514 / CGE [TV]

• Noise or no tuning. Raster and graphics OK.
• Vertical fault.
• Intermittently no sound or picture. (514 tips)
• Buttons lock out. No RC.
• Field linearity. Tuner drift.
• No sound present. Cannot be switched over with the RCU.
• No start-up. intermittently.
• No OSD.
• Intermittent picture flashing. Burning smell and it went to a line across middle.
• Dead.
• No picture. OSD OK .
• No picture. after a while (intermittently).
• No picture. after a few seconds. Audio OK .
• Excessive horizontal size.
• Pink picture when colour increased. Grey scale OK.
• Ringing in picture. on the left. (514 tips)
• No TXT or garbled TXT.
• No raster.
• Dark screen. Sound present. (514 tips)
• Searches for channels continuously.
• Dark picture. Loud crackling. (514 CGE repair tip)
• Powers up then jumps in and out of standby. No picture.
• Cycles on/off.
• Blank raster. OSD OK .
• Line output transformer arcing to chassis.
• Tripping.
• Picture is noisy, cuts out or collapses vertically and horizontally.
• Dead. after a few minutes. (514 tips)
• Chopper transistor blows intermittently.
• Dead after 30 mins.
• No picture. No audio. Switches to standby.
• Ticking noises from the right loudspeaker - only during mono transmissions.
• Blank raster. Flyback lines.
• Intermittently dead. Standby LED lit .
• Intermittently dead. (CGE - 514 information)
• Vertical white line. in the centre.
• Dead. Burning smell.
• Stuck in standby. (CGE - 514 information)
• No OSD. TXT OK .
• Audio remains in STANDBY mode.
• Green picture. Flyback lines.
• Ballooning effect.
• No picture or frame collapse. (514 tip from CGE)
• Snowy raster. No tuning.
• No signal.
• Dead with ticking noise from loud speakers.
• Buzz in audio.
• Crackling audio. Picture OK .
• Excessive HV.
• OSGs incorrect size.
• Pink screen when colour increased. (service info for CGE -514)
• No picture. intermittently. OSD OK .
• Vertical collapse. (514 tips)
• LEDs intermittently go on and off.
• Reduced width, frame collapse and no sound. (CGE - 514 information)
• Switches to standby. after start-up (intermittently).
• No picture.
• Intermittently no vertical sync.
• Does not switch to standby.
• Sound only, cannot be switched with remote control.
• No start-up. Plopping noise from speaker.
• No start-up. Standby LED does not light.
• Does not respond to RC or user control.
• Intermittently picture fades or no picture at start up.
• No picture. Raster OK .
• No signal. intermittently. OSD OK .
• No picture. No line drive.
• Unstable picture. Patterns in picture.
• No sound after I701 has been replaced.
• Snow in picture.
• No picture. EHT crackles. Sound OK.