MND49I / DANTAX [TV]

• Vertical size varies (intermittently).
• Vertical collapse. Horizontal collapse.
• No line drive. Switches to standby. after a few seconds.
• No tuning. No picture, only snow.
• Low HT.
• Spots in picture.
• Picture approx. 3cm vertically.
• Flickering picture. Hum bar (when cold).
• Black horizontal lines in picture. No menu OSD. No TXT.
• No OSD sync.
• Picture is only half its size.
• Blue line on screen.
• Tripping.
• Text and OSD run through from top to bottom. Black bar runs through, when OSD not available.
• At switch on, EHT crackles then appliance trips.
• Picture shifted horizontally.
• Enter service mode.
• No or dark picture.
• No picture. Audio OK . (MND49I tips)
• No OSD.
• Intermittent red flashes with retrace lines on picture, a few times, then goes to standby. (MND49I tips)
• No switch on. Standby LED becomes darker and switches back to standby.
• No picture.
• Black horizontal lines on picture.
• Stuck in standby.
• No picture, only snow.
• Vertical jitter.
• No synchronisation.
• Stuck in standby. LED blinks .
• Dead.
• Shuts down. after start-up. Standby LED flashes .
• Shuts down. intermittently. (MND49I tips)
• Tripping. LED blinks .
• FET keep blowing.
• Diagonal line in picture. No OSD.
• Screen is bright with flyback lines, switches off after a short time. (DANTAX - MND49I information)
• No channels.
• T601 faulty.
• Shuts down.
• Skips channels during tuning.
• No AV2. (MND49I tips)
• Low brightness. Low contrast.
• Poor picture. Snow in picture. (MND49I tip from DANTAX)
• Flickers, goes out.
• No picture. via AV. Audio OK . (MND49I tips)
• Picture size varies with picture content.
• No picture. via SCART.
• Blurred picture, with green cast and flyback lines.
• Basic features.
• Blue picture. at start-up. No picture. No audio (after a while).
• No start-up from standby.