692985 / OTTOVERSAND [TV]

• Intermittently dead. (part of circuit diagram displayed)
• Appliance switches off and goes into safety mode at random, when warm.
• LED flashes 4 times, then pause, then flashes 4 times, otherwise no function. (extract of circuit diagram attached)
• Dead.
• Torn picture. (with circuit diagram extract)
• RC unit.
• Dead. Whistling. (with circuit diagram extract)
• Start-up problems from standby mode.
• Strong buzzing noise on certain channels.
• No synchronisation (intermittently). Patterns in picture. (+ extract of circuit diagram)
• Low voltages from PSU. (692985 OTTOVERSAND repair tip)
• Dark picture with two red lines on top. (+ extract of circuit diagram)
• No start-up from standby (when cold). (extract of circuit diagram attached)
• Freeze frame in standby. Small picture. (part of circuit diagram displayed)
• No reception. When looking for stations on high frequencies, goes to look for lower frequencies. (part of circuit diagram displayed)
• No audio. Buzz in audio.
• Standby LED flashes permanently.
• Flashes twice.
• No audio. Picture OK .
• Switches off by itself. after a few hours. (692985 tip from OTTOVERSAND)
• Power supply starts up and cuts out instantly. (picture attached)
• Switches off and starts up from program site 1.
• Blank picture at bottom in all display modes except 4:3. (extract of circuit diagram attached)
• No sound. No picture. Red LED blinks twice.
• Black lines (vertical oscillation) at lower edge of picture, after a certain time. (part of circuit diagram displayed)
• No function. Screen doesn't become brighter. LED pulsates 11 times.
• Red picture. Flyback lines.
• Black screen. No audio. OK via SCART .
• Whines when standby selected. Small dim raster in centre of screen.
• Switches to protection mode.
• In service mode, cannot adjust horizontal amplidute in 4/3 mode.
• Torn picture, E/W correction is slightly too large.
• Lines in picture. on the left. (+ extract of circuit diagram)
• No LED. Noise from PSU.
• Noise bars in picture for approx 15 mins, then OK.
• Picture missing in 4:3 mode.
• RC unit. (692985 tips)
• Distorted picture.
• Switches off by itself.
• Black vertical line in the middle of the screen. (extract of circuit diagram attached)
• Colours vary on certain "S" channels, i.e. S11 to S13 and S17.
• No standby connection in cold conditions. (extract of circuit diagram attached)
• Enter service mode.
• Error codes. (with circuit diagram extract)
• Relays pulls in, drops again within 1 sec. LED lights up or flashes.
• Humbar on dark scenes of picture. (part of circuit diagram displayed)
• No picture. after a few seconds. (picture attached)
• Line tearing. Excessive vertical size. (+ extract of circuit diagram) (692985 tip from OTTOVERSAND)
• RC unit.
• No audio.
• Goes to standby ten times with LED flashing. (+ extract of circuit diagram)
• No start-up. (with circuit diagram extract)
• No picture. No OSD. Audio OK . (+ extract of circuit diagram)
• No picture. OK via SCART . (with circuit diagram extract)
• Tuning drifts.
• Reduced horizontal size. E/W fault.
• No audio.
• No sound at start-up. Sound appears after a short time but sound PB distorted (like defective speaker).
• No functions. LED blinks .
• Starts from standby but switches immediately off. LED remains ON.
• Intermittently picture drops down to leave black band at top and then pulls to right. (picture attached)
• RC unit.
• No functions. Power LED lit . (with circuit diagram extract)
• Distorted audio. No start-up. intermittently. LED blinks .
• Standby LED flashes 4 times immediately after switch-on.
• No function. Fails
• E/W fault.