MSS100 / PACE [Sat /TV reception module]

• How to reset microprocessor U700.
• No decoder and channel idents jumps or flickers on channel change.
• Switches to standby (intermittently).
• When white level of OSG is too high, sound buzzes.
• 'LNB short circuit' on OSD.
• To set video level.
• Intermittently sound disappears when changing channels.
• No signal. (PACE - MSS100 information)
• UHF output has slight horizontal lines when using RC.
• No picture.
• Sound interference on several channels, especially by subcarriers with narrow band .
• Poor RF.
• Grainy, colourless terrestrial TV loop-through pictures.
• No E-E after stormy weather.
• Intermittently no RC function.
• Intermittent decoding of Video-Crypt programmes.
• Low gain E-E. No UHF satellite pictures.
• No 12V.
• Automatically reverts to standby, occasionally comes on again.
• Intermittent or permanent blue screen with no signal.
• Channel names float to left; No "please insert card" message.
• Distorted audio.
• No display.
• Dead. (MSS100 tips)
• Intermittent audio. (MSS100 tips)
• Remote control.
• No decoder messages after 30 mins.
• Blue screen with "No signal" message displayed.
• Wavy coloured lines running down picture.
• No picture (intermittently).
• Blue picture.
• No picture or sound, menus OK.
• "No signal" message displayed. Audio OK.
• Slight patterning.
• Intermittent blue screen with no signal.
• "Card invalid" message displayed.
• To tighten power supply output tolerance.
• Blue screen.
• No decoder messages or transparent menus.
• Dead, power supply trips.
• Low audio. (PACE - MSS100 information)
• No display (intermittently). (MSS100 tip from PACE)
• Intermittent "No signal" message.
• No functions. All front panel LEDs lit. (MSS100 PACE repair tip)
• Intermittent blue screen and no signal. (service info for PACE -MSS100)
• Blue screen no picture
• Non functioning receiver-decoder after rapid on/off power cuts.
• No RC, RF or LEDs.
• Dead after thunder storm. (PACE - MSS100 information)
• Pink screen, "LNB Short Circuit" displayed.
• No picture or sound, menus OK.
• Carry out general reset.
• No LNB voltage.