55IMCFUTURA 989524E / NORDMENDE [TV (Standard)]

• Resistor RG08 and E/W-IC burns. (extract of circuit diagram attached) (55IMCFUTURA NORDMENDE repair tip)
• Choose OSD language.
• Defective raster. Line in top of picture. (with circuit diagram extract)
• Dark screen with a short bright flash. (picture attached)
• No synchronisation. in TXT. (part of circuit diagram displayed)
• No program display or TXT. No OSD.
• Teletext clock stops. Each 5cm high part of the picture is missing. (with circuit diagram extract)
• Menu display is in a wrong language.
• 4-5 coloured flyback lines in upper half of picture. (picture attached) (service info for NORDMENDE -55IMCFUTURA)
• Upper picture part is dark. Rest of the picture is white with flyback lines. (extract of circuit diagram attached)
• Vertical lines jitter. Line tearing is greater in the top third.
• No picture, only sinusoidal lines in the middle of the screen. (with circuit diagram extract)
• No blue. (with circuit diagram extract)
• After switch on power supply pulsates three times. (with circuit diagram extract)
• Occasionally static discharge.
• No function, no stand-by display. (+ extract of circuit diagram)
• Horizontal line tearing in picture when cold.
• No picture, no sound. No LED standby display. (extract of circuit diagram attached) (55IMCFUTURA tip from NORDMENDE)
• PSU doesn't start up. Standby LED flickers. (extract of circuit diagram attached)
• Linearity is temperature sensitive. (with circuit diagram extract)
• After replacement horizontal end stage goes defective again. (with circuit diagram extract)
• Only a horizontal line at top of picture. (picture attached)
• In TOP text memorized page numbers are occasionally erased or changed randomly.
• 10cm wide stripes on top of picture. (extract of circuit diagram attached)
• PSU does not start, does not pulsate. Standby LED lights up. (with circuit diagram extract)
• No picture. (part of circuit diagram displayed)
• Loss of raster. Horizontal warped line at top of picture. (picture attached)
• Shuts down. after start-up. (part of circuit diagram displayed)
• No horizontal output stage drive. (part of circuit diagram displayed)
• Vertical lines run over the top part of the screen. (part of circuit diagram displayed)
• Switches off by itself (intermittently). (+ extract of circuit diagram)
• Switches to standby. Flyback lines.
• No vertical deflection. (+ extract of circuit diagram) (NORDMENDE - 55IMCFUTURA information)
• East/West equalisation is not adjustable. (extract of circuit diagram attached)
• Noise. No picture content. When another program position is chosen and switched back again, the contents of the previous preprogrammed TV channel is visible. (extract of circuit diagram attached)
• North/South correction cannot be adjusted correctly. (part of circuit diagram displayed)
• Poor N/S correction. (with circuit diagram extract)
• No sync via RF. Horizontal lines running vertically. OK via SCART. (+ extract of circuit diagram)
• Retrace lines.
• TXT shows faulty phase. (part of circuit diagram displayed)
• East/West correction can only be poorly adjusted. (part of circuit diagram displayed)
• Intermittently two severe indentations on the left and right, knocksensitive.
• When turning the mains on/off the store is lost or the programmes change over. (with circuit diagram extract)
• No line oscillation. (with circuit diagram extract)
• Memory loss. (part of circuit diagram displayed)
• Mains fuse blows often in few weeks.
• Sound fails or disappears completely.
• Noise in picture.
• Jagged picture (line tearing). E-W error. (+ extract of circuit diagram)
• Picture has shifted upwards. Sound OK. (picture attached)
• In Pip function "automatic channel run through". Skips channel position 4.
• Intermittently control unit processor blocks when SAT receiver is connected via scart socket. Can be restarted only from service mode. (+ extract of circuit diagram) (55IMCFUTURA tip from NORDMENDE)
• At switch on PSU goes defective. (with circuit diagram extract) (55IMCFUTURA NORDMENDE repair tip)
• Mains fuse has blown.
• Only a horizontal line at bottom of picture. (+ extract of circuit diagram)
• Microprocessor HD 404019 A05. (extract of circuit diagram attached)
• No synchronisation. (picture attached)
• Unsynchronised OSD if no aerial signal present. (picture attached)
• No functions. (extract of circuit diagram attached)
• The storage is lost or the set will not turn on.
• Vertical deflection fault. Only a few bent lines in upper part of the screen are displayed.
• Approx 5cm wide stripes in upper picture part. Stripes become brighter towards centre. Line transformer whistles. (extract of circuit diagram attached)
• Switches off by itself. intermittently. No start-up. (picture attached)
• Appliance fails when switched on (high voltage occurs 3 times). PSU is ok.
• Occasionally loud crackling from the housing.
• Line output transistor TL31 S2000A fails in irregular conditions. (+ extract of circuit diagram)
• A white dotted line appears on the left of the picture in VHF/Band I reception. (picture attached)
• Horizontal size varies. Colour varies.
• Snowy picture in UHF and VHF. (part of circuit diagram displayed)
• PSU switching transistor and line output transistor fail. (with circuit diagram extract)
• Dead. (extract of circuit diagram attached) (service info for NORDMENDE -55IMCFUTURA)
• Shuts down. (part of circuit diagram displayed)
• Picture is black in lower picture side. (+ extract of circuit diagram)
• Tuning voltage alters. (+ extract of circuit diagram)
• The East/West amplitude changes with the beam current. (with circuit diagram extract)
• Only a horizontal line in middle of picture. (+ extract of circuit diagram)
• Cut-Off lines become visible after some time. (with circuit diagram extract)
• No audio. No picture. (picture attached)
• Commands are only performed with a delay.
• The PSU fails 3 times and then switches off. Rep set has been replaced unsuccessfully. TP24 runs quickly time and time again. (part of circuit diagram displayed)
• Stuck in standby. (picture attached)
• N/S cannot be adjusted. (+ extract of circuit diagram)
• Only the bottom half is lit up, 3 RGB wavy lines, severe 50Hz noise.
• Poor start up performance of the power supply. (picture attached)
• Dead. Standby LED lit .
• No start-up. Standby LED lit . (extract of circuit diagram attached)
• Reduced horizontal deflection. (+ extract of circuit diagram) (55IMCFUTURA tip from NORDMENDE)
• Blocking all operation functions when checking tops text. (55IMCFUTURA tips)
• Vertical lines run over the whole screen. (with circuit diagram extract) (55IMCFUTURA NORDMENDE repair tip)
• Occasionally wide interference lines (similar to a defective HF-cable) appear on the screen. Picture is ok via Scart. (extract of circuit diagram attached) (55IMCFUTURA tip from NORDMENDE)
• Primary power supply fails under load. (picture attached)