 |
C14M08 / NIKKAI [TV]
The EURAS repair tip database for professional technicians and service engineers
supplies the following faults for C14M08 / NIKKAI.
List of fault symptoms:
- Flyback lines. intermittently. (service info for NIKKAI -C14M08)
- Coloured lines. at top.
- White balance adjustment.
- Picture size increases and decreases.
- Distorted audio (only on certain channels).
- Dark screen. Audio OK .
- Wow in audio.
- HV falshover at line transformer.
- LED lights, no function.
- Dead.
- Weak contrast.
- Line output transistor (2SD1541) has blown.
- No RC functions.
- Dark and bright streaking to the right in the picture, also during AV mode and menu displays.
- IC304 (TDA7263M) fails repeatedly.
- Does not shut down.
- Noise in audio (intermittently).
- Short non-linear frame (may improve as set warms up).
- RC code HQ.
- Horizontal output transistor fails repeatedly.
- Does not switch to standby.
- No horizontal synchronisation.
- No colour. Snow in picture.
- Picture remain visible in standby, but without colours, contrast, or brightness.
- No colour; lines; jumping - worse on bright scenes.
- No picture.
- Vertical fault. at top.
- Flyback lines.
- Horizontal lines at top 3-4 inches.
- No function, goes to standby, red LED is on. Does not start up with RC. (NIKKAI - C14M08 information)
- Picture darkens then goes back to normal.
- Comes on for a short time. Switches to standby.
- No picture. Audio OK .
- No colour. Reduced vertical size.
- TV stuck on standard BG or DK. Cannot switch to L.
- No picture, only high tension.
- Distorted audio. at high volume.
- Snowy picture, no channel LEDS and no volume.
- Trips when switched on.
- AGC adjustment. (picture attached)
- No E/W correction.
- No front control operation or LED. Snowy raster. No tuning.
- Skips channels during tuning.
- No function. Standby is not lit.
- No start-up. Relay clicks .
- Retrace lines. Excessive brightness.
- Blank raster. No audio.
- Only starts on remote.
- Crackling noise.
- Slow start-up. in standby.
- Dead. after lightning strike.
- Blank raster.
- Brightness varies.
- No EE or PB picture.
- PSU defective.
- Blank raster. Audio and OSD OK .
- Stuck in standby.
- Vertical collapse.
- No signal. No picture, only snow.
- Two bright lines approx 0,40 inches at lower and upper part of screen.
- Hum bar.
- Intermittently no colour, field foldover and loss of horizontal shift.
- Distorted audio from central speaker.
- Poor picture. Low contrast.
- Screen adjustments.
- No start-up.
- Supply voltage adjustment. (+ extract of circuit diagram)
- Geometry adjustment.
- Enter service mode.
- Intermittent low gain.
- No TXT.
- No start-up (intermittently).
- Noise or click from PSU. No start-up. (C14M08 tips)
- White screen. Flyback lines.
- Yellow picture.
- Flyback transformer slightly chirps.
- Black screen.
- No channels. No picture, only snow.
- R528 (10K) and C524 (220nF) keeps failing.
- No colour.
- Switches off by itself. at high volume.
- No functions with RC, only the internet functions. (NIKKAI - C14M08 information)
- Arcing effect on high brightness.
- Horizontal dark lines in centre of screen. (C14M08 tip from NIKKAI)
- HT does not function.
- No picture. Audio OK . No HV.
- No reception.
- Linearity coil humming. (service info for NIKKAI -C14M08)
- OSD shifts or wrong colours when changing channels with RC.
- No functions.
- Dim picture.
- Picture jitters at the top and bottom and lines after 30 mins.
- No picture. OSD OK .
- Intermittent colour. after warm-up.
- Horizontal line.
- Defective menu, no OSD.
- No line oscillation.
- Excessive vertical size.
- Cracking noise 4-5 times when switched on.
- Black streak in lower part and half a picture in upper part of the screen.
- Flyback transformer is defective.
When NIKKAI C14M08 fails , these symptoms are known and EURAS knows the remedy/solution.
Tips are coming from EURAS customers, workshops and payed technicians from all over the world. NIKKAI C14M08 fails can be better solved. If NIKKAI C14M08 fails, this information will help you. Here you can only see the symptom list, to access remedies, you must register. With help of this list a solution is found often when NIKKAI C14M08 fails.
|
Additionally to repairtips or service information C14M08 is linked to 21 components (IC's and/or transformers) in the Tectra
database, through which you can identify electrical compatibilities (crossreferences) in
appliances.
|
Chassis information is available (which chassis is built in into C14M08 ).
EURAS system also knows 470 appliances having the same chassis as C14M08 and can easily list them.
In the repair discussion pinboard for C14M08 there are 48 replies to questions asked about 25 different repair problems. With access to EURAS you can all read them or enter your own questions and get help for C14M08 from EURAS technicians or other users.
Do want to see this remedies/cures for repairtips? Register here for the EURAS System
Already registered? open C14M08 NIKKAI in EURAS
All details on the EURAS System: English |
Deutsch |
Français |
Italiano |
Español |
Magyarul |
Português |
Polski |
Română |
Greek |
Back to EURAS Homepage >>
All manufacturers >>
NIKKAI
tech tips
(C) EURAS International Ltd.
Last updated: 30. Aug 2008 14:46:01 MET, doccode ISO9002AS168EKA200805C [cachelite] EURASMOP
Responsible for the content: EURAS International GmbH, Eime, Germany.
All rights reserved, EURAS database V2.0 (C) 2002-2008.
All brand- or productnames are copyrighted by the respective manufacturer of the appliance and are only being used for identification purposes.
|
|