 |
CX5944W3XEG / SAMSUNG [TV]
The EURAS repair tip database for professional technicians and service engineers
supplies the following faults for CX5944W3XEG / SAMSUNG.
List of fault symptoms:
- Enter service mode.
- No vertical deflection. at top.
- Stuck in standby.
- E/W fault.
- Lines in picture. at top.
- Only green LED.
- Factory mode adjustment. (CX5944W3XEG tip from SAMSUNG)
- Screen grid voltage adjustment.
- Horizontal output transistor fails after a short while. (service info for SAMSUNG -CX5944W3XEG)
- SERVICE mode adjustment.
- Poor audio.
- No picture and no functions possible via scart 1 output.
- No picture. No display.
- Tripping.
- Switches to standby. after start-up. (SAMSUNG - CX5944W3XEG information)
- Geometry adjustment.
- Cuts out immediately after switching on.
- Picture in the lower third of the screen is compressed.
- Aging mode adjustment.
- Dead. intermittently.
- No vertical deflection. Audio OK .
- Picture appears slowly. (CX5944W3XEG tips)
- No functions. No display.
- How to replace CRT. (CX5944W3XEG tips)
- No start-up.
- No raster. Blank raster with flyback lines after A1 is turned up.
- Adjustment when EEPROM is replaced.
- Dead.
- RF AGC adjustment.
- Switches OFF after about 10 minutes. Also a strange noise can be heard at that time from PSU.
- No picture.
- Canal + decoder does not function via scart plug 2. (CX5944W3XEG tip from SAMSUNG)
- No picture. intermittently. Audio OK . (CX5944W3XEG SAMSUNG repair tip)
- Tearing frame. Picture jitters vertically and horizontally.
- No picture. No audio. Power up OK. (SAMSUNG - CX5944W3XEG information)
- FACTORY/SERVICE mode adjustment.
- No audio. Incorrect width and height.
- Flyback lines. at top.
- White line.
- Brightness varies. (SAMSUNG - CX5944W3XEG information)
- Switches to protection mode (after a few seconds).
- Reduced vertical size.
- No picture. Audio OK . (CX5944W3XEG tips)
- At high-frequency (over 10KHz) on NICAM broