KVE2561D / OTTOVERSAND [TV]

• Wow in audio. (extract of circuit diagram attached)
• Blank raster with flyback lines. E/W incorrect and various LEDs flash. (picture attached)
• Horizontal lines. in the centre.
• Torn picture. via SCART. (KVE2561D tip from OTTOVERSAND)
• NICAM sound distortion at low audio level. (extract of circuit diagram attached)
• EHT starts up briefly for several secs then switches off. A and B LED blink alternately.
• Use of I²C Jig (Psion organiser).
• Incorrect colour, only red and blue picture. TXT and OSD ok. Picture is darker on the left.
• E/W fault. after warm-up. Knock sensitive.
• Horizontal lines on top. No picture content. Switches off after approx 10 secs. Knock sensitive. (with circuit diagram extract)
• No picture.
• Violet band on left side of screen. (part of circuit diagram displayed)
• No picture. intermittently. Switches to standby. Knock sensitive. (+ extract of circuit diagram)
• Black picture. STEREO lamps flash A once, B three times. (part of circuit diagram displayed)
• No start-up. LED blinks . (extract of circuit diagram attached)
• Intermittently stored programs are interchanged or disappear.
• North-south fault. (+ extract of circuit diagram)
• No start-up. (picture attached)
• No audio and picture intermittently or switches to standby. (picture attached) (service info for OTTOVERSAND -KVE2561D)
• Picture has line, flashes and becomes smaller. (extract of circuit diagram attached)
• CRT replacement from 29" GX to 29" GX2.
• Incomplete videogame picture. (extract of circuit diagram attached)
• Vertical collapse.
• Picture and sound appear after 2 minutes when switching over channels. (extract of circuit diagram attached)
• The sound from the tuner signal is audible in the AV1, AV2 and AV3 mode. (part of circuit diagram displayed)
• Distorted subtitle characters, especially when scenes with bright background are transmitted. (picture attached)
• No audio. No picture. when cold. (part of circuit diagram displayed)
• No start-up. when cold. (with circuit diagram extract)
• Horizontal stripe is displayed for short while, then switches off. (with circuit diagram extract)
• Flashing picture. intermittently. (+ extract of circuit diagram)
• Colour flashing. Colour level flashing in photo mode. (+ extract of circuit diagram)
• Flyback lines.
• RC unit.
• Software programming problem. A certain sequence may give a frozen picture of one channel (B) while the sound from a second channel (A) is heard. (with circuit diagram extract)
• Picture appears after approx 2 mins, then drops out. Sound OK. (extract of circuit diagram attached)
• Forced start up from protection.
• No start up. A-B LEDs flash alternatively. (picture attached)
• No functions. (+ extract of circuit diagram)
• Goes to protective switching. LED (B) flashes 13x.
• No colour via tuner.
• Band I fails, tuner is knock sensitive.
• Dead or intermittently dead. (part of circuit diagram displayed) (OTTOVERSAND - KVE2561D information)
• RC unit.
• No picture when cold. Then picture is weak with green lines.
• No vertical deflection. (with circuit diagram extract) (KVE2561D OTTOVERSAND repair tip)
• PSU does not start up. Attempts to start up and then stops oscillating. (picture attached)
• RC unit.
• N/S distortion faulty. Dents on the top and at the bottom of the picture edge (with circuit diagram extract) (OTTOVERSAND - KVE2561D information)
• White horizontal line with VCR.
• Horizontal line. (OTTOVERSAND - KVE2561D information)
• No PIP. (picture attached) (KVE2561D tips)
• Another power problem. (picture attached)
• RF reception fails, AV OK. (part of circuit diagram displayed)
• Picture runs slowly through from bottom towards top. Picture is shifted to the left (black bar on the right side).
• Dead. (+ extract of circuit diagram)
• Wavy picture. Horizontal lines shaking. Unstable vertical.. (with circuit diagram extract)
• No or distorted picture. (+ extract of circuit diagram)
• No focus. intermittently. (part of circuit diagram displayed) (KVE2561D OTTOVERSAND repair tip)
• No menu and no OSD with new megatext IC, set switches into standby. (+ extract of circuit diagram)
• Channels interchange individually. (extract of circuit diagram attached)
• Flickering picture. Distorted picture. (with circuit diagram extract)
• No reception. only on certain channels.
• When receiving a channel on a collective installation fitted with satellite receiver, picture remains unstable in M6 channel or Canal Plus. Picture OK in PAL channels. OK with other TVs or VCRs. (+ extract of circuit diagram)
• Excessive green. in PIP. (with circuit diagram extract)
• Vertical linearity error in upper picture area. Test lines visible.
• Lines in picture. on upper half screen. (extract of circuit diagram attached) (service info for OTTOVERSAND -KVE2561D)
• Faulty on-screen display operation. When watching TV, random osd characters may appear on the screen for a few seconds. (space invaders effect). (+ extract of circuit diagram)
• No start-up. intermittently. (extract of circuit diagram attached)
• Poor field scan; jumbled lines on bottom half of screen. (+ extract of circuit diagram)
• Chassis demounting.
• Cycles on/off. Bright flashing raster with lines.
• Runs approx. for 2-3 min. with normal picture and sound. Stereo LEDs are flashing: A once, B three times, alternately. Switches then to standby and can be started up immediately again.
• Switches to standby after a few secs. Comes on without E/W or picture.
• Dead, Power supply hiccups. (part of circuit diagram displayed)
• 29" GX picture tube information.
