6035 047802883 / NORDMENDE [TV]

• No function. Appliance fails very quickly twice. (part of circuit diagram displayed)
• Ballooning effect.
• No picture on lower half of screen. Top half picture OK.
• Switches to protection mode. at start-up.
• No or intermittent start-up. Switches off by itself. after a few seconds.
• No start-up. (part of circuit diagram displayed)
• Brightness fault.
• Noise in audio. at low volume.
• Bright line in the lower part of the picture.
• Intermittently dead. (+ extract of circuit diagram) (service info for NORDMENDE -6035)
• Switches to standby. (picture attached)
• Powers up with burning smell, then dead. Mains ON/OFF switch inoperative. (part of circuit diagram displayed)
• Blue picture. Flyback lines. No display. (part of circuit diagram displayed)
• Switches off or cannot be started up.
• The stations cannot be memorized.
• Erratic convergence values in the top third of the picture.
• Horizontal stripe.
• When the appliance has been on for approx. 10 minutes it quits and then comes on again on channel 1. This reoccurs in quick succession and then stays off completely after the third time. (extract of circuit diagram attached)
• All settings (colour/sound etc.) set to 0.
• Only 7 to 10 raster lines in centre of picture. Lines are moving and are not close together (picture attached)
• No synchronisation.
• After few mins of starting up, only half picture at bottom of screen. PSU chirps.
• Switches off after about 30 mins. If restarted immediately will function for a short time then switches off again.
• White stripes on the top of picture, which spin. After approx. 5 seconds picture becomes dark.
• Picture too dark. Blooming with full contrast. (6035 tip from NORDMENDE)
• Very short, faint crackle at switch on from standby
• Blurred picture with lines and hardly visible. Very dark.
• E/W fault. (6035 NORDMENDE repair tip)
• No luminance but colour is present. No signal on TR47, but 12V is present. (with circuit diagram extract)
• Tuning drifts, patterning.
• Faulty TXT.
• After switching over station has disappeared. After switching off and on again station returns.
• Height drifts.
• The picture is intermittent and jitters. (6035 tips)
• Horizontal bright stripe in the picture. (part of circuit diagram displayed)
• No vertical deflection.
• No RC functions.
• One colour missing.
• Wide dark stripes on left side of picture.
• No picture. No audio (intermittently). (picture attached)
• No channel search and no band switching possible.
• Picture is shifted. Linearity fault.
• Vertical fault.
• Occasionally picture becomes very narrow (East-West). (picture attached)
• Horizontal picture amplitude cannot be adjusted. E/W is defective.
• White screen. Flyback lines.
• No reception. in VHF.
• Colour flickers, Picture I ok, picture III cannot be adjusted. (picture attached)
• Picture and sound are missing, raster ok.
• Goes back to standby after approx. 5 minutes and then can be switched on again via the remote control. After a while the appliance switches off again and the situation repeats. (with circuit diagram extract)
• Occasionally the East/West scanning fails.
• Vertical roll. (6035 tip from NORDMENDE)
• Loud noise or crackling in the speaker during stereo transmissions.
• Intermittent serrated vertical edges in picture.
• Occasionally IF fault. (with circuit diagram extract)
• No E/W correction.
• No picture. (+ extract of circuit diagram)
• Poor, noisy stereo sound. Sounds distorted. Mono OK.
• No OSD. No TXT.
• Unsteady frame scan, lines may be present. (service info for NORDMENDE -6035)
• Switches on 3x for a short time, then goes to protective circuit.
• Channels cannot be switched over. Channel display stops on channel 5.
• Slow start-up.
• Failure to start up. Standby LED flashes at about 1Hz when appliance switched on at mains. (with circuit diagram extract)
• Power supply end stage transistor TP24 (S2000AF) fails after approx 15 mins. (part of circuit diagram displayed)
• Intermittently appliance switches off, one or two times per day. (+ extract of circuit diagram)
• Sound fails.
• Picture appears only after several restarts or after operating picture search. (service info for NORDMENDE -6035)
• Dead or trips.
• Does not switch to standby.
• Intermittently image and sound disappear. Then only dark flickering. knocking makes screen completely dark. Image conitues appearing if brightness key is pressed. Black/ white only. Image and sound normal again, also if key COLOUR is pressed.
• Roaring audio.
• No picture and no sound. The mains relay does not pull in.
• No audio. intermittently. Noise in audio. Knock sensitive.
• Intermittent white, horizontal line in the middle of the picture, otherwise dark.
• Bright picture. Stripes in picture. (6035 tip from NORDMENDE)
• How to store picture adjustment values.
• Picture dark and line visible in the top part. (picture attached)
• Zig Zag verticals.
• Snow in picture. intermittently. (part of circuit diagram displayed)
• Single straight line 2 inches from top of screen.
• Incorrect picture size.
• Focus problems.
• Dancing white horizontal lines on a stripe which is approx 10cm wide. Dark picture. (extract of circuit diagram attached)
• Horizontal stripes at 3-4cm distance. Dark picture. Loud chirping in line transformer.
• Snow in picture. Noise in audio. after a few minutes.
