EURAS System
   EURAS worldwideeuras.com    
EURAS System

KV27TS32 / JSN [TV]

The EURAS repair tip database for professional technicians and service engineers supplies the following faults for KV27TS32 / JSN.

List of fault symptoms:
  • Two faint vertical bars approx 2 ins. from either side of tube.
  • Vibration from L509.
  • Half moon with rainbow strips, or rainbow strips at a lower overall brightness level on picture.
  • Horizontal output transistor fails repeatedly. (service info for JSN -KV27TS32)
  • Picture turns bright blue. Retrace lines. Immediately shutsdown.
  • Screen jitters vertically after 10 mins.
  • No picture (intermittently).
  • No picture. Audio and HV OK .
  • Picture fades in and out.
  • Black screen. intermittently. (JSN - KV27TS32 information)
  • No raster.
  • Pincushion distortion.
  • Clicking noise. (KV27TS32 JSN repair tip)
  • Remote only works at close range. Affected by light.
  • Capacitors found defective:
  • Q601, Q602, & Q591 repeat failure in a few days
  • Intermittent picture or sound.
  • No closed caption. (service info for JSN -KV27TS32)
  • Very low contrast. Picture almost white.
  • Lines in picture and squealing at high volume.
  • Vertical jitters.
  • Horizontal width small. Vertical size too large.
  • Operation functions automatically.
  • No luminance.
  • Close caption not working.
  • Shuts off when it's turned on. (KV27TS32 JSN repair tip)
  • Power up inop. only time/standby lite comes on
  • If appliance looses power then losses vertical and horizontal size too.
  • No HV (intermittently).
  • Dead. Standby voltage low.
  • Immediately blows Q601 and Q602.
  • No brightness (intermittently).
  • Picture jitters. after warm-up.
  • Shuts down. after a few seconds.
  • Vertical roll. Audio OK .
  • Black line on screen with cable box.
  • Dead. after power failure. (KV27TS32 tip from JSN)
  • No picture. No sound. HV OK. (KV27TS32 tips)
  • High pitched squealing.
  • Cabinet buzzes.
  • Dead. Switching transistors S/C.
  • Video blanking.
  • Loss of picture and sound after 20 mins.
  • Four green or red rows of colored dots on the upper half of the screen.
  • Black bar at top of screen. Pincushion problem.
  • Loosing convergence after it has been playing for a while.
  • Poor picture.
  • Vibrating sound from back of TV. (KV27TS32 JSN repair tip)
  • Pulses but won't turn on. (KV27TS32 tip from JSN)
  • Dashed lines in centre portion of PIP picture.
  • Intermittent high pitched noise.
  • Horizontal lines.
  • Intermittent picture at top of screen.
  • Menu items appear in Spanish.
  • Buzzing noise coming from back of set, when the TV is ON or OFF.
  • Repeated failure of Q501 (horizontal output transistor).
  • Buzzing.
  • Power shuts off, when FF on VCR.
  • Dead, SMPS shorted and/or, SMPS repeat failure (JSN - KV27TS32 information)
  • H.o.t. repeat failure
  • No sound or raster.
  • When volume is turned up the front mask sound like it is vibrating against the CRT.
  • Picture torn left to right.
  • No HV. Audio OK. (KV27TS32 tips)
  • No picture. PIP OK .
  • Distorted jumpy picture.
  • Insufficient vertical. Picture pulled up approx 1 inch from bottom.
  • Q601, Q602 and R607 fails repeatedly.
  • Horizontal bars going across screen
  • Loosing vertical linearity after it has been playing for a while.
  • No picture and OSD.
  • No picture after power on. No OSD. Timer LED is blinking.
  • No picture. Standby LED flashes .
  • Dead. Possible storm damage.
  • Vertical collapse.
  • Snow in picture (intermittently).
  • Remote only works at close range and is affected by light.
  • No vertical or horizantal child picture sync.
  • Dead. Relay clicks .
  • Severe vertical jitter at turn on.
  • Intermittently noise, bars and other interference in picture.
  • Picture tilted at top of screen.
  • Vertical jitter, light vertical lines on each sides.
  • High pitch sound from set.
  • Q601, Q602, & R607 repeat failure in a few days (KV27TS32 JSN repair tip)
  • Half moon or rainbow stripes in picture.
  • After channel change it would take some time for the pix to stabilize or had no pix sometimes.
  • No scan line across screen approx 1/3 way down from top. (KV27TS32 tips)
  • Slow vertical roll.
  • Pincushion could not be adjusted.
  • No RC functions, only menu button operate.
  • RC only works at close range and affected by light. (service info for JSN -KV27TS32)
  • Dead, when power button is pushed sets relay clicks ON then OFF. It repeats this on its own 3 - 4 times then ceases all activity.
  • Relay pulses on and off continuously. (JSN - KV27TS32 information)
  • White vertical line on each side of picture.
  • Vertical jitter at turn on. OK after few mins.
  • Main fuse opens immediately.
  • Vibration noise in cabinet.
  • High pitched noise coming in and out.
  • Intermittently picture snowy.
  • Dead. R527 overheating. looks like maybe bad yoke
  • No picture. Sound OK. HV OK. (KV27TS32 tip from JSN)
  • 3" wide horizontal bar was displayed across centre of screen. Picture in bar out of focus and convergence. (JSN - KV27TS32 information)
  • Poor pincushion.
  • No picture. Audio OK .
  • Vertical jitter. at start-up.
  • Stuck in standby. (KV27TS32 tip from JSN)
  • Squeal from horizontal linearity coil.
  • No picture. Retrace lines and dim picture when screen control adjusted.
  • No picture. intermittently. Audio OK .
  • Shut down.
  • Retrace lines in picture. Audio distorted with a popping sound.
  • No start up. Standby light comes on when power button pressed.
  • Shuts down (after start-up).
  • No picture. Screen lights up with antenna connected. Green spot in upper right hand corner. Gray diagonal lines moving up screen. (KV27TS32 JSN repair tip)
  • No picture.
  • Squealing noise.
  • No picture. Audio and HV OK. G2 won't adjust. (service info for JSN -KV27TS32)
  • High pitched squealing. Heat related.
  • RC functions from short distances only.
  • Picture flickers for several seconds when cold.
  • Distorted, noisy picture.
  • No picture. Audio and display OK.
  • Top half of pix collapsed.
  • The right 3/4 of the screen is dark with retrace lines.
  • Picture rolled upward.
  • Dead. No standby.
  • No operation.
  • No pincushion adjustment. No correction.
  • Dark raster.
  • Intermittent PIP function.
  • Squealing from HLC coil.
  • No audio. No picture.
  • No start-up.
  • No picture. Intermittent rattling. Sound OK.
  • Lost power while operating.
  • Video menu settings have no memory.
  • Relay constantly clicks when power applied.
  • Intermittently shutdown and pulses.
  • Service settings cannot be stored.
  • Clicks on and off 3 times then shutsdown.
  • Q601 and Q602 repeatedly fail.
  • No tuning. Insufficient width.
  • Top and bottom of picture strobs light and dark on cable only.
  • Dark raster with flaring across picture.
  • No start-up. Relay clicks .
  • Flickering picture.
  • TV cabinet buzzes with sound.
  • Does not store service settings.
  • Bright picture. Retrace lines.
  • No picture. Audio and OSD OK .
  • Squealing from PSU.
  • RC only works at close range.
  • Noise bars in the picture and audio hum from the speakers, when cable is hooked up to the set.
  • Unit would display various degrees of piecrusting after it was on for a while. Intermittently it would lose horizontal hold.
  • Dead.
  • No autoprogramme. When channels changed, a loud noise is heard. No AFT.
  • Relay chatters when plugged in.
  • Poor focus. (service info for JSN -KV27TS32)
  • Vertical down approximately 2 inches from top.
  • No picture, after changing video input signal.
  • No picture. No HV.
  • High pitched ringing sound.
  • PIP vertical roll.

