EURAS System
   EURAS worldwideeuras.com    
EURAS System

5837TNOVA 10884 / ELEMIS [TV (Standard)]

The EURAS repair tip database for professional technicians and service engineers supplies the following faults for 5837TNOVA / ELEMIS.

List of fault symptoms:
  • Dead with a slight squealing sound, which gets louder.
  • Dead.
  • Switches to protection mode.
  • Smearing in picture.
  • Shuts down. after start-up. No vertical deflection.
  • Tries to start 2 times then switches to standby.
  • PSU pulsates. LED flickers .
  • Switches to standby (after start-up).
  • Dark picture. Audio OK .
  • No start-up from standby.
  • Reduced horizontal size. Foldover in centre of picture.
  • Noise in picture.
  • Black band on picture with tearing effect. Intermittently picture flutters on bright scenes. Arcing noise.
  • No functions.
  • No raster.
  • Bright white raster with flyback lines after start up, then goes to standby.
  • Vertical collapse.
  • Switches to protection mode (after start-up).
  • Blank raster.
  • Excessive horizontal size. No E/W correction.
  • No picture. after a while.
  • Excessive horizontal size. after a few hours.
  • Low voltages.
  • Trips (after start-up).
  • No start-up.
  • Bright raster. Retrace lines.
  • Dead. Standby LED does not light.
  • No E/W correction.
  • RV38 value.
  • No picture , only lines, via AV socket.
  • Protective circuit starts up, if appliance is switched on again when warm. Red LED blinks.
  • PSU chirps every second after switch on, LED blinks. No other function.
  • No picture. intermittently. Audio OK .
  • Stuck in standby. when cold.
  • Blows fuse. at start-up. (5837TNOVA tips)
  • Blank raster. Retrace lines. Audio OK .
  • Picture shifted horizontally. Horizontal foldover. (5837TNOVA tips)
  • Focus cannot be set well. It takes a long time before picture appears.
  • Image white and with flyback lines and then horizontal pulsating. (ELEMIS - 5837TNOVA information)
  • Bright white picture.
  • Blows fuse.
  • Peeping sound.
  • No functions. after lightning strike.
  • Installation menu.
  • Dead. Standby LED flashes .
  • No line drive.
  • Interference in picture.
  • Dead. Power LED is red.
  • Stuck in standby. Green LED fades out when switched on.
  • Flashing picture. after a few minutes. (ELEMIS - 5837TNOVA information)
  • No E/W correction. Cannot be adjusted in the service menu.
  • Switches off by itself. after start-up.
  • No horizontal deflection.
  • E/W fault. intermittently.
  • No function. PSU ticks.
  • Line output transistor S/C.
  • Dead. LED is red .
  • Ragged picture.
  • Reduced vertical size.
  • No function, only standby LED is red.
  • No operation.
  • Switches off by itself.
  • Tripping.
  • Stuck in standby.
  • Starts up three times then switches off.
  • Protection mode activated. LED blinks .
  • No colour and ragged verticals.
  • Reduced vertical and horizontal size.
  • Line output transistor fails repeatedly.
  • Shuts down. after start-up.
  • Brightness and contrast vary about 10mins, then picture flashing then goes out. Remains green raster and intermittently retrace lines.
  • No function. Standby LED does not light up. Power supply squeaks once a second.
  • No picture. Bright raster. Flyback lines.
  • No switch on. Ticking from loudspeaker.
  • No horizontal or SDA/SCL pulses after 10 seconds.
  • Shuts down.
  • Doesn't read DVD's.
  • Switches to standby. after a while.
  • Blue display.
  • Switches to standby. intermittently.
  • No picture. after a few minutes. Audio OK .
  • Power supply hiccups.
  • Switches off by itself. intermittently.
  • Continuously blinking red LED.
  • Horizontal line. in the centre. (5837TNOVA tip from ELEMIS)
  • Mains switch does not lock. (service info for ELEMIS -5837TNOVA)
  • No start-up (intermittently).
  • Attempts to start up twice and switches off.
  • Reduced horizontal size. No E/W correction.
  • Enter service mode.
  • Disable child lock. (ELEMIS - 5837TNOVA information)
  • No colour.
  • White line in the bottom half of the picture.
  • Resistors RD06 and RD17 burnt.
  • No picture. via SCART.
  • All channels up to CH51 are tuned, otherwise no function.
  • Changing sound to UK standard (6MHz).
  • No picture. No audio.
  • Comes on for a short time. Burning smell.
  • Shuts down. intermittently. PSU pulsates.
  • Excessive brightness. Flyback lines. Audio OK .
  • Horizontal linearity fault.
  • Drops out.
  • Flyback lines.
  • Flickering picture. Audio OK .
  • First no colours/interference, then no function.
  • Cannot be switched on from standby. Switches by itself to standby or sound mutes.
  • Power supply hiccups, LED flashing.
  • Fuse FP01 has blown
  • Enable child lock.
  • Starts up twice then dead.
  • Picture is only red or green or blue with flyback lines. (5837TNOVA ELEMIS repair tip)
  • After 10mins. picture flashes and cuts out. (5837TNOVA ELEMIS repair tip)
  • Switches to protection mode. LED flashes repeatedly twice. (5837TNOVA tip from ELEMIS)
  • No start-up. Green LED flashes .
  • Flickering picture. intermittently.
  • Picture increases gradually. Linearity error and stripes in upper picture area.
  • White screen. Flyback lines.
  • Reduced horizontal size. E/W distortion.
  • No power up. PSU whistles every second.
  • No start-up after switched off from RC. Noise from PSU in standby.
  • No start-up. LED is red .
  • Trips. (ELEMIS - 5837TNOVA information)
  • Lines across screen then set displays a bright white raster and turned itself OFF. When switching ON again it just trips.
  • No synchronisation. OSD and TXT OK .
  • No audio. via SCART.
  • At switch on LEDs flash. Set dead when current is switched on. Stays in standby mode.
  • Frame has shifted downwards approx 1". (service info for ELEMIS -5837TNOVA)
  • Horizontal line.
  • Beep after start-up.
  • Bright picture.
  • Reduced vertical deflection.
  • Horizontal collapse.
  • Motorboating noise in audio.
  • Poor synchronisation.
  • Sawtooth pattern when cold. Best visible in 4:3 mode. OK after a few minutes.
  • Fails after start-up.
  • No picture. Audio OK .
  • Smoking.
  • E/W fault.
  • Torn picture. Vertical foldover. depending on picture content.
  • Line tearing.
  • Squealing about once a second.
  • FBT flashover.
  • Squealing from PSU.
  • Picture fails intermittently, line tearing in part and sound disturbs.
  • No tuning.
  • No channel storing. only on certain channels.
  • No function, red LED is on, sometimes only faint noise from PSU. (5837TNOVA tips)
  • Switches on. Raster appears and switches to standby after 2-3 secs.
  • Noise and whistle from the SOPS trafo.
  • Cycles on/off.

