FXV5099 C8Q000 / FELIX [TV]

• No picture.
• At switch on, EHT crackles then appliance trips.
• Black horizontal lines in picture. No menu OSD. No TXT.
• Enter service mode.
• Vertical jitter.
• Screen is bright with flyback lines, switches off after a short time.
• Blurred picture, with green cast and flyback lines.
• No tuning. No picture, only snow.
• No picture. Audio OK .
• Picture is only half its size.
• T601 faulty.
• Flickers, goes out.
• Basic features.
• No AV2.
• No OSD sync. (FXV5099 tips)
• No line drive. Switches to standby. after a few seconds.
• No picture. via AV. Audio OK . (service info for FELIX -FXV5099)
• Picture shifted horizontally.
• Low HT.
• Stuck in standby. LED blinks .
• Blue picture. at start-up. No picture. No audio (after a while).
• Text and OSD run through from top to bottom. Black bar runs through, when OSD not available.
• No channels.
• Picture approx. 3cm vertically.
• Picture size varies with picture content.
• Vertical collapse. Horizontal collapse.
• Poor picture. Snow in picture.
• Intermittent red flashes with retrace lines on picture, a few times, then goes to standby.
• Tripping. LED blinks .
• Vertical size varies (intermittently).
• Spots in picture.
• Shuts down. after start-up. Standby LED flashes .
• No synchronisation.
• Tripping.
• Stuck in standby.
• No picture, only snow.
• Shuts down. intermittently.
• No picture. via SCART.
• No switch on. Standby LED becomes darker and switches back to standby.
• Dead.
• No start-up from standby.
• No or dark picture.
• FET keep blowing.
• Blue line on screen.
• Black horizontal lines on picture.
• Diagonal line in picture. No OSD.
• Shuts down.
• No OSD.
• Skips channels during tuning.
• Low brightness. Low contrast.
• Flickering picture. Hum bar (when cold).