 |
1484 / NIKKAI [TV]
The EURAS repair tip database for professional technicians and service engineers
supplies the following faults for 1484 / NIKKAI.
List of fault symptoms:
- White screen. Flyback lines. (1484 NIKKAI repair tip)
- Two bright lines approx 0,40 inches at lower and upper part of screen.
- LED lights, no function.
- Flyback transformer slightly chirps.
- Noise or click from PSU. No start-up.
- Hum bar.
- No picture. OSD OK .
- Picture jitters at the top and bottom and lines after 30 mins.
- No channels. No picture, only snow.
- No function, goes to standby, red LED is on. Does not start up with RC.
- Trips when switched on.
- IC304 (TDA7263M) fails repeatedly.
- Coloured lines. at top.
- Stuck in standby.
- No signal. No picture, only snow.
- OSD shifts or wrong colours when changing channels with RC.
- Black streak in lower part and half a picture in upper part of the screen.
- No colour; lines; jumping - worse on bright scenes.
- Flyback lines. intermittently.
- No reception.
- Only starts on remote.
- Horizontal lines at top 3-4 inches.
- No line oscillation.
- No start-up. Relay clicks .
- Does not switch to standby.
- Comes on for a short time. Switches to standby. (1484 tip from NIKKAI)
- Dim picture.
- No RC functions.
- Geometry adjustment.
- Enter service mode.
- Snowy picture, no channel LEDS and no volume.
- Black screen.
- Weak contrast.
- Poor picture. Low contrast.
- HT does not function.
- Dead.
- Vertical fault. at top.
- Intermittently no colour, field foldover and loss of horizontal shift.
- No picture.
- No horizontal synchronisation.
- Linearity coil humming.
- No functions.
- Distorted audio (only on certain channels).
- PSU defective.
- Intermittent low gain.
- Wow in audio.
- No picture, only high tension.
- Dead. after lightning strike.
- Cracking noise 4-5 times when switched on.
- No EE or PB picture.
- Intermittent colour. after warm-up.
- Brightness varies.
- No E/W correction. (service info for NIKKAI -1484)
- Retrace lines. Excessive brightness.
- Crackling noise.
- No colour.
- Blank raster.
- HV falshover at line transformer.
- White balance adjustment.
- Distorted audio from central speaker.
- Dark and bright streaking to the right in the picture, also during AV mode and menu displays.
- Skips channels during tuning.
- Horizontal line.
- Does not shut down.
- Flyback transformer is defective.
- No TXT.
- No functions with RC, only the internet functions.
- Flyback lines.
- Noise in audio (intermittently).
- Yellow picture.
- Blank raster. No audio.
- Slow start-up. in standby. (NIKKAI - 1484 information)
- Excessive vertical size.
- Blank raster. Audio and OSD OK .
- Arcing effect on high brightness.
- AGC adjustment. (with circuit diagram extract) (1484 NIKKAI repair tip)
- TV stuck on standard BG or DK. Cannot switch to L.
- Screen adjustments.
- No picture. Audio OK .
- Picture remain visible in standby, but without colours, contrast, or brightness.
- R528 (10K) and C524 (220nF) keeps failing. (1484 tip from NIKKAI)
- Horizontal output transistor fails repeatedly.
- Supply voltage adjustment. (picture attached)
- Picture size increases and decreases.
- No colour. Snow in picture.
- RC code HQ.
- Defective menu, no OSD.
- No front control operation or LED. Snowy raster. No tuning.
- Short non-linear frame (may improve as set warms up).
- Vertical collapse. (1484 NIKKAI repair tip)
- No start-up (intermittently).
- Picture darkens then goes back to normal.
- No function. Standby is not lit. (1484 tip from NIKKAI)
- Line output transistor (2SD1541) has blown.
- Dark screen. Audio OK .
- No picture. Audio OK . No HV.
- Switches off by itself. at high volume.
- No colour. Reduced vertical size. (NIKKAI - 1484 information)
- No start-up.
- Horizontal dark lines in centre of screen.
- Distorted audio. at high volume.
With this service information, you may repair NIKKAI 1484 faster/better when it fails.
When NIKKAI 1484 fails , these symptoms are known and EURAS knows the remedy/solution.
Tips are coming from EURAS customers, workshops and payed technicians from all over the world. NIKKAI 1484 fails can be better solved. If NIKKAI 1484 fails, this information will help you. Here you can only see the symptom list, to access remedies, you must register. With help of this list a solution is found often when NIKKAI 1484 fails.
|
Additionally to repairtips or service information 1484 is linked to 21 components (IC's and/or transformers) in the Tectra
database, through which you can identify electrical compatibilities (crossreferences) in
appliances.
|
Chassis information is available (which chassis is built in into 1484 ).
EURAS system also knows 470 appliances having the same chassis as 1484 and can easily list them.
In the repair discussion pinboard for 1484 there are 48 replies to questions asked about 25 different repair problems. With access to EURAS you can all read them or enter your own questions and get help for 1484 from EURAS technicians or other users.
Do you want to see this remedies/cures for repairtips? Register here for the EURAS System Please note: access to the EURAS System can be granted only to professional
Video/household electronics repair shops/technicians/TV which are
authorized for service by a manufacturer, or can prove to be professionally
certified to do repairs on electronic appliances. You will be asked for a
statement and information accordingly during registration.
If you do not qualify as stated above and you have an appliance that needs
technical service, we do recommend you to contact the manufacturer (for
example through his website) or go to a professional Video/TV/household
electronics repair shop close to you.
Already registered? open 1484 NIKKAI in EURAS
All details on the EURAS System: English |
Deutsch |
Français |
Italiano |
Español |
Magyarul |
Português |
Polski |
Română |
Greek |
Back to EURAS Homepage >>
All manufacturers >>
NIKKAI
tech tips
Last updated: 06. Oct 2008 15:09:20 MET, doccode ISO9002AS168EKA200805C EURASMOP
Responsible for the content: EURAS International GmbH, Eime, Germany.
All brand- or productnames are copyrighted by the respective manufacturer of the appliance and are only being used for identification purposes.
|
|