With help of this list a solution is found often when ELEMIS 5837TNOVA fails.


Additionally to repairtips or service information 5837TNOVA 10884 is linked to 73 components (IC's and/or transformers) in the Tectra database, through which you can identify electrical compatibilities (crossreferences) in appliances.


Chassis information is available (which chassis is built in into 5837TNOVA 10884).

EURAS system also knows 337 appliances having the same chassis as 5837TNOVA 10884 and can easily list them.

For 5837TNOVA 10884 there are 2 compatible appliances known and can be listed.


In the repair discussion pinboard for 5837TNOVA 10884 there are 155 replies to questions asked about 134 different repair problems.
With access to EURAS you can all read them or enter your own questions and get help for 5837TNOVA from EURAS technicians or other users.

Do you want to see this remedies/cures for repairtips?   Register here for the EURAS System
Please note: access to the EURAS System can be granted only to professional technicians/TV/Video/household electronics repair shops which are authorized for service by a manufacturer, or can prove to be professionally certified to do repairs on electronic appliances. You will be asked for a statement and information accordingly during registration.

If you do not qualify as stated above and you have an appliance that needs technical service, we do recommend you to contact the manufacturer (for example through his website) or go to a professional household/TV/Video electronics repair shop close to you.

Already registered? open 5837TNOVA ELEMIS in EURAS

All details on the EURAS System: English | Deutsch | Français | Italiano | Español | Magyarul | Português | Polski | Română | Greek |


Back to EURAS Homepage >> All manufacturers >> ELEMIS tech tips  












Last updated: 15. Oct 2008 23:38:39 MET, doccode ISO9002AS168EKA200805C EURASMOP

Responsible for the content: EURAS International GmbH, Eime, Germany.
All brand- or productnames are copyrighted by the respective manufacturer of the appliance and are only being used for identification purposes.