565514 / OTTOVERSAND [TV]

• No audio. No picture. Fault occurs intermittently. . (picture attached)
• Dead. Screen doesn't become bright. LED pulsates 11times.
• Interference in picture. Crackling audio.
• Arcing noise and flashing lines on screen. (with circuit diagram extract)
• RC unit.
• RC unit.
• Ragged picture. Too much green via tuner. Picture OK via AV.
• How to re-initialise the NV ram.
• Comes on for a short time. (+ extract of circuit diagram)
• Relay trips. (picture attached)
• Slight line tearing. Switches off after 1 min. LED flashes 2 times. (extract of circuit diagram attached)
• Extremely poor CRT purity. (with circuit diagram extract)
• Switches to standby. Comes back pressing a button, but goes off again after a while. (extract of circuit diagram attached)
• LED flashes. after start-up. (picture attached)
• Intermittently switches off when switched on. Visible arcing interference on screen when appliance does function. (+ extract of circuit diagram)
• No start-up. intermittently. Comes on for a short time.
• No video via AV1.
• Picture is very high with E/W fault. Picture occasionally in black and white. (picture attached)
• No picture, no sound. No vertical deflection. Error code 2.
• When turning on, it seems that it starts up, but the red standby LED starts flashing. (part of circuit diagram displayed)
• Error codes. (picture attached)
• Volume goes up and down randomly.
• Flashing picture. (picture attached)
• No audio (after a few seconds). No channel storing.
• No picture. intermittently. (+ extract of circuit diagram)
• Information when LED flashes 19 times on power up.
• RC unit. (565514 tip from OTTOVERSAND)
• Tuning drifts. after a while.
• TXT and program number shifted 10cm to the right.
• No sound in Canal Plus after switch on, either from standby or other. (service info for OTTOVERSAND -565514)
• On switch on EHT comes up and runs for 5 secs, then loss of line drive. (with circuit diagram extract)
• Pincushion distortion, text disappears at left and right. (picture attached)
• Switches to standby.
• Blue screen. at start-up. Trips.
• Picture cuts off intermittently with poor brightness or red/green tinge.
• Picture appears and disappears twice a sec. When it is a bright picture it happens more frequently. Dark picture OK. (extract of circuit diagram attached) (565514 tips)
• No picture. Audio OK . (extract of circuit diagram attached)
• Switches to protection mode. after start-up.
• Value of C818.
• Switches to protection mode. in TXT.
• No start-up. after lightning strike. (extract of circuit diagram attached)
• Whine noise from speakers when volume is turned on.
• Switches on, sound appears, appliance switches off shortly afterwards, LED flashes 2x, no picture.
• EHT comes up briefly then nothing. No error code. (extract of circuit diagram attached)
• No audio. Headphones OK. (+ extract of circuit diagram)
• Starts up for 2 seconds then stops. Relay pulsates 3 times then LED flickers in sequences of 24 times. Appliance functions normally when activating switch several times.
• Takes about 5 mins for picture to appear. Sometimes disappears for a few seconds then comes back on.
• Degaussing incomplete. (picture attached)
• Incomplete or messy OSD and menus. TXT OK. (with circuit diagram extract) (service info for OTTOVERSAND -565514)
• Does not got into standby mode completely; picture disappears but line continues to run. (+ extract of circuit diagram) (565514 tip from OTTOVERSAND)
• Trips off just as brightness appears. LED's flashes twice. (part of circuit diagram displayed)
• RC unit.
• Locks when hot. (with circuit diagram extract)
• RC unit.
• AV on the left upper side of display does not disappear in AV. (565514 tip from OTTOVERSAND)
• PSU blocked. Squeaking.
• Switches to protection mode after a second. Front LED flickers 2 times. (565514 tip from OTTOVERSAND)
• RC unit.
• No picture. after a while. Audio OK .
• Green picture. No picture. after a while.
• Shuts down. intermittently.
• Low contrast. after a few seconds. Flyback lines. after a while. (+ extract of circuit diagram)
• Excessive horizontal size. Pincushion distortion. on sides. (picture attached)
• Picture too big. (service info for OTTOVERSAND -565514)
• Blank screen (intermittently). Audio OK . (part of circuit diagram displayed)
• Blurred picture, right side is darker and there are flashing blank lettering. (extract of circuit diagram attached)
• Vertical collapse. (picture attached) (service info for OTTOVERSAND -565514)
• Switches off by itself. after start-up. (with circuit diagram extract)
• RC unit.
