio. No picture.
• No functions.
• Stuck in standby.
• White value cannot be adjusted.
• E/W fault.
• No picture. Noise from flyback transformer. Poor line drive. Sound OK.
• No picture, only colour outlines (Y is missing), OSD and sound OK.
• HV builds up.
• No start-up. LED is green.
• Switches on. Sound available and picture appears briefly. Then switches to standby.
• Only brief start up/ pumps.
• No focus. Flyback lines. Audio OK .
• No function. No standby display.
• Alternative wide, horizontal black and white stripes run through picture. Fast ticking noise. No sound.
• Shuts down (intermittently).
• Switches only with RC. Only menu can be selected. Only a few lines of the OSD are visible.
• Excessive horizontal size. E/W fault.
• No start-up from standby (intermittently).
• No functions. LED is green.
• Vertical foldover at top.
• Blue picture.
• Output stage transistor defective.
• No reception. Only S 6.
• Horizontal lines. on upper half screen.
• Red missing. Red streaking in picture.
• No OSD, no TXT, runs through unsynchronised.
• No HV. (ECOM17B CENTRUM repair tip)
• Low contrast. Excessive green.
• Starts and functions normally. Switches off after some time in any function and cannot be started again. Can then be started again and fault repeats itself. Red and green LED are not lit during fault.
• No sound. Display bar reacts. (CENTRUM - ECOM17B information)
• Dead. (ECOM17B CENTRUM repair tip)
• Picture only present in the top third and severely compressed/ geometrically distorted.
• No LED, colour television receiver does not start up.
• Horizontal size varies.
• No sound. Picture ok but no TXT picture from the scart socket.
• No picture. Audio OK .
• Geometry distortions move across the screen, suddenly OK, then the same again .
• Distorted audio.
• Picture too large with slight E/W distortion.
• LED gets green from red, then no function.
• Switches to standby. after a few seconds.
• Distorted picture. Line tearing.
• No function. PSU tries to start up approx every 4 secs. LED remains dark.
• Picture is superimposed with slight vertical shift.
• Dark picture. Low contrast.
• White, discontinuous horizontal lines. (ECOM17B tips)
• No TXT. No menu display. Only left frame of the menu field visible.
• No audio. Picture OK . (ECOM17B tip from CENTRUM)
• Enter service mode.
• Picture suddenly too bright and opaque. Sound present.
• No picture.
• No picture. No sound. Can be switched over via RC. OSD and TXT ok. (service info for CENTRUM -ECOM17B)
• Cannot find stations. Only black picture with negative picture content with manual programming.
• E/W fault and mouse teeth when cold.