FX2120 / FIRSTLINE [TV]

• PSU pumps after switch on. LED flickers green and picture and sound are missing. Blubber form the loudspeakers.
• No line drive. (FIRSTLINE - FX2120 information)
• Green LED flashing.
• Memory loss.
• No picture.
• No picture. Three colored streaks on upper half screen. Audio OK.
• Trips. Green LED flashes .
• No picture. OSD OK .
• Whistling from PSU.
• Vertical collapse.
• Picture disappears with a flash. Sound stays and picture is back. (FIRSTLINE - FX2120 information)
• No functions. Chirping. (service info for FIRSTLINE -FX2120)
• Retrace lines. Blank raster.
• No start-up.
• Green light flashing on picture.
• Only 300 V at rectifier.
• No picture. OSD and TXT OK .
• Hum bar. No RC functions.
• Switches to standby. after start-up.
• E/W fault.
• Line output transistor fails repeatedly.
• Black screen with 3 colour lines on the first third at the top of the screen.
• Reduced vertical deflection.
• Faulty OSD and/or Teletext.
• Pincushion distortion.
• Annoying noise from PSU. Functions OK.
• PSU pulsates. No functions. Standby LED flashes .
• LED stays green when switching to standby. (FX2120 tips)
• No picture. No audio. PSU pulsates. (FIRSTLINE - FX2120 information)
• No picture. Audio and OSD OK .
• Excessive horizontal size. Pincushion distortion. on sides.
• Display shows "locked" during programme search, though lock is cancelled.
• Switches to standby, LED is red for a short time and then pulsates green every second.
• Slow start-up. Pulsating picture. Switches off by itself.
• No tuning menu. "Locked" appears, when Install option is selected.
• No start-up from standby. Green LED comes on then blinks red.
• No blue. (FX2120 FIRSTLINE repair tip)
• No vertical deflection.
• Enter service mode. (FIRSTLINE - FX2120 information)
• Erratic start-up.
• Wavy picture.
• Annoying noise from PSU in standby. (FX2120 FIRSTLINE repair tip)
• Stuck in standby.
• Does not start, fast pulsating also without deflection plug.
• No start-up. Led briefly green then goes into standby again.
• No start-up from standby with RC. (FIRSTLINE - FX2120 information)
• Line output transformer is defective.
• Bright raster.
• No start-up. Standby LED flashes .
• PSU pulsates.
• Very bright picture content and blooming, even during AV.
• Dark screen. No contrast control. No brightness control.
• Dark screen. Audio OK .
• PSU chirps.
• Bright picture. Flyback lines.
• 8V input voltage missing from stabiliser.
• Pincushion distortion (intermittently).
• Picture and menu has slightly shifted horizontally. After approx 10 minutes sound becomes lower, crackles and then disappears completely. If appliance is restarted, sound is available again and error repeats itself.
• Dead.
• LED flashes.
• Vertical output stage fails repeatedly.
• Shuts down.
• No SECAM L standard.
• Reduced horizontal size. Stripes in picture. on the left.
• Excessive horizontal size.
• Reduced horizontal deflection.
• Ticking noise. in standby.