PM8670C2C60 / FORMENTI [TV]

• Blank raster. Flyback lines. Audio OK .
• No vertical deflection.
• Dead. LED lit. .
• D13 fails.
• Vertical collapse on half picture.
• Dead (intermittently).
• Reduced vertical size. Bright picture.
• No start-up from standby with RC. Switches off by itself. intermittently.
• No audio. No picture.
• No E/W correction.
• No brightness, contrast and colour adjustment via RC (they are at 0). No OSD.
• No IR transmission.
• Trapezium distortion and picture is too wide. Picture width changes radically as contrast and brightness change. Slight ballooning effect.
• Stuck in standby.
• Picture blanks in zoom mode.
• Ripple on picture. Picture oversized.
• Intermittent signal strength. Noise in picture.
• Picture disappears after start-up and lines appears. OK after a few minutes. Fault reappears after restart.
• Squealing noise.
• Dead.
• Tripping. No start-up.
• Switches to standby (intermittently).
• Shuts down (intermittently).
• Trips.
• Reduced horizontal size after EHT flashover.
• Enter service mode.
• Vertical collapse.
• Line output transistor fails at start-up. (service info for FORMENTI -PM8670C2C60)
• No power. (service info for FORMENTI -PM8670C2C60)
• Burning smell. Other functions OK .
• Blurry picture. (FORMENTI - PM8670C2C60 information)
• Poor E/W.
• No line drive (intermittently).
• Distorted picture.
• E/W fault.
• Switches to standby (after a few minutes).
• Low sound and distorted by RF reception.
• No channel storing.
• When using Sony Playstation via SCART, picture flashes between TV and AV.
• Impossible to enter SERVICE mode.
• Trips. after a few seconds.
• No picture. Audio OK .
• No or poor picture. via SCART.
• No picture.