ICC5121 / SABA [TV (chassis)]

• Protective circuit is activated.
• Protective circuit malfunction.
• Slight picture jitter in vertical sync.
• RC part number.
• Oscillation in band 1 and 3.
• Shuts down (intermittently).
• No picture after switching to TXT.
• Black picture, four lines in centre.
• PSU does not start up, only remains in standby.
• E/W fault. Unable to adjust picture amplitude.
• Occasionally no start up. Protective circuit sets in. No soft start.
• Difficult to start up. RC has to be pressed for a long time.
• Spare part no. info: Power supply repair kit.
• The screen is dark but the sound is present. Red, green and blue horizontal lines appear in the picture.
• Stripes in the bottom part of the picture.
• Double picture in top quarter of the screen. Middle of the picture is darker.
• Thin horizontal stripes on the picture.
• Picture interference at the top and bottom, which changes with the line amplitude.
• Sporadic memory loss.
• Dark picture. No picture content.
• Does not store programmes.
• Picture is dark and no picture content. No display, only standby dot. (ICC5121 SABA repair tip)
• No start-up.
• PSU does not oscillate correctly.
• Mains switch does not lock on.
• Picture distorted on top. Lines have shifted. Crackle in appliance.
• How to disable key code.
• No STEREO reception on channel 60. (SABA - ICC5121 information)
• Picture is too dark - coloured edges on the right.
• No switch on from main switch or via RC.
• Dead. Standby LED is blinking.
• Switches off after operating for a short time. The display is lit up. Picture and sound also correct. After switching on everything goes ok again.
• Bright horizontal stripe at the bottom of the picture.
• 6 to 7 horizontal coloured lines in picture.
• No vertical deflection.
• Transistor TP24 (S2000A) fails after start-up.
• Vertical position does not go high enough. (ICC5121 SABA repair tip)
• Vertical lines slightly oscillates on the top. No improvements when turning vertical control PF02.
• Loud noises from speaker (at switch-off).
• Cannot be switched off with RC. Display shows standby, but picture remains black and white.
• Black raster with red, green and blue horizontal lines. Sound ok.
• No audio.
• Line in picture approx 10cm from top. Other functions OK.
• Colour cuts out occasionally.
• Vertical lines are jagged.
• Intermittent large noise bands. Picture OK via SCART socket.
• Picture is too wide and the appliance switches off.
• Only rainbow effect (picture foldover).
• Noisy and distorted sound. (ICC5121 tips)
• Rainbow effect on lower picture edge, otherwise no picture.
• Distorted vertical lines only on the top.
• Flickering on channel 60 and on special channels.
• Rotating vertical stripes on the whole screen.