 |
CT141T / NIKKAI [TV]
The EURAS repair tip database for professional technicians and service engineers
supplies the following faults for CT141T / NIKKAI.
List of fault symptoms:
- Intermittent colour. after warm-up.
- No start-up. Relay clicks .
- Flyback lines. intermittently.
- No RC functions.
- No reception.
- Flyback transformer slightly chirps.
- Weak contrast. (service info for NIKKAI -CT141T)
- Excessive vertical size.
- Arcing effect on high brightness.
- Vertical fault. at top.
- Crackling noise.
- Skips channels during tuning. (CT141T tip from NIKKAI)
- Horizontal dark lines in centre of screen. (service info for NIKKAI -CT141T)
- Does not switch to standby. (NIKKAI - CT141T information)
- Dark and bright streaking to the right in the picture, also during AV mode and menu displays.
- White screen. Flyback lines.
- Stuck in standby.
- No front control operation or LED. Snowy raster. No tuning. (service info for NIKKAI -CT141T)
- No channels. No picture, only snow.
- Picture jitters at the top and bottom and lines after 30 mins. (CT141T tips)
- Horizontal output transistor fails repeatedly.
- Flyback transformer is defective.
- Yellow picture.
- No colour; lines; jumping - worse on bright scenes. (CT141T tips)
- No picture. Audio OK . No HV.
- Screen adjustments.
- No signal. No picture, only snow.
- No start-up (intermittently).
- Vertical collapse.
- R528 (10K) and C524 (220nF) keeps failing.
- Two bright lines approx 0,40 inches at lower and upper part of screen. (CT141T NIKKAI repair tip)
- Comes on for a short time. Switches to standby.
- Dim picture.
- Switches off by itself. at high volume.
- Enter service mode.
- Poor picture. Low contrast.
- Line output transistor (2SD1541) has blown.
- Distorted audio. at high volume.
- Slow start-up. in standby.
- Dead.
- Coloured lines. at top.
- No start-up.
- No picture. Audio OK .
- Picture darkens then goes back to normal.
- No picture. OSD OK . (service info for NIKKAI -CT141T)
- Trips when switched on.
- Only starts on remote.
- Intermittent low gain.
- Short non-linear frame (may improve as set warms up).
- Retrace lines. Excessive brightness.
- No E/W correction.
- No function. Standby is not lit.
- Horizontal lines at top 3-4 inches.
- No colour. Snow in picture.
- Flyback lines.
- Geometry adjustment.
- Blank raster.
- Snowy picture, no channel LEDS and no volume.
- Supply voltage adjustment. (extract of circuit diagram attached)
- Picture remain visible in standby, but without colours, contrast, or brightness.
- No EE or PB picture. (NIKKAI - CT141T information)
- Defective menu, no OSD.
- Wow in audio.
- OSD shifts or wrong colours when changing channels with RC. (service info for NIKKAI -CT141T)
- Intermittently no colour, field foldover and loss of horizontal shift. (service info for NIKKAI -CT141T)
- Hum bar.
- Black streak in lower part and half a picture in upper part of the screen.
- No functions with RC, only the internet functions.
- AGC adjustment. (+ extract of circuit diagram)
- Blank raster. Audio and OSD OK .
- HV falshover at line transformer.
- No line oscillation.
- Dark screen. Audio OK .
- IC304 (TDA7263M) fails repeatedly. (NIKKAI - CT141T information)
- Does not shut down.
- Horizontal line.
- No horizontal synchronisation.
- Distorted audio from central speaker.
- No picture.
- No colour. Reduced vertical size.
- No picture, only high tension. (service info for NIKKAI -CT141T)
- RC code HQ.
- No functions.
- Black screen.
- Cracking noise 4-5 times when switched on.
- TV stuck on standard BG or DK. Cannot switch to L. (NIKKAI - CT141T information)
- HT does not function.
- Dead. after lightning strike.
- No colour.
- No TXT.
- Noise in audio (intermittently).
- No function, goes to standby, red LED is on. Does not start up with RC.
- PSU defective.
- Brightness varies.
- Blank raster. No audio. (CT141T tips)
- Distorted audio (only on certain channels).
- White balance adjustment.
- Picture size increases and decreases.
- Linearity coil humming.
- LED lights, no function.
- Noise or click from PSU. No start-up.
When NIKKAI CT141T fails , these symptoms are known and EURAS knows the remedy/solution.
Tips are coming from EURAS customers, workshops and payed technicians from all over the world. NIKKAI CT141T fails can be better solved. If NIKKAI CT141T fails, this information will help you. Here you can only see the symptom list, to access remedies, you must register. With help of this list a solution is found often when NIKKAI CT141T fails.
|
Additionally to repairtips or service information CT141T is linked to 21 components (IC's and/or transformers) in the Tectra
database, through which you can identify electrical compatibilities (crossreferences) in
appliances.
|
Chassis information is available (which chassis is built in into CT141T ).
EURAS system also knows 470 appliances having the same chassis as CT141T and can easily list them.
In the repair discussion pinboard for CT141T there are 48 replies to questions asked about 25 different repair problems. With access to EURAS you can all read them or enter your own questions and get help for CT141T from EURAS technicians or other users.
Do want to see this remedies/cures for repairtips? Register here for the EURAS System
Already registered? open CT141T NIKKAI in EURAS
All details on the EURAS System: English |
Deutsch |
Français |
Italiano |
Español |
Magyarul |
Português |
Polski |
Română |
Greek |
Back to EURAS Homepage >>
All manufacturers >>
NIKKAI
tech tips
(C) EURAS International Ltd.
Last updated: 29. Aug 2008 23:33:41 MET, doccode ISO9002AS168EKA200805C [cachelite] EURASMOP
Responsible for the content: EURAS International GmbH, Eime, Germany.
All rights reserved, EURAS database V2.0 (C) 2002-2008.
All brand- or productnames are copyrighted by the respective manufacturer of the appliance and are only being used for identification purposes.
|
|