774713 / OTTOVERSAND [TV]

• Horizontal deflection plug burnt.
• Flyback lines. at top.
• No sound. Loudspeaker relays are "mute".
• Intermittent rolling picture. Sometimes also a horizontal stripe or no picture at all.
• No picture. Audio OK .
• Does not switch to stereo. (OTTOVERSAND - 774713 information)
• No vertical synchronisation.
• Switches to protection mode (intermittently).
• Black-white setting adjustment.
• Adjusting the option byte (OP).
• PSU does not work properly.
• Stripes in picture and distorted picture after 5 mins.
• No function of PIP module via scart.
• Standby flashes, no function.
• Picture is bright and flickers, sound is present.
• Bright green picture with flyback lines.
• R19 burns.
• No functions.
• Picture is completely white via AV.
• No audio.
• PSU does not function.
• E/W cannot be adjusted.
• Reduced horizontal size.
• BUV 70 in PSU fails again immediately.
• Horizontal end stage transistor T2 is destroyed after operating time
• Dark picture. Audio OK .
• Picture is blurred and has a very high contrast and contrast cannot be altered.
• E/W correction does not work.
• Contrast is too weak. Contrast cannot be adjusted. (774713 OTTOVERSAND repair tip)
• Bright picture. Flyback lines. No audio.
• Black picture.
• No U2.
• Line tearing and brightness fluctuation.
• No picture. No sound. PSU tries to start, vibrating sound.
• Switches on immediately and cannote be switched off with RC. (774713 tip from OTTOVERSAND)
• At switch-on from cold, intermittently no sound and no vertical/horizontal sync. When it switches on correctly, picture comes on with horizontal bars.
• Intermodulation (pattern in coloured surfaces) with large aerial level. Error signs in TXT.
• No start-up. Standby LED lights green.
• No storage.
• No picture (intermittently). Audio OK .
• R17 blown in vertical deflection.
• BU508A fails at start-up.
• E/W fault.
• Vertical deflection defective. Different picture errors; sound OK.
• Service adjustment for East/West horizontal amplitude shows no response.
• Stuck in standby.
• Weak colours. Stripes and lila faces.
• No green.
• Sound is low and fades away. (774713 tip from OTTOVERSAND)
• Red picture. Flyback lines.
• Picture folds down on the top. Flyback lines.
• Picture shifts approx 3-5 mm downwards, then becomes OK again.
• No sound. Picture is black and perhaps white stripe at the top edge of the picture.
• No sound or sound distortion.
• Line output stage is defective.
• Horizontal centre adjustment.
• Dark picture. No vertical deflection.
• Horizontal sync changes.
• Transistor T101 and IC 101 fail in power supply.
• No picture. No sound. Display is OK. Videotext won't synchronize.
• Appliance does not switch on. U2 and U3 are missing. If appliance is started with the IR transmitter chirping can be heard in the PSU.
• Black picture at the bottom, white line in the middle, distorted picture above that
• Scanning won't stop. No sound.
• Line foldover.
• Dark picture.
• The top 10 lines have been drawn out and partly folded over. No temperature fault.
• Black bars in picture. Flyback lines . No colours. (service info for OTTOVERSAND -774713)
• Horizontal stripe. intermittently.
• Perpendicular stripes on the left of the picture.
• No colours after warm up.
• Picture grey, sound OK. No RC functions.
• Small vertical lines in the picture.
• Picture runs through vertically in tuner operation. (774713 tip from OTTOVERSAND)
• No picture at start up, sound is fine. After 1 minute there is a picture.
• No function. No U1 (148).
• Picture blooming in AV mode. (774713 tips)
• Dark screen. Audio OK .
• Excessive horizontal size.
• Immediate failure of BUV70 at switch on.
• On the left two vertical stripes. Sync alters.
• RC has no range of transmission.
• No sound via loudspeaker. Sound OK via head phone.
• Bright stripe in picture centre.
• Chirping.
• T2 fails again immediately. (774713 tips)
• Picture is overcontrolled in AV mode.
• Sound is distorted. Whistling sound is audible.
• Channel mistunes after memorization.
• Sound is very low in mono, ok in stereo.
• No picture, not even in video. Sound ok. Predominantly green screen, menu display and adjustments.
• Snowy picture after switch on.
• No AV operation. Bright picture
• No contrast. White picture.
• Bottom half of the picture is missing and horizontal, unsynchronised lines. Improves with time but insufficient vertical amplitude.
• Does not memorise.
• Blank raster. No RC functions. No OSD.
• 2-3cm wide horizontal stripe in image.
• Two vertical stripes on the left. Synchronization alters.
• Black screen when Canal Plus decoder is plugged onto scart plug. Scart OK when plugged to VCR.
• Display is black. At times colours are missing.
• Vertical deflection is defective. Upper picture aprt is oversized and picture is contracted at the bottom.
• Picture amplitude is defective.
• Picture is approx. 1cm high.
• No brightness.
• 2cm wide black stripes in upper picture part.
• Trips.
• Occasionally uP blocks.
• No colours (intermittently).
• Adjusting the horizontal centering in TXT.
• No picture in mono. Ok in stereo.
• No green.