• No E/W correction. (part of circuit diagram displayed)
• Buzz from the right speaker in Nicam which varies with sound level. In MONO OK. (part of circuit diagram displayed)
• Switches off to standby intermittently. LED flashes 2 times, and again 2 times after switch off.
• No functions. OSD volume bar always on screen. (565514 tip from OTTOVERSAND)
• Stripes in picture, especially in corners.
• Black screen. Audio OK . (picture attached)
• Pulses in and out of standby. RY600 clicks each time. (extract of circuit diagram attached)
• Dead. (part of circuit diagram displayed)
• Switches to security. LED blinks 2 times.
• Blue screen. Flyback lines. Switches off by itself.
• No start-up. Clicking noise. Burning smell.
• How to change audio norm.
• No sound from cold for first 30 mins. (part of circuit diagram displayed) (565514 tips)
• Intermittently channel hops.
• Green screen with flyback lines at switch on, then switches to standby after 10 secs.
• Picture too big and E/W defect. Switches off after a while and goes back on with black screen. (+ extract of circuit diagram)
• Speakers buzz.
• No display. No picture. (part of circuit diagram displayed)
• Intermittently switches off after bright green picture.
• Horizontal tearing (after warm-up). (picture attached)
• Overbright, nearly negative picture.
• LED blinks twice after storm.
• Vertical bounce. (with circuit diagram extract)
• Enter service mode. (service info for OTTOVERSAND -565514)
• Vertical lines. No colour (intermittently). Switches to protection mode (intermittently). (with circuit diagram extract)
• E/W correction poor, along with poor picture, low brilliance and red bands either side of picture. (extract of circuit diagram attached)
• Switches to protection mode after a few secs. LED flashes 2 times.
• Blue picture.
• AV connected locks on but no vision just audio.
• Channels wiped out of memory.
• Dark picture. Reduced horizontal size. (picture attached)
• Dark picture. after a few seconds. Flyback lines. (picture attached)
• After a short operation time, whitish picture with spots. Appliance switches off and on. (extract of circuit diagram attached) (OTTOVERSAND - 565514 information)
• No picture.
• Switches on, picture only appears for approx. 1 sec after voltage built-up. Switches off and flashes twice every sec.
• Attempts to start up, EHV audible, switches to standby, LED flashing. Intermittent fault. (with circuit diagram extract)
• Excessive height varies with picture content, after 2-3 minutes frame collapse followed by shut down and LED flashing error 2. (with circuit diagram extract)
• Channels change at random. (with circuit diagram extract)
• No synchronisation. in TXT. (with circuit diagram extract)
• Picture present then screen becomes black. Picture comes back for 10 mins.
• Inmediate green pincushion effect followed by appliance stopping. The only way to make it work is switching it off with main switch and switching it on again. Still, the fault reappears later on.
• Switches to protection mode.
• Does not switch to standby. (with circuit diagram extract)
• Intermittent bright blue picture.
• Switches off by itself after about a minute. (565514 tip from OTTOVERSAND)
• LED flashes an error code 2 on power up. (+ extract of circuit diagram)
• No start-up. LED lights-up for a short time.
• Shuts down (at start-up).
• No audio.
• No OSD. No TXT. (+ extract of circuit diagram)
• Picture shifted vertically. (565514 tip from OTTOVERSAND)
• Dead. LED blinks .
• How to change norm to PAL I.
• Picture comes and goes on a regular basis, both via antenna and via scart socket. Sound is always ok. Green spot for a few seconds after switching TV off.
• One colour missing. intermittently (after a few minutes).
• Floating picture. Raster OK. Picture OK when connecting TV to SCART socket. Audio OK.
• No channel switch-over. Pictures appears after 5 seconds. (extract of circuit diagram attached)
• No picture unless contrast and brightness turned fully up. (picture attached)
• Flashes or stripes when appliance is warm. Crackling. (565514 tip from OTTOVERSAND)
• Picture switches off, then on and is discoloured (when cold).
• General information.
• Flickering picture. Faulty TXT. (part of circuit diagram displayed)
• High pitched tone which alters with the volume and mutes when changing channels.
• Noise bars in picture for approx. 15 mins, then OK. (part of circuit diagram displayed)
• LED flashing 19 times on power up. (part of circuit diagram displayed)
• No sound through phones or scart.
• No picture. Switches to standby, after a few seconds. LED blinks 2 times.
• RC unit.
• VOL varies. Channels lost from memory and strange characters down one side of screen. (part of circuit diagram displayed)
• Picture appears slowly. Audio OK .
• Cannot adjust Usystem at 140V.
• No audio from cold for 30 min.
