SS7000X / PACE [Sat /TV reception module]

• Will not switch to vertical polarity.
• Impossible to store frequencies although frequency adjustment ok. (SS7000X PACE repair tip)
• Dead. Appliance remains in standby position (LED flashes).
• No functions, all LEDs flash.
• Appliance hums.
• No start-up.
• Spurious accompanying sound, e.g. EUROSPORT.
• BUT11 in PSU blows.
• No or faulty graphics.
• Cuts out when hot.
• Poor picture, excessive spikes in the picture.
• New programming.
• No response to remote control signals.
• No polarizer switch over possible. (SS7000X tip from PACE)
• Receiver cannot be adjusted.
• Installation instructions TE-4.
• Appliance cannot be switched on. Standby LED lights up continually.
• No horizontal level.
• Noise in picture.
• Dead.
• 6.5MHz audio carrier fails.
• Stuck in standby.
• Very distorted picture.
• Venetian blind effect. Poor picture with horizontal lines.
• Intermittently whistling at start-up. Horizontal lines in picture when cold. Intermittently no V-level change-over.
• Increase of switching voltage.
• Noisy transformer.
• No picture, On LED lights up. (SS7000X tip from PACE)
• Intermittent LNB voltage.
• No function or the receiver loses the station memory.
• No picture, screen is black.
• No LNC supply.
• Horizontal stripes in picture on all channels and on both polarisation levels.
• Stand by is defective. (service info for PACE -SS7000X)
• No sound or picture in SAT reception.
• General reset.
• No sound. Sound is present only on channels TELECOM B, TELECOM A, MCM and Canal Plus.
• Channels cannot be switched over. (service info for PACE -SS7000X)
• No screen OSD, picture is normally present.
• Venetian blind effect at start up.
• No test signal on TV set (only visible via aerial cable).
• No function, all LEDs light on SAT tuner front side. Selection via RC ok.
• SAT receiver cannot be adjusted.
• No audio.
• Functions for approx 1 hour and then switches automatically off and then on again.
• Dark picture, without content. No sound.
• Impossible to switch on or channels run through. On LED does not light up while RC is being used.
• Demodulator functions for a fortnight to a month then loses stations. Necessary to reprogramme and so on.
• Horizontal stripes in picture.
• No picture.
• Modification SS6001 to 14/18V switch over.
• Bold lines in the picture which looks as if line frequency has been wrongly adjusted.
• Will not switch to horizontal polarity.
• Sound only in Stereo mode.
• No picture or sound in SAT reception.