F2819 / PROLINE [TV]

• Clicking noise.
• Volume display advances only approx. three quarters of its travel.
• Vertical foldover.
• Line output transformer arcing.
• Black screen. No audio. via tuner.
• Vertical bar. on the left. (F2819 tip from PROLINE)
• Chopper FET S/C.
• Reduced horizontal size. Horizontal foldover.
• Picture dark or bright with flyback lines when turning up SG control. Sound ok. (service info for PROLINE -F2819)
• Audio does not increase above half level.
• High frequency whistle.
• Switches off by itself. (F2819 PROLINE repair tip)
• Zooming from 4:3 mode to 16:9 mode depending on picture content. TXT OK.
• Dark picture.
• Stuck in standby. Clicking noise.
• Stuck in standby. intermittently. (F2819 tips)
• No RC functions. after a while.
• No picture. Audio OK. Flaring picture appears if G2 adjusted.
• No sound, just a crackle and buzz.
• Picture size varies with picture content.
• Shuts down (intermittently).
• Reduced horizontal size. E/W fault.
• Excessive horizontal size.
• Switches to standby.
• Tripping.
• Unable to alter sound. No sound menu available.
• Switches to standby (intermittently).
• Unable to enter service mode.
• Picture yellow with tearing on left side of the screen.
• Switches to protection mode. intermittently (after warm-up).
• Switches to standby. after start-up.
• Pincushion distortion. Excessive horizontal size.
• Enter service mode.
• After un difficult start up, appliance sizzles and switches back to standby.
• Erratic RC functions.
• No picture. Raster OK .
• E/W fault.
• Takes time raster to appear. No OSD. No tuning. No blue in picture with geometry errors via scart.
• Switches to standby (after a while).
• Unable to adjust audio volume. Volume bar stuck.
• No picture. Audio OK .
• White screen. Audio OK .
• No start-up.
• Retrace lines. White screen.
• Line output transformer fails.
• E/W fault. Bowed edges.
• Reduced horizontal size. No audio. No volume bar.
• Audio volume stuck. No tuning menu.
• No E/W correction.
• Sound is stuck at a very low level. Loss of horizontal synchronisation when switching over channels.
• No functions. Switches to protection mode.
• No start-up from standby with RC. (F2819 tips)
• Black screen. on the left.
• Line output transistor is constantly S/C.
• Dim picture then a blank screen.
• Wavy picture on verticals.
• Stuck in standby. If attempting to start with RC, PSU whistles and goes back to standby.
• TR16 (S2055AF) goes s/c after replacement.
• Dead.
• No sound and no picture via tuner. Sound OK via SCART.
• Dead. Standby LED flashes .
• No picture. Flyback lines.
• Unable to turn sound up above level 4.
• No synchronisation. when changing channels. OSD and TXT OK .
• No front control operation. When using RC channel change, but after a minute channel change by itself.
• Picture size varies.
• Dark picture. Low contrast.
• No line and frame synchronisation with moiré at channel switch-over.
• Black screen. Audio OK .