TVC16997 / NEUFUNK [TV 16:9]

• Vertical fault.
• Pincushion distortion.
• Procedure to come in the instalation menu.
• No picture. Audio OK .
• No functions.
• Brief HV pulse, then only standby.
• LED green for approx 2 secs, then it switches off.
• How to adjust option byte.
• Does not start. LED is red, if appliance is switched on via RC, LED indication disappears and appliance makes a noise.
• Dead. Standby LED becomes green, then goes off. (TVC16997 NEUFUNK repair tip)
• Dead. Starts briefly from standby. Green LED is on and off again.
• No E/W correction. (NEUFUNK - TVC16997 information)
• Red standby LED turns green at switch on with RC and then goes off. After approx. 15 mins can be switched on and then functions OK until switch off. (TVC16997 tip from NEUFUNK)
• Switches to standby. Knock sensitive.
• No start-up.
• Stuck in standby. (TVC16997 tip from NEUFUNK)
• Horizontal transistor (S2000N) is S/C.
• Enter service mode. (NEUFUNK - TVC16997 information)
• Appliance is in standby. PSU then switches off completely
• E/W fault.
• Dead. (service info for NEUFUNK -TVC16997)
• No image. No sound. After turning on green ONE LED appears and then it turns immediately off.
• S2000N in the line output stage is S/C.
• Switching PSU blown immediately at start-up.
• Standby ok, Green LED switches on briefly at switch on, PSU then switches off completely. (TVC16997 tips)
• Stops immediately in user control position after start .
• Trips.
• Disable child lock.
• PSU runs in standby, switches off when switched on.
• PSU pulsates, then only standby.
• No audio. No picture. No functions. Green LED flashes .
• Vertical collapse.
• Comes on for a short time.
• No vertical deflection. (TVC16997 tips)
• Squealing from PSU.
• Does not start. Green LED lights up briefly, then goes out.
• Shuts down.
• No function. If it is switched on with RC, red LED flashes. After switch on with RC, green LED flashes briefly and goes out then no function.
• No TXT.
• Switches off by itself. after a while.
• Output stage transistor becomes repeatedly defective. (TVC16997 NEUFUNK repair tip)
• Excessive horizontal size.
• Red LED flashes, then no more functions when switched on via power switch.
• "NO SIGNAL" displayed on the screen.
• No picture. Flyback lines.
• RG4, ZG1 and RG5 fail. (TVC16997 NEUFUNK repair tip)
• Dead. Standby LED flashes .
• Flyback lines. on upper half screen.
• On start-up LED flashes green, then LED goes red but appliance can be started by RC and functions OK.