 |
774138 / OTTOVERSAND [TV]
The EURAS repair tip database for professional technicians and service engineers
supplies the following faults for 774138 / OTTOVERSAND.
List of fault symptoms:
- Noise in one channel.
- Sparkles then goes off.
- Squealing noise.
- No vertical deflection.
- Switches to standby.
- Squeals when switched on then goes dead. Channel LED lit.
- Vertical bars run down the left side of the screen in one third of the picture. This is clearest on AV. We have already tried to level off 12V and 205V slightly.
- No audio.
- Line switch breaks down without any apparent reason.
- Switches on for a short time and then switches off after approx 0.5 secs. OSD remains.
- Cogging on verticals.
- Picture size varies with picture content.
- Leaky line output transistor and fusible feed resistor O/C.
- No picture. No audio with OSD display unlocked and drifts from bottom right hand side up to top left hand side. (774138 tip from OTTOVERSAND)
- Vertical collapse.
- Whistling and horizontal lines on picture.
- No colour. Picture only black and white in digital mode.
- Right hand side cramped.
- Line output transistor fails repeatedly.
- Nicam Crackle. (service info for OTTOVERSAND -774138)
- Faint line on raster.
- Stays on briefly, then switches to standby leaving three blobs of colour in the middle of the screen.
- No sound in HF. OK in AV.
- Orange picture.
- No picture. Channel display on .
- Excessive vertical size. Vertical foldover at top.
- Intermittent teletext and occasional bar graph on screen.
- Irregular horizontal lines. Vertical outlines tear.
- Creaking or sizzling sound, otherwise no function.
- E/W fault.
- No audio for 10 mins.
- Goes bright red then trips off.
- No picture.
- Flyback lines. on upper half screen.
- Intermittently bright red.
- After switching on with the remote control or mains switch short chirping noise in the PSU. PSU then switches off, only the program display still functions. (OTTOVERSAND - 774138 information)
- device starts up for short while, HSP drops out display ok.
- After a few hours, right hand side of picture creeps in by couple of inches with slight E/W distortion.
- Bright raster. Flyback lines.
- Squealing from PSU. (774138 tips)
- No start-up. Squealing from PSU. (774138 OTTOVERSAND repair tip)
- Q551 runs hot and R567 blows after 4 hours.
- No sync on teletext.
- Dead.
- Dead, channel indicator LED lit and momentary squeak from power supply at switch on.
- No E-E just blank raster. Scart input OK.
- No TXT.
- No TXT. No bar graphs. TXT OK in mix.
- Poor, faded picture.
- Dead. Channel display on .
- Low brightness.
- Failure of line output transistor Q551 (2SD1441RL).
- Comes on for a short time.
- Brief current consumption after switch on. Display OK.
- Switches off by itself. intermittently.
- Switches to protection mode. Whistling from PSU.
- No horizontal deflection.
- Intermittently no line hold.
- Dead. Display OK .
- Line squiggles/osc noise from scan coils.
- Blank screen. No OSD. No TXT.
- Orange picture.
- No audio. OSD display unlocked and drifts from bottom right hand side up to top left hand side. No picture.
- Shuts down (after start-up). (774138 OTTOVERSAND repair tip)
- Stuck in standby. No functions. Display OK .
- Red picture. Flyback lines.
- No sound from cold.
- No functions.
- No picture (intermittently). Audio OK .
- Resistor (R567) in the HT feed to the line output stage blows after a few hours.
- No colour.
- No audio. No picture. Display OK .
- Line output transistor S/C.
- 4 horizontal lines across upper half screen.
- No signal. Slow and erratic RC functions.
- Powers up for one second then shuts down. LED and channel no. are still displayed.
- SD1441 (horizontal deflection) is S/C.
- Non linear top of frame scan and/or portion of scan missing. Possibly flyback lines.
- Intermittent bright blue or green picture.
- Ticking noise.
- Top of picture has stretched but corrects itseft when warmed.
- Right side of screen is shaded. Low lighting. (OTTOVERSAND - 774138 information)
- No picture for 30 minutes.
- No luminance signal. Chroma is present.
- No focus. (OTTOVERSAND - 774138 information)
- Black screen. Audio OK .
- Unlocked OSD and bar graphs. Irregular TXT.
- Unlocked OSG, picture OK.
- IC801 defective again after several months.
- Bowed picture. (774138 OTTOVERSAND repair tip)
- No RC functions.
- Speckled white bands.
- Line scanning transistor fails.
- Shuts down. after start-up. Channel display on .
- PSU chirps. (service info for OTTOVERSAND -774138)
- Intermittently flickers and powers off.
- PSU whistles for a short time after switch on, program display remains. Previously E/W fault occasionally.
- Picture has a faint line of shading down right hand side with low brightness or in the AV mode.
- Shuts down.
- Smeary red content of picture, red cut-off and drive controls critical.
Tips are coming from EURAS customers, workshops and payed technicians from all over the world. OTTOVERSAND 774138 fails can be better solved. If OTTOVERSAND 774138 fails, this information will help you. Here you can only see the symptom list, to access remedies, you must register. With help of this list a solution is found often when OTTOVERSAND 774138 fails.
|
Additionally to repairtips or service information 774138 is linked to 69 components (IC's and/or transformers) in the Tectra
database, through which you can identify electrical compatibilities (crossreferences) in
appliances.
|
Chassis information is available (which chassis is built in into 774138 ).
EURAS system also knows 26 appliances having the same chassis as 774138 and can easily list them.
In the repair discussion pinboard for 774138 there are 26 replies to questions asked about 10 different repair problems. With access to EURAS you can all read them or enter your own questions and get help for 774138 from EURAS technicians or other users.
Do you want to see this remedies/cures for repairtips? Register here for the EURAS System Please note: access to the EURAS System can be granted only to professional
TV/technicians/household electronics repair shops/Video which are
authorized for service by a manufacturer, or can prove to be professionally
certified to do repairs on electronic appliances. You will be asked for a
statement and information accordingly during registration.
If you do not qualify as stated above and you have an appliance that needs
technical service, we do recommend you to contact the manufacturer (for
example through his website) or go to a professional TV/Video/household
electronics repair shop close to you.
Already registered? open 774138 OTTOVERSAND in EURAS
All details on the EURAS System: English |
Deutsch |
Français |
Italiano |
Español |
Magyarul |
Português |
Polski |
Română |
Greek |
Back to EURAS Homepage >>
All manufacturers >>
OTTOVERSAND
tech tips
Last updated: 05. Nov 2009 10:56:04 MET, doccode ISO9002AS168EKA200805C EURASMOP
Responsible for the content: EURAS International GmbH, Eime, Germany.
All brand- or productnames are copyrighted by the respective manufacturer of the appliance and are only being used for identification purposes.
|
|