With this service information, you may repair JSN KV27TS32 faster/better when it fails.

When JSN KV27TS32 fails , these symptoms are known and EURAS knows the remedy/solution.

Tips are coming from EURAS customers, workshops and payed technicians from all over the world. JSN KV27TS32 fails can be better solved.

If JSN KV27TS32 fails, this information will help you. Here you can only see the symptom list, to access remedies, you must register.

With help of this list a solution is found often when JSN KV27TS32 fails.


Additionally to repairtips or service information KV27TS32 is linked to 9 components (IC's and/or transformers) in the Tectra database, through which you can identify electrical compatibilities (crossreferences) in appliances.


Chassis information is available (which chassis is built in into KV27TS32 ).

EURAS system also knows 58 appliances having the same chassis as KV27TS32 and can easily list them.

In the repair discussion pinboard for KV27TS32 there are 12 replies to questions asked about 9 different repair problems.
With access to EURAS you can all read them or enter your own questions and get help for KV27TS32 from EURAS technicians or other users.

Do want to see this remedies/cures for repairtips?   Register here for the EURAS System

Already registered? open KV27TS32 JSN in EURAS

All details on the EURAS System: English | Deutsch | Français | Italiano | Español | Magyarul | Português | Polski | Română | Greek |


Back to EURAS Homepage >> All manufacturers >> JSN tech tips  


(C) EURAS International Ltd.










Last updated: 21. Aug 2008 12:05:36 MET, doccode ISO9002AS168EKA200805C [cachelite] EURASMOP

Responsible for the content: EURAS International GmbH, Eime, Germany. All rights reserved, EURAS database V2.0 (C) 2002-2008. All brand- or productnames are copyrighted by the respective manufacturer of the appliance and are only being used for identification purposes.