• No colour.
• Adjusting the Y delay.
• No or incorrect colours.
• No channel storing.
• Picture compressed at bottom.
• Frame fault.
• No red. Picture tube cathode has 200V instead of approx 140V.
• Picture is distorted at D box. (OTTOVERSAND - 774713 information)
• No blue.
• With a new digital board picture is white and has no tone. After switching off picture is white again.
• In Service Mode it is not possible to adjust G2.
• Comes on for a short time.
• No blue.
• Transistor BD 683 line driver has no operating voltage at collector.
• White screen.
• No picture. Sound present. Picture is blue/lilac with flyback lines.
• Only a vertical line.
• Adjusting the colour sub carrier.
• Only snow in the picture. No tuning possible.
• No functions. Starts up OK.
• No channel storing. (OTTOVERSAND - 774713 information)
• White picture and flyback lines.
• Power supply transistor fails every 3 hours. (774713 tips)
• Snow in picture.
• Vertical sync is unstable. Dark picture.
• No horizontal synchronisation.
• Picture rolls at times.
• No picture. (774713 OTTOVERSAND repair tip)
• No picture and videotext sync. (774713 tips)
• Picture is too dark. TXT is hardly recognizable.
• No audio via AV.
• Oscillations at the top of the picture which disappear after a few mins.
• Picture is displaced to the bottom of the screen. Fault recedes when appliance warms up.
• Picture is grey, sound OK.
• Stops a brief period after switch on.
• Insufficient picture height or horizontal line intermittently. (service info for OTTOVERSAND -774713)
• Control unit turns off at times.
• Vertical collapse.
• RC does not function at combined SAT appliances. If SAT tuner is disconnected everything is OK.
• Flicker, moire and rolling horizontal drop out bars of other stations.
• No audio. via tuner (via SCART). (OTTOVERSAND - 774713 information)
• Shuts down (after a few minutes).
• Picture amplitude is too low at times.
• Vertical stripes on top. Picture appears intermittently.
• No start-up from standby. Standby LED lit .
• Only half picture.
• Picture has shifted downward.
• Only the Stand-by LED lights up, otherwise there is no function.
• Switches to protection mode (after start-up).
• Appliance runs for some time and then switches off. Operating display LED lights up. Moreover screen is white. Audio is present. (service info for OTTOVERSAND -774713)
• Green picture. Flyback lines.
• No horizontal deflection (intermittently). (774713 tips)
• R17 becomes high resistive in vertical deflection.
• No start-up.
• Interference lines on band I (mainly channel 4). (774713 OTTOVERSAND repair tip)
• Venetian blind effect in picture from top to picture centre.
• In the top part of the picture approx 10 bright flyback lines. Otherwise picture is dark. No sound and PSU begins to tick.
• Vertical foldover at top.
• No response to RC.
• Picture fades. It looks like a tuning problem.
• Picture fades, as if stations would go out of tuning. (OTTOVERSAND - 774713 information)
• Enter service mode.
• E/W fault and slight distortion.
• Digiboard fails immediately.
• Rolling picture, both via tuner and scart. OSD and TXT seem OK. (774713 tip from OTTOVERSAND)
• Picture has shifted approx 10cm downwards and folds down.
• No TV/AV switch over.
• Bright on the left edge of the picture. Screen is lit up unevenly. (774713 tips)
• Venetian blind effect on the left.
• Contrast is too strong. Cannot be adjusted.
• In indefinite time intervals drop-out from an individual programmes (variable). Not knock or heat sensitive.
• After Channel 44 no more programmes can be received.
• When volume is attempted to be increased, OSD menu displays headphone volume at first. Press red key to control loudspeaker volume. OSD menu shows both bars: headphone volume up and loudspeaker volume down, when volume key is pressed. Each time after start-up, headphone volume bar is active first.
• Background stripes run through from top towards bottom.
• Horizontal lines in picture with buzz from line output transformer. (OTTOVERSAND - 774713 information)
• Only vertical stripes are visible. (774713 OTTOVERSAND repair tip)
• One colour is missing, all colours present on the connector D on the picture tube board.
• No functions. LED blinks .
• Bright picture. Audio OK .
• Vertical line.
• Flyback lines.
• Bright picture. Flyback lines.
• Flyback lines. at top. Dark picture. at bottom.
• No synchronisation (after a few seconds).
• Adjusting the horizontal centering for the video input.
• Dark picture. No display. No vertical scanning.
• BUZ90 fails.
• Over current protection activated.
• Picture sometimes becomes brighter, sometimes darker or normal again. (service info for OTTOVERSAND -774713)
• Picture is faint, no change when adjusting contrast.
• No sound. Picture is black and perhaps white stripe at the top edge of the picture.
• Picture has folded over at the top.
• Dead.
• No red.
• Green streaking in videotext mode.
• No vertical scanning. R16, R17, D2 O/C. C10 has been replaced.
• Only low chirping noise in the PSU.
• Adjusting the control voltage.
• Picture height and picture width are too low. Picture is adjustable, however differs from the rated values for the picture tube.
• Moire in picture via tuner and AV.
• No sound. Scanning won't stop.
• Mains voltage at the antenna socket.