TLD200 / DANTAX [TV]

• Stuck in standby. (TLD200 tip from DANTAX)
• Picture changes depending on the beam current in the picture size.
• Dead with ticking noise.
• No horizontal deflection.
• No picture.
• No BG.
• Dead.
• Reduced vertical size. Lines in picture. (TLD200 tip from DANTAX)
• Picture width pulsates very strongly. Intermittently poor E/W and is difficult to adjust.
• Dead. High pitched ticking noise. (DANTAX - TLD200 information)
• White screen.
• Pulsating picture. (service info for DANTAX -TLD200)
• Intermittent height.
• No picture. Audio OK .
• Switches to standby after operation. Poor standby LED.
• Basic features.
• Stretched picture.
• Retrace lines.
• Poor picture. Noise in audio.
• Vertical collapse.
• E/W-error.
• Smokes, then dead.
• Poor response to RC or switches image and sound at random.
• No start-up (intermittently).
• Spot after switch off
• Afterglow at switch off. (TLD200 tips)
• Starts up briefly, then red LED switches off and flashes.
• Picture width depends on brightness.
• Switches on for a short time and then returns to standby.
• Power problem. after lightning strike.
• No picture. via SCART. Audio OK .
• Drive transistor T102 exploded and R101 burned.
• C145 has burnt.
• No audio (intermittently). (TLD200 DANTAX repair tip)
• Dead, after smoke.
• Line output transistor (BU508AF) fails repeatedly.
• No sound via AV or HF.
• No start-up.
• Picture size varies.
• Appliance cannot be started up by user control (control panel).
• Bright blank raster. Flyback lines.
• No green. (TLD200 tip from DANTAX)
• No RC functions.
• Pincushion distortion.
• No function. PSU ticks quietly. (TLD200 DANTAX repair tip)
• Fails after several hours.
• No HV.
• Flickering picture.
• Line output transistor S/C.
• Picture height only approx. 2cm. (TLD200 tips)
• Tuner reception only in BG standard.
• Horizontal end stage is defective. Fails again after a short time.
• Snow in picture.
• Only 3" picture in middle of screen with white line through middle.
• Distorted noise from set.
• Picture is compressed on the right hand side. Cannot be adjusted.
• Horizontal output stage BU (BU508AF) is defective.
• Trapezoid correction varies intermittently.
• Dark picture.
• BU508DF fails after a while.
• Volume changes, picture disappears briefly. (TLD200 tips)
• No function, fuse fails immediately.
• Line output stage blown after some hours of operation. Image pulsates at bright image places. (TLD200 DANTAX repair tip)
• No or poor E/W correction.
• Whistling from PSU.
• Dead except faint ticking.
• Resistor R101 is burnt.
• Line output stage transistor fails immediately after replacement. (TLD200 tips)
• E/W fault. (service info for DANTAX -TLD200)
• No vertical deflection.
• Defective vertical deflection after high voltage flashover.
• No HV. intermittently.
• No picture (via AV).
• Picture shifted to the right.
• Red LED pulsates. Bumping nois from speaker, then goes dead. Red LED not lit.
• Hiss in audio. Blank screen.
• Line damping.
• No audio. No picture. No RC functions. No front panel function.