ENTRADA15 / PEACOCK [15" monitors]

• Vertical lines in the lower quarter. (ENTRADA15 tips)
• Storage of the geometry values is defective.
• Dead. Monitor ticks.
• No picture content after turning up the screen grid controls.
• Picture flickers. (brightness and contrast can be regulated).
• Extremely wide picture. Poor E/W and control.
• Do not replace CS EPROM with ATMEL version.
• No trap adjustment.
• Picture is too dark, flyback lines.
• No OSD. Dark picture.
• Striations and stripes in the picture. (ENTRADA15 tip from PEACOCK)
• No picture, too high grid 1 voltage, approx 150V.
• Factory adjustment after changing memory IC. (PEACOCK - ENTRADA15 information)
• Hardly any picture content. Only slightly brighter background. Sync tips away when pressing an arbitrary key and picture background gets darker. (ENTRADA15 PEACOCK repair tip)
• Dead. Smoke from the PSU.
• No high voltage, no signal at pin 8 of IC401.
• Vertical jitter.
• Replacement transistor for the processor power supply.
• Switches off after run length. Relay clicks.
• Picture is too bright. G1 cannot be controlled.
• Red picture with flyback lines. (ENTRADA15 PEACOCK repair tip)
• Picture width is insufficient.
• White line running vertically across screen.
• OSD cannot be called up after run length.
• No green.
• No degaussing function.
• Value of R472 on pin 7 of the FBT.
• Dead. PSU ticks 4 to 5 times. (ENTRADA15 PEACOCK repair tip)
• Vertical picture jitter with OSD operation.
• Occasionally no picture or picture flickers.
• Picture is blue with flyback lines.
• Picture is compressed vertically and lower picture half is folded. (service info for PEACOCK -ENTRADA15)
• No picture content after turning up screen grid control.
• Line tearing - dependent on the picture width.
• Switches off. OSD active.
• Brak OSD,ciemny obraz.Przy w³aczaniu OSD monitor wy³¹cza siê i zaraz w³acza.
• Vertical, coloured lines in the picture.
• Picture is green. Cut-Off is defective.
• Power supply S/C.
• Dead. LED flashes.
• Does not start from Power-Save.
• Green picture with flyback lines.
• Picture has too much colour. No cut off control.
• Adjusting the factory adjustments after replacing EEPROM.
• Excessive brightness.
• No vertical deflection.
• Horizontal stripes.
• Picture compressed vertically in the lower third.
• Picture jiggles in horizontal amplitude.
• Goes into power save mode. (ENTRADA15 PEACOCK repair tip)
• Reduced vertical at bottom.
• Picture is too wide, E/W defective, no control.
• 0V at G1.
• Picture is too small horizontally. Control ok. Widens after operating for some time.
• Specifications.
• Triple picture.
• Vertical amplitude changes with the brightness control.
• No start-up.
• No storage with different resolutions eg. 800x600.
• Picture is too narrow. No picture width control.
• Picture is monochrome, one colour is predominant. (PEACOCK - ENTRADA15 information)
• Picture slowly gets dark and begins to flicker.
• No vertical synchronisation.
• No picture.
• No picture content. OSD is defective or does not synchronise.
• Picture flickers in the vertical amplitude - fails completely until it becomes a vertical line.
• Flickering picture.
• No OSD. Picture blanking when calling up OSD.
• Brightness cannot be controlled.
• No function. PSU ticks.
• Horizontal centering can hardly be regulated.
• Line tearing and flickering.
• No red.
• No blue.