• Shuts down (after warm-up). (extract of circuit diagram attached)
• Bright raster. Dim picture. No LED lit. (part of circuit diagram displayed)
• TV switches off in standby then switches on again with a click and with LED flashing. Impossible to switch on TV afterwards. (extract of circuit diagram attached)
• Sizzling in picture, mostly in TXT.
• RC unit.
• Tries to start-up for three times, then shuts down and LED flashes 15 or 23 times.
• Dead, comes on momentarily with flyback. (extract of circuit diagram attached)
• Horizontal interference in picture during first half hour. (+ extract of circuit diagram)
• Searches for channels continuously. after start-up.
• Does not shut down. Red LED blinks. (with circuit diagram extract)
• Stuck in standby. (+ extract of circuit diagram)
• No audio.
• No vertical deflection.
• RC unit.
• No picture. No audio. after a while.
• Serrated line near top of screen and one near the bottom. (extract of circuit diagram attached)
• No audio.
• At start up, EHT switches on and line driver control immediately drops out. LED does not blink. Picture and sound present via scart. Standby and channel switch over function via RC.
• RC unit.
• No sound from cold. (picture attached)
• LED flash twice, pause then flash twice again. (picture attached)
• Partially blanked horizontally. (picture attached)
• TV operates correctly on normal channels. On CANAL +, colour disappears after a sec.
• RC unit. (service info for OTTOVERSAND -565514)
• E/W fault. Line output transistor fails repeatedly. after warm-up.
• RC unit.
• At switch on, sound and picture take about 5 minutes to appear then cut out regularly every 5 seconds.
• No start-up (intermittently). (with circuit diagram extract)
• Comes on then switches to standby. Standby LED flashes twice. (+ extract of circuit diagram)
• Noise in picture. Horizontal size varies. when cold. (+ extract of circuit diagram)
• Information when LED flashing 2 times on power up.
• Poor geometry settings. (with circuit diagram extract) (OTTOVERSAND - 565514 information)
• Cycles on/off with relay click and blank raster. Starts up OK.
• Switches sporadically to safety mode, LED blinks twice. Slight line tearing and/or picture amplitude changes visible. (with circuit diagram extract)
• Black or green picture with flyback lines. (565514 OTTOVERSAND repair tip)
• RC unit.
• No audio output.
• Tripping. (extract of circuit diagram attached)
• Characters on left side of screen.
• Poor geometry. (565514 tip from OTTOVERSAND)
• Red picture. Flyback lines. (with circuit diagram extract) (565514 tips)
• Blank raster.
• No TXT. Shuts down (intermittently). (part of circuit diagram displayed) (service info for OTTOVERSAND -565514)
• No RC functions (intermittently). (part of circuit diagram displayed)
• E/W fault. Pincushion distortion. (+ extract of circuit diagram)
• No audio.
• Distorted or loud crackling from audio. (picture attached)
• STEREO indication blinks in picture, then switches off.
• Vertical collapse or error code 2.
• No sound in Canal Plus after starting up, whether it is from standby or not.
• Green screen and flyback after 5 minutes. (picture attached) (service info for OTTOVERSAND -565514)
• No audio. No picture. No TXT. No OSD. No vertical deflection ocassionally. No error code.
• Thin lines and grey picture. (+ extract of circuit diagram) (565514 OTTOVERSAND repair tip)
• Continuous buzz. Goes off if mute or min VOL is selected.
• No picture (intermittently). Audio OK . (picture attached)
• Black screen. (with circuit diagram extract)
• No forward/back zoom in widescreen zoom.
• Switches to protection mode (after start-up). (with circuit diagram extract)
• Blank screen (intermittently).
• Excessive brightness. (part of circuit diagram displayed)
• Picture appears slowly. (picture attached)
• Squealing noise.
• Poor sound on one channel.
• No line drive when cold. After a minute the relay clicks on/off every 10 secs. The picture disappears periodically.
• Green flyback lines at switch on then dead after ten secs. (picture attached)
• Starts with reduced height then shuts down. 2 LED flashes.
• Service mode for geometry adjustments and colours.
• TV fails after 48 hours then switches to safety at switch on. TV starts up by RC after many attempts but no picture and 1cm horizontal bar on bottom 1/3 of picture. Sound ok. Switches to safety once again. (with circuit diagram extract) (OTTOVERSAND - 565514 information)
• 5cm line at the top edge.
• No sound, picture or LEDs. (extract of circuit diagram attached)
• Vertical collapse. after start-up. (+ extract of circuit diagram)
• RC unit.
• Wide mode image too small.
• Red frame with flyback lines.
• No functions. (part of circuit diagram displayed)
• No channel change unless menu is pressed first. (extract of circuit diagram attached)