TV633000 STASSFURT / RFT [TV 63 (59) cm picture]

• Excessive horizontal size.
• Picture is dented to the inside and too wide.
• E/W dented inwards.
• Picture has intermittently jagged edges horizontally.
• No OSD. No TXT.
• No sound from LS, just loud crack at switch over, headphones work.
• Black picture. Symbols in background. Sound available.
• Display (LED) does not flash.
• No picture. (service info for RFT -TV633000)
• No RC function after start-up, only after restart.
• No picture. Raster OK .
• Dark picture. Lines in picture. in the centre.
• Programm digits are displayed twice, e.g. 4.4 when on 4th place.
• Flickering picture. after a few minutes.
• Picture content only partially visible. Picture seems to be coded. (TV633000 RFT repair tip)
• No picture. Audio OK .
• Noise in picture. Flyback lines.
• Incorrect colours in the menu displays (dark brown instead of grey). Picture ok.
• No start-up. Distorted display.
• Model release/pricing information.
• Vertical IC VI 6701 (TDA8350) defective.
• Black and white dots in the picture (interference).
• At switch on with power switch intermittently no function, or absurd indications in display.
• Switches off after several mins. LED and program display available.
• Only colours are recognizable but no picture content. Several shadowed areas vertically on picture. (TV633000 tip from RFT)
• Jagged edges in picture. (TV633000 RFT repair tip)
• Bottom half is black, top half is ok but slight E/W distortion.
• Intermittently does not start. Three vertical lines in display.
• Dark screen. No picture. intermittently.
• No picture and no sound. Starts up, display ok and E1 flickers in the display.
• Intermittent noise from loudspeaker in Standby Mode.
• Large black bars on the picture intermittently. Sometimes both halves of picture are black and various picture faults are present.
• Enter service mode.
• No vertical deflection. Horizontal bright lines. Sound present. Switch over possible.
• Lines missing at lower edge, flyback lines visible only. OSD and TXT bounce up and down.
• E/W fault. intermittently. Knock sensitive.
• No picture but has flyback lines in upper section of screen.
• Switches automatically to AV2.
• Picture is folded down approx. 15cm on bottom, the rest of picture is black. After approx. 15 mins. of operation picture is fully available and it is too large.
• Green picture. Flyback lines. Fault occurs intermittently. . Knock sensitive.
• Dead.
• Switches off by itself. Erratic start-up.
• Vertical deflection error.
• Afterglow spot after switch off
• Dark screen.
• Starts up, programme display present.
• Error codes.
• Only half picture available. No horizontal picture control.
• No start-up.
• No picture content only colours, shadows in picture.
• Vertical IC fails.
• Picture jitters as brightness is increased.
• Moire on all channels, even in SAT.