• Goes immediately to protective switching after switch on. Stereo LED flash alternately 1 and 7.
• Switches to protection mode. (service info for OTTOVERSAND -KVE2561D)
• Switches to standby (after start-up). (with circuit diagram extract)
• Standby LED does not light. Other functions OK . (with circuit diagram extract)
• No picture, no sound. LED A and LED B blink rhythmically alternately. (+ extract of circuit diagram)
• Start attempt. Switches off. At the second start attempt horizontal stripes.Switches off. Then LED blinks 13 times. (picture attached)
• Foldover at top of picture and smear effect. (part of circuit diagram displayed)
• Faulty picture, chroma noise, incorrect colour phase. (with circuit diagram extract) (OTTOVERSAND - KVE2561D information)
• Image slightly shifted down and extended at the bottom. (extract of circuit diagram attached)
• No or intermittent synchronisation. (KVE2561D tip from OTTOVERSAND)
• Intermittently no power on AC. Especially common when starting from cold. (picture attached)
• 3cm wide stripe of non-coloured picture on the right side of the screen.
• PSU output voltages are too low. (with circuit diagram extract)
• No start-up. after warm-up. (+ extract of circuit diagram)
• Faulty strobe function. The TV set may enter the strobe mode when using a remote commander for other equipment. (with circuit diagram extract)
• In text mode, a horizontal bar may be visible which is moving slowly over the screen in vertical direction. (picture attached)
• Lines in picture. in the centre (intermittently). (extract of circuit diagram attached)
• Picture jitter with certain inputs. Poor sync with VCR input, or after changing program. (extract of circuit diagram attached)
• Dead. How to carry out PSU solo test.
• Error code 13 after switch on.
• No start up. LED flashes 3 times.
• North/south correction defective.
• Faulty picture in picture/digital picture function. Greenish pip picture. (part of circuit diagram displayed)
• Switches on briefly, switches off after a few seconds. No LED display during this time. Tries to start up again and then switches off completely.
• Parental lock problem. (+ extract of circuit diagram)
• Picture too small. Switches off by itself. intermittently. (part of circuit diagram displayed)
• No vertical deflection. A LED flashes 1, B LED 13. (+ extract of circuit diagram)
• No synchronisation. (KVE2561D tips)
• Enter service mode.
• High voltage builds up briefly, and switches off then after approx. 5 sec. (part of circuit diagram displayed)
• Intermittent pop noise from speakers. Pop noise resembling static discharge is audible. The noise occurs every 3 or 8 minutes. Its loudness depends on the volume setting.
• Screen blank. Sound via scart OK. No screen insertion. Picture too small, screen slightly bright. (part of circuit diagram displayed)
• EHT cuts out before set warms up. Protect mode in operation.
• Wavy picture. Vertical shaking. Fault occurs intermittently. . (picture attached)
• Cyclic colour cast and flyback lines come and go with soft transistion.
• Picture is bent on top and bottom. (part of circuit diagram displayed)
• Poor synchronisation. in PB. (+ extract of circuit diagram)
• Colours fade away.
• No picture. No OSD. Audio OK .
• No or intermittent start-up. Erratic start-up. (picture attached)
• After selecting one of the A/V inputs there is no On-screen display (OSD).
• No horizontal sync in zoom mode. (with circuit diagram extract)
• Pincushion distortion. on sides.
• Value of D682.
• No colour. Left half picture is B/W and the right half picture is magenta. TXT OK.
• Very low supply line voltages. (+ extract of circuit diagram)
• No horizontal synchronisation.
• Some programme presets are linked to one another.
• Switches on, no picture, no sound, no LED, switches off after 4 secs. Process repaes itself.
• Switches to protection mode. after a few seconds. (with circuit diagram extract) (KVE2561D tip from OTTOVERSAND)
• No picture. Audio OK .
• Subtitles are distorted, especially on W. (part of circuit diagram displayed)
• After short operation, approx 2-5 mins., coloured lines in picture (flashes). (with circuit diagram extract)
• B LED blinks 7 times and A LED once. (+ extract of circuit diagram)
• Sometimes black screen and standby LED flashing. Occasionally stripes on screen (horizontal lines or bars). (picture attached)
• EHT rustle then goes dead.
• Switches automatically to standby after 10 mins. In the moment of failure short collapse of vertical deflection. (extract of circuit diagram attached)
• Two pictures are played back on top of each other. (with circuit diagram extract)
• Dark picture. Colour fault. Display OK . (picture attached)
• No colour in PB.
• Picture is intermittently vertically double. E/W collapsed.
• No colour in the VTR playback mode (PAL mode), especially with second generation copies. (with circuit diagram extract)
• Pincushion distortion.
• Top 16:9 bar is distorted in the middle of the picture towards the bottom. (extract of circuit diagram attached)
• Switches over to strobe function, if a RC of another audio/video appliance eg. VTR or CDI RC is used. (part of circuit diagram displayed)
• Dead. Short start up of HS hearable. On STEREO - LEDs no fault message displayed. (with circuit diagram extract)
• Error codes. (picture attached)
• Vertikal stripe. Dark picture or blinking of standby diodes. (part of circuit diagram displayed)
• No function after switch on, picture flashes, maybe fault is not present at operation via AV. (with circuit diagram extract)
• Switches off. LED B flashes 13 times. (picture attached)
• No picture, faint flyback lines, sound OK, LED flashes 5 times, then swiches off.