CW533CWG / SAMSUNG [TV]

• Dead. LED blinks green and orange.
• No picture. after start-up. Audio OK .
• No picture, only snow. AV OK .
• No vertical deflection.
• Enable Hotel mode. Disable hotel mode.
• Enter service mode.
• No sync on picture. Flag effect. No sound. Fault only occurs in HF.
• Rolling lines downward on screen. Noise from PSU.
• Vertical fault. Blurry picture.
• Intermittently 5A main fuse blown.
• Brightness varies. Greyscale problems.
• One colour missing. Brightness varies.
• Black screen and no picture. Sound ok. Flyback lines and negative picture when increasing screen control.
• No functions. Red LED blinks.
• Line tearing.
• No audio or picture. Sound OK and snowy picture via scart.
• Dead.
• No start-up. Protection mode activated.
• No picture. Audio OK . (CW533CWG tips)
• Focus problems. when cold. (service info for SAMSUNG -CW533CWG)
• Picture jitters. in TXT.
• Dim picture.
• No RC or front panel functions.
• No picture.
• Bent stripes on the left.
• No reception in SECAM. OK in PAL.
• No vertical deflection when turning up SG control. Sound present.
• Picture goes intermittently dark, sound ok.
• Dead. Standby LED flashes .
• Grey screen. Retrace lines.
• Line output transistor fails repeatedly. (CW533CWG SAMSUNG repair tip)
• Horizontal collapse.
• Dark picture. Audio OK .
• No RC functions.
• Coloured flyback lines at the top edge. Fault is visible within the first 10 mins.
• E/W fault.
• Red colour parts only visible as red streaks in the picture.
• Horizontal output transistor fails repeatedly.
• Stuck in standby. intermittently. (CW533CWG SAMSUNG repair tip)
• No start-up. Green LED appears, then goes back to red. (CW533CWG SAMSUNG repair tip)
• Excessive horizontal size.
• LED flashes.
• SMSP output voltages too high and unstable.
• No green.
• No switch on. LED flashes 5 times (red).
• Dim picture. No focus. Flyback lines.
• No picture. CRT does not heat up.
• No start-up. LED is green. No line drive.
• Green picture. Flyback lines.
• Approx. 3 cm wide vertical bars at right picture edge.
• LED flashing.
• Picture colour changing to green or blue, when adjusting brightness. Intermittently clicking noise frome CRT.
• Error in E/W pincushion booster.
• Distorted picture. after warm-up. (SAMSUNG - CW533CWG information)
• Hum/oscillation noise from appliance. (CW533CWG tip from SAMSUNG)
• No start up or relay chatters constantly or starts up intermittently with washed out and distorted picture.
• E/W fault. intermittently.
• No picture. Blank raster with blue-pink bars flashing.
• Green LED switches off at start-up, but line stage does not start.
• Superimposed vertical lines on picture in AV1, AV2 modes and RCA and S-Video front inputs.
• Reduced picture width, V shaped, with loss of convergence in upper and lower part.
• Picture bluish-mauve with flyback lines.
• Dark picture.
• No picture in AV2.
• HV builds up briefly, breaks down again, then red LED blinks 5 times.
• Smearing in picture.
• Black stripe at the bottom.
• Intermittently switches off. No field scan; when turning G2, the horizontal line is a wave.
• Vertical IC (LA7845) burns.
• No picture. No audio. (CW533CWG tip from SAMSUNG)
• No start-up. LED blinks .
• No functions. No LED lit.
• No picture (intermittently). Audio OK .
• Snowy picture on some channels ( digitalised ). (service info for SAMSUNG -CW533CWG)
• E/W fault. Reduced vertical size.
• Brightness varies. Intermittent fizzing sound.
• Dark picture with red trail.