KV29F2D / OTTOVERSAND [TV]

• Shuts down (after warm-up). (part of circuit diagram displayed)
• No picture. Switches to standby, after a few seconds. LED blinks 2 times.
• RC unit. (KV29F2D tips)
• Flickering picture. Faulty TXT. (+ extract of circuit diagram)
• E/W fault. Pincushion distortion. (part of circuit diagram displayed) (OTTOVERSAND - KV29F2D information)
• Switches off to standby intermittently. LED flashes 2 times, and again 2 times after switch off.
• Horizontal interference in picture during first half hour. (+ extract of circuit diagram)
• LED flashes an error code 2 on power up. (part of circuit diagram displayed)
• Switches to protection mode.
• TXT and program number shifted 10cm to the right.
• Black screen. (+ extract of circuit diagram)
• Error codes. (with circuit diagram extract) (service info for OTTOVERSAND -KV29F2D)
• Extremely poor CRT purity. (+ extract of circuit diagram)
• No channel switch-over. Pictures appears after 5 seconds. (picture attached)
• Cycles on/off with relay click and blank raster. Starts up OK.
• Trips off just as brightness appears. LED's flashes twice. (picture attached)
• LED flashes. after start-up. (with circuit diagram extract)
• Searches for channels continuously. after start-up.
• Green picture. No picture. after a while.
• No sound in Canal Plus after starting up, whether it is from standby or not. (OTTOVERSAND - KV29F2D information)
• Picture is very high with E/W fault. Picture occasionally in black and white. (with circuit diagram extract)
• No synchronisation. in TXT. (part of circuit diagram displayed)
• VOL varies. Channels lost from memory and strange characters down one side of screen. (picture attached)
• Attempts to start up, EHV audible, switches to standby, LED flashing. Intermittent fault. (part of circuit diagram displayed)
• Service mode for geometry adjustments and colours.
• No vertical deflection.
• Information when LED flashing 2 times on power up.
• No start-up. LED lights-up for a short time.
• Vertical collapse. (with circuit diagram extract)
• Picture shifted vertically.
• No E/W correction. (+ extract of circuit diagram)
• Ragged picture. Too much green via tuner. Picture OK via AV.
• No picture. intermittently. (extract of circuit diagram attached)
• Slight line tearing. Switches off after 1 min. LED flashes 2 times. (+ extract of circuit diagram)
• Tuning drifts. after a while. (KV29F2D tips)
• On switch on EHT comes up and runs for 5 secs, then loss of line drive. (part of circuit diagram displayed)
• Partially blanked horizontally. (+ extract of circuit diagram)
• RC unit.
• Green screen and flyback after 5 minutes. (+ extract of circuit diagram)
• Excessive brightness. (extract of circuit diagram attached)
• At start up, EHT switches on and line driver control immediately drops out. LED does not blink. Picture and sound present via scart. Standby and channel switch over function via RC.
• Locks when hot. (extract of circuit diagram attached) (KV29F2D tip from OTTOVERSAND)
• Red picture. Flyback lines. (with circuit diagram extract)
• Noise bars in picture for approx. 15 mins, then OK. (with circuit diagram extract)
• AV connected locks on but no vision just audio.
• No picture.
• Dead, comes on momentarily with flyback. (extract of circuit diagram attached)
• RC unit.
• No RC functions (intermittently). (with circuit diagram extract)
• Relay trips. (with circuit diagram extract)
• Excessive horizontal size. Pincushion distortion. on sides. (part of circuit diagram displayed)
• Picture appears slowly. Audio OK . (OTTOVERSAND - KV29F2D information)
• No video via AV1.
• Comes on then switches to standby. Standby LED flashes twice. (part of circuit diagram displayed)
• Incomplete or messy OSD and menus. TXT OK. (with circuit diagram extract)
• No functions. (+ extract of circuit diagram)
• Blurred picture, right side is darker and there are flashing blank lettering. (picture attached)
• RC unit.
• No audio (after a few seconds). No channel storing.
• Switches to security. LED blinks 2 times. (KV29F2D tip from OTTOVERSAND)
• Bright raster. Dim picture. No LED lit. (+ extract of circuit diagram)
• No sound in Canal Plus after switch on, either from standby or other.
• No picture, no sound. No vertical deflection. Error code 2.
• Blank raster.
• No audio. No picture. Fault occurs intermittently. . (with circuit diagram extract)
• Vertical collapse. after start-up. (with circuit diagram extract)
• Low contrast. after a few seconds. Flyback lines. after a while. (+ extract of circuit diagram)
• Vertical bounce. (picture attached)
• Switches on, sound appears, appliance switches off shortly afterwards, LED flashes 2x, no picture.
