BABY10 / NIKKAI [TV < 27cm picture (<23)]

• No or intermittent audio. No or intermittent picture. (BABY10 tip from NIKKAI)
• No brightness control.
• Hum bar like symbols.
• Dead.
• Screeching noise at switch on.
• Regulator connections veiwed from benneath reg.
• No functions.
• Dead. Constantly blowing F401 (600mA).
• Pincushion distortion.
• D410 repeatedly fails. (BABY10 tip from NIKKAI)
• Poor field.
• Shuts down. after warm-up.
• Hum.
• No start-up with 12V. Relay clicking.
• No picture. Audio and OSD OK .
• Tuning drifts. when changing channels.
• No picture, sound ok. On screen graphics appear when channel is changed or volume increased.
• No colour. after warm-up. (BABY10 NIKKAI repair tip)
• Faint hum bars appear after about half an hour.
• Reduced vertical and horizontal size.
• Flashing on ITV and BBC1.
• Vertical bounce. depending on picture content. Switches off by itself. intermittently.
• Fuse is O/C and diode BY299 is S/C.
• Shuts down. Standby LED does not light.
• No luminance (intermittently).
• No audio.
• As set warms up, the picture gets darker until there is no picture.
• No raster.
• Dead or intermittently dead.
• Audio stuck at maximum level. Muting OK.
• Dead. Relay clicks .
• Wavy picture. when cold.
• Stuck in standby. LED is red .
• Line output transistor overheats. No picture. Audio OK.
• Station lost when channels changed once set is warm. (NIKKAI - BABY10 information)
• Vertical collapse.
• No tuning.
• Intermittently dead.
• Shuts down (intermittently).
• No picture (intermittently).
• No colour.
• Only an inch of field scan with a bright line across the screen.
• Picture bounces and sometimes becomes oversized, cuts out.
• Hum bar.
• Flickering picture. only on certain channels. (service info for NIKKAI -BABY10)
• No picture. Burning smell. Audio OK .