• Dark picture. on upper half screen. (extract of circuit diagram attached)
• After some time, switches off and then sometimes switches on again by itself. Dragging sound. Slight frame cramping. (with circuit diagram extract)
• Picture is overmodulated when picture content is bright. Picture flickers intermittently black.
• Poor vertical linearity.
• No functions. (picture attached) (6035 tip from NORDMENDE)
• Line output transistor fails repeatedly.
• Appliance does not start up intermittently, or attempts to start up 3 times. (6035 NORDMENDE repair tip)
• No horizontal synchronisation. (6035 NORDMENDE repair tip)
• Line tearing.
• S/C in PSU. (part of circuit diagram displayed)
• Lines flash on picture, may not affect all channels.
• No blue in the scale of colours. Grey wedge OK. A picture recorded via scart on an external appliance is in order. (with circuit diagram extract)
• Appliance switches briefly on three times and switches to protection mode.
• Picture is disturbed. Vertical lines are wavy. Picture improves when appliance is warm.
• Horizontal linearity fault.
• Y is missing. (+ extract of circuit diagram)
• Horizontal collapse. (part of circuit diagram displayed)
• No indication. Blue picture with flyback lines. (+ extract of circuit diagram)
• Switches off by itself. constantly.
• Black screen. after a few minutes.
• Dark and colourless AV picture. Occasionally only interference visible. No channel display. (picture attached) (NORDMENDE - 6035 information)
• The PSU collapses when the load is changed. (6035 NORDMENDE repair tip)
• Black and white picture on channels C46 to C51.
• Visible television picture in TXT (display shows lines). (NORDMENDE - 6035 information)
• Pulsates 2-3 times and switches off.
• No start-up from standby. PSU ticking. at start-up. (+ extract of circuit diagram)
• No function. Faint whistle.
• Flickering, flaring, brightness and contrast changes in picture or white with flyback lines.
• No picture. Audio OK .
• Battery dead.
• Flashing "PS" in display in standby. Switches off after a short while. (picture attached)
• Drop out in picture. (6035 tip from NORDMENDE)
• Dead. (part of circuit diagram displayed)
• Power supply pulsates 3 times, then no further function.
• Blank screen (no field scan) and smell of overheating. (with circuit diagram extract)
• Enter service mode.
• Starts up three times then switches off. Protection mode activated. (picture attached)
• Poor picture contrast, picture can hardly be seen. Becomes a little bit better with more brightness. (extract of circuit diagram attached)
• Dead, low whistling.
• Immediate S/C. Brief HT, then standby. (with circuit diagram extract)
• Image compressed horizontally. Insufficient width approx 1cm on left and right of screen.
• Picture interference plus noise on sound.
• Irregular sound mute. (+ extract of circuit diagram)
• Appliance has drop out. (+ extract of circuit diagram)
• Does not receive any channel. Everything OK via SCART.
• Dark picture. after a while.
• Random clicks with Nicam sound.
• Functions only after several attempts.
• Pincushion distortion.
• No light during max. contrast and brightness. Faint picture. Picture present via scart. (extract of circuit diagram attached)
• Contrast problems. (NORDMENDE - 6035 information)
• No tuning. in UHF. VHF OK . (extract of circuit diagram attached)
• With low brightness and contrast, the UHF range is affected by distortion up to channel 28. At maximum brightness, the picture is ok. (with circuit diagram extract)
• No HV.
• Horizontal output stage transistor fails repeatedly after few days/weeks without any apparent reason.
• Picture collapsed to a 5 cm horizontal line in picture centre. (NORDMENDE - 6035 information)
• Popping noise at switch on.
• No vertical deflection. when cold. (part of circuit diagram displayed)
• Switches off by itself. Knock sensitive.
• Moire pattern.
• Versucht 3 times to start up, then remains off.
• The top half of the picture is rainbow coloured and cannot be adjusted.
• Vertical collapse. (with circuit diagram extract)
• Distorted field linearity. (extract of circuit diagram attached)
• Noise bars. (6035 NORDMENDE repair tip)
• No function. Trips three times. (picture attached)
• No new channels can be adjusted, no reception but old channels however are stored.
• No channels visible. Dark picture, without colour. AV picture visible, without colour, dark and intermittently only picture noise.
• Switch on condition of the primary power supply.
• No start-up. Standby LED flashes . (service info for NORDMENDE -6035)
• Occasionally loud cracking and noise in the sound, also when the volume is turned down.
• Poor audio. Noise in audio. (+ extract of circuit diagram)
• Jagged picture vertically.
• After light spot when turning off.
• No picture, no sound. No stations are found during station search. (picture attached)
• Pulsates 2 up to 3 times, otherwise no function.
• Dark picture without colour. AV picture visible, without colour, dark and only intermittently visible picture noise. (NORDMENDE - 6035 information)
• Picture visible in 1" strip at left hand side of screen, rest blanked. (6035 tips)
• No TXT.
• No picture. No audio. (picture attached)
• Image position adjusts itself vertically wrong.
• Picture is dim and faint.
• No start-up (intermittently).
• The PSU pulsates very faintly three times a second. Power processor, quartz, LOPT and BUs have already been replaced unsuccessfully. Mains transformer and flyback transformer have been completely resoldered. (NORDMENDE - 6035 information)
• Trapezoid picture.