• Dead. Screen doesn't become bright. LED pulsates 11times.
• Pincushion distortion, text disappears at left and right. (part of circuit diagram displayed)
• Switches off by itself. after start-up. (part of circuit diagram displayed)
• How to change norm to PAL I.
• E/W correction poor, along with poor picture, low brilliance and red bands either side of picture. (part of circuit diagram displayed)
• At switch on, sound and picture take about 5 minutes to appear then cut out regularly every 5 seconds.
• RC unit.
• Noise in picture. Horizontal size varies. when cold. (with circuit diagram extract)
• Whine noise from speakers when volume is turned on.
• Interference in picture. Crackling audio. (KV29F2D OTTOVERSAND repair tip)
• Speakers buzz.
• Poor sound on one channel.
• Switches to protection mode. after start-up.
• Switches to protection mode after a second. Front LED flickers 2 times. (KV29F2D OTTOVERSAND repair tip)
• Picture appears and disappears twice a sec. When it is a bright picture it happens more frequently. Dark picture OK. (extract of circuit diagram attached)
• Continuous buzz. Goes off if mute or min VOL is selected.
• RC unit.
• RC unit.
• Channels wiped out of memory.
• No display. No picture. (part of circuit diagram displayed)
• Poor geometry.
• RC unit.
• No audio. Headphones OK. (+ extract of circuit diagram)
• AV on the left upper side of display does not disappear in AV.
• Black or green picture with flyback lines.
• Shuts down (at start-up).
• No sound from cold for first 30 mins. (with circuit diagram extract)
• Green screen with flyback lines at switch on, then switches to standby after 10 secs.
• No audio from cold for 30 min.
• No audio.
• High pitched tone which alters with the volume and mutes when changing channels.
• Buzz from the right speaker in Nicam which varies with sound level. In MONO OK. (extract of circuit diagram attached)
• Information when LED flashes 19 times on power up. (OTTOVERSAND - KV29F2D information)
• Stripes in picture, especially in corners.
• Picture present then screen becomes black. Picture comes back for 10 mins.
• Blue picture.
• Pulses in and out of standby. RY600 clicks each time. (extract of circuit diagram attached)
• No TXT. Shuts down (intermittently). (extract of circuit diagram attached)
• Volume goes up and down randomly.
• No start-up (intermittently). (with circuit diagram extract)
• Green flyback lines at switch on then dead after ten secs. (part of circuit diagram displayed)
• Vertical lines. No colour (intermittently). Switches to protection mode (intermittently). (part of circuit diagram displayed)
• Serrated line near top of screen and one near the bottom. (+ extract of circuit diagram)
• RC unit.
• No audio.
• No picture. Audio OK . (with circuit diagram extract)
• Does not shut down. Red LED blinks. (extract of circuit diagram attached)
• Starts with reduced height then shuts down. 2 LED flashes.
• No audio output.
• Dark picture. Reduced horizontal size. (picture attached) (service info for OTTOVERSAND -KV29F2D)
• Picture switches off, then on and is discoloured (when cold).
• STEREO indication blinks in picture, then switches off.
• No start-up. after lightning strike. (picture attached)
• LED flash twice, pause then flash twice again. (extract of circuit diagram attached)
• Switches off by itself after about a minute.
• Black screen. Audio OK . (part of circuit diagram displayed)
• Does not got into standby mode completely; picture disappears but line continues to run. (+ extract of circuit diagram)
• No line drive when cold. After a minute the relay clicks on/off every 10 secs. The picture disappears periodically.
• Channels change at random. (extract of circuit diagram attached)
• TV fails after 48 hours then switches to safety at switch on. TV starts up by RC after many attempts but no picture and 1cm horizontal bar on bottom 1/3 of picture. Sound ok. Switches to safety once again. (picture attached)
• Intermittently switches off after bright green picture.
• Shuts down. intermittently. (KV29F2D OTTOVERSAND repair tip)
• No picture. after a while. Audio OK . (KV29F2D tips)
• Picture cuts off intermittently with poor brightness or red/green tinge. (service info for OTTOVERSAND -KV29F2D)
• No OSD. No TXT. (with circuit diagram extract)
• Dead. (picture attached)
• Thin lines and grey picture. (picture attached)
• How to change audio norm.
• Flashes or stripes when appliance is warm. Crackling. (OTTOVERSAND - KV29F2D information)
• No start-up. intermittently. Comes on for a short time.
• Distorted or loud crackling from audio. (extract of circuit diagram attached) (KV29F2D OTTOVERSAND repair tip)
• Value of C818. (KV29F2D tips)
• Tries to start-up for three times, then shuts down and LED flashes 15 or 23 times.
• Switches to protection mode (after start-up). (picture attached)
• Poor geometry settings. (part of circuit diagram displayed)
• Picture appears slowly. (picture attached)
• Degaussing incomplete. (extract of circuit diagram attached)
• No picture. No audio. after a while.
• Takes about 5 mins for picture to appear. Sometimes disappears for a few seconds then comes back on.
• Squealing noise.
• No audio.
• Dark picture. after a few seconds. Flyback lines. (with circuit diagram extract)
• No sound through phones or scart.
• TV switches off in standby then switches on again with a click and with LED flashing. Impossible to switch on TV afterwards. (with circuit diagram extract)
• Switches to protection mode after a few secs. LED flashes 2 times.
• How to re-initialise the NV ram.
• Blank screen (intermittently).
• Comes on for a short time. (extract of circuit diagram attached)
• Starts up for 2 seconds then stops. Relay pulsates 3 times then LED flickers in sequences of 24 times. Appliance functions normally when activating switch several times.
• Intermittent bright blue picture.
• No audio.
• General information.
• Wide mode image too small.
• RC unit.
• RC unit.
• Switches to standby. Comes back pressing a button, but goes off again after a while. (with circuit diagram extract)
• Vertical collapse or error code 2.
• Enter service mode.
• RC unit.
• Tripping. (+ extract of circuit diagram)
• Cannot adjust Usystem at 140V.
• Excessive height varies with picture content, after 2-3 minutes frame collapse followed by shut down and LED flashing error 2. (picture attached)
• E/W fault. Line output transistor fails repeatedly. after warm-up.
• Flashing picture. (picture attached)
• After a short operation time, whitish picture with spots. Appliance switches off and on. (picture attached)
• Intermittently channel hops.
• Horizontal tearing (after warm-up). (part of circuit diagram displayed) (service info for OTTOVERSAND -KV29F2D)
• Switches to standby.
• No channel change unless menu is pressed first. (extract of circuit diagram attached)
• No sound from cold. (+ extract of circuit diagram)
• No start-up. Clicking noise. Burning smell.
• LED flashing 19 times on power up. (extract of circuit diagram attached)
• Does not switch to standby. (picture attached)
• Blue screen. at start-up. Trips.
• Inmediate green pincushion effect followed by appliance stopping. The only way to make it work is switching it off with main switch and switching it on again. Still, the fault reappears later on.
• Characters on left side of screen.
• TV operates correctly on normal channels. On CANAL +, colour disappears after a sec.
• No audio. No picture. No TXT. No OSD. No vertical deflection ocassionally. No error code.
• No picture unless contrast and brightness turned fully up. (with circuit diagram extract) (KV29F2D tip from OTTOVERSAND)
• Blank screen (intermittently). Audio OK . (part of circuit diagram displayed)
• No picture (intermittently). Audio OK . (picture attached)
• EHT comes up briefly then nothing. No error code. (picture attached)
• Picture comes and goes on a regular basis, both via antenna and via scart socket. Sound is always ok. Green spot for a few seconds after switching TV off.
• Switches to protection mode. in TXT.
• RC unit.
• Intermittently switches off when switched on. Visible arcing interference on screen when appliance does function. (picture attached)
• No forward/back zoom in widescreen zoom.
• When turning on, it seems that it starts up, but the red standby LED starts flashing. (+ extract of circuit diagram)
• Sizzling in picture, mostly in TXT.
• Picture too big.
• No sound, picture or LEDs. (extract of circuit diagram attached)
• LED blinks twice after storm. (KV29F2D OTTOVERSAND repair tip)
• One colour missing. intermittently (after a few minutes).
• PSU blocked. Squeaking.
• Arcing noise and flashing lines on screen. (with circuit diagram extract)
• Picture too big and E/W defect. Switches off after a while and goes back on with black screen. (picture attached)
• Dead. LED blinks .
• Switches on, picture only appears for approx. 1 sec after voltage built-up. Switches off and flashes twice every sec.
• Red frame with flyback lines.
• Overbright, nearly negative picture.
• Floating picture. Raster OK. Picture OK when connecting TV to SCART socket. Audio OK. (OTTOVERSAND - KV29F2D information)
• RC unit.
• Switches sporadically to safety mode, LED blinks twice. Slight line tearing and/or picture amplitude changes visible. (extract of circuit diagram attached)
• No functions. OSD volume bar always on screen.
• RC unit.
• Stuck in standby. (with circuit diagram extract)
• 5cm line at the top edge.
• Blue screen. Flyback lines. Switches off by itself.