562107 / OTTOVERSAND [TV]

• No colour in main picture. PIP OK.
• Comes on for a short time.
• No picture, only AV OSD.
• Bright, white picture with flyback lines, switches off after 10 sec.
• Switches off by itself. after a few minutes.
• Audio fades. after a few seconds. Picture OK .
• Slight hum from speakers.
• Low noise in sound.
• Raster ringing and H-linearity. (+ extract of circuit diagram)
• CRT socket. (OTTOVERSAND - 562107 information)
• No audio. Poor geometry.
• No colour.
• Q601, Q602, Q615 fail repeatedly at switch on.
• Voltages are too low.
• Intermittentlly no function at switch on. No display (LEDs dark). If mains plug is removed and plugged in again, PSU starts up intermittently.
• Switches to protection mode. after a few seconds.
• Noisy picture, picture and picture is OK in VHF.
• A & B LEDs flashing in standby causing appliance to switch on intermittently from standby.
• Picture disappears when vertical deflection fails, appliance cannot be switched on then. Protective switching responds at every start up. (562107 tips)
• Dead.
• Audio plop when switching preset channels. (+ extract of circuit diagram)
• Horizontal lines in zoom mode.
• Poor picture. OSD and TXT OK . (extract of circuit diagram attached)
• OSD appears in picture for 2 secs as soon as picture appears after switch on then switches to protection mode.
• RC unit.
• Low contrast. after a while. Flyback lines.
• Picture appears slowly. Audio OK .
• No HV. after a few seconds.
• Very dark picture. No sound. Geometry faults.
• Geometry has shifted or appliance does not switch on.
• E/W fault. intermittently. Vertical fault. intermittently. Switches off by itself. (service info for OTTOVERSAND -562107)
• No function after being switched off and immediately switched on again. Applies to switch off/on with mains switch and from standby. (service info for OTTOVERSAND -562107)
• No RC functions.
• Shuts down. after start-up.
• Error codes.
• No picture. after start-up. Audio OK .
• No audio. No picture.
• RC unit.
• Green picture. Flyback lines.
• Enter service mode.
• Red picture with flashes. Intermittent standby. Intermittent start-up.
• Reduced vertical and horizontal size. Excessive red.
• Switches to standby after a few secs. LED A blinks once, then LED B blinks 4 times and cycle repeats itself. (562107 OTTOVERSAND repair tip)
• No picture ,OSD and Text available. LED blinks 4 times.
• Blinking STEREO/NICAM LEDs in standby mode.
• Dark picture for half an hour, then picture with poor contrast.
• No OSD. Switches off by itself. after a while. (part of circuit diagram displayed)
• LED A blinks once, then LED B blinks 4 times. Cycles.
• No function. Squeaking sound from power supply.
• How to enter service menu to adjust geometry.
• Picture is black. Menu, OSD, text and sound OK. Channel B LED blinks 5 times. (OTTOVERSAND - 562107 information)
• Red picture. Picture too small.
• No picture. (OTTOVERSAND - 562107 information)
• Horizontal line.
• Poor audio. on the left.
• RC unit.
• Vertical streaks.
• No or intermittent start-up. Switches off by itself. after a while. (+ extract of circuit diagram) (service info for OTTOVERSAND -562107)
• Black lines at the bottom of the picture, increase with time.
• Picture switches randomly from large to small format at irregular time intervals.
• Poor picture. Low audio. (562107 tip from OTTOVERSAND)
• Colour and AFC fault when cold at switch over.
• "PROTECT SP" displayed.
• Flyback lines.
• Test lines in upper picture half can be seen, vertical deflection distorted at upper picture edge.
• Starts up, HV builds up which can be heard then switches off after approx 3 secs. No LED display. (extract of circuit diagram attached)
• Picture too dark and/or various irregularities in geometry, brightness and volume. Also incorrect PB from the menu or spontaneous menu action. (picture attached)
• Appliance starts up, but no LED, no vertical deflection audible and switches off after approx. 10 secs.
• No RC functions.
• No start-up.
• Switches to protection mode. (picture attached) (562107 OTTOVERSAND repair tip)
• No Dynamic Noise Reduction setting with software version AE306. (OTTOVERSAND - 562107 information)
• No picture or picture is dark. No sound. Different geometry faults.
• No picture. intermittently. (service info for OTTOVERSAND -562107)
• After setting volume to max, sound drops out, then cannot switch TV back on or it starts up but, if put into standby, does not switch on and, in this case, no front LED.
• PSU starts and switches off immediately. No LED display.
• No sound on some programs or sound appears later.
• Stripes and other interference in picture when switching to channels in band III. OK after 6 secs. (+ extract of circuit diagram)
• Red, green or blue picture with flyback lines. (extract of circuit diagram attached)
• Intermittently dead.
• TXT menu corrupted. A number of characters is repeated. (part of circuit diagram displayed)