PLSC28WNS ARD000 / PLAYSONIC [TV (Standard)]

• Appliance has loss of memory. Picture is visible only for approx. 1 sec. after changing the programme. OK via SCART, but visible geometry faults.
• LED flickers. Buzzing.
• No blue. (PLAYSONIC - PLSC28WNS information)
• Reduced vertical size at top.
• No UHF channels.
• No start-up. Tripping.
• Switches on in cable 1 after mains disconnection. (PLSC28WNS PLAYSONIC repair tip)
• Does not change channels. when cold.
• Intermittent purity error.
• Horizontal output stage does not function.
• Appliance starts up in Standby when switched on via ON/OFF switch. OK via RC or keyboard.
• No picture. Audio OK . (PLSC28WNS tips)
• Half a picture (bottom), picture content OK. Only a few thin red, green and blue horizontal lines in the top half.
• Enter service mode.
• No vertical deflection.
• Line output transistor (2SD2499) S/C.
• Vertical fault.
• Squealing noise. after a while.
• Dead. LED lit. .
• Stuck in standby.
• Sound twitters on when switched to standby.
• No start up, relay rattles.
• Dead.
• At start up, EHT pulsates and noise in loudspeaker. No sound and picture.
• Coloured lines. at top.
• Line output transistor fails repeatedly.
• Coloured, thin lines at the top of the picture.
• Reduced horizontal size, at 3-4 inches wide.
• Check line output transistor and line output transformer for S/C.
• Faulty OSD. after a few minutes.
• Trips. (PLSC28WNS tip from PLAYSONIC)
• No operation intermittently with RC and front controls, therefore, no start up.
• Reduced horizontal size. No start-up, just a fast ticking noise intermittently.
• Green picture. Flyback lines.
• White line at top or black screen. (PLSC28WNS tips)
• No picture. intermittently. Audio OK .
• No E/W correction. (PLAYSONIC - PLSC28WNS information)
• Cuts out when tapping ZD602 (TL431CLP).
• T601, D626 and D627 in PSU S/C.
• Switches to standby. intermittently.
• No line drive.
• Brightness increases after a few minutes. Blank raster after a while with flyback lines. Shuts down.
• Poor screen control.
• LED blinks very fast after switch on, no other function.
• Tripping.
• Demagnetising relais rattles intermittently in standby.
• Black boxes in picture.
• Squealing noise. Shuts down.
• PSU pulsates.
• Brief flash at switch on, runs then ok.
• No audio.
• Intermittently no picture when switching from one band to another.
• No function, only red LED lit after switch on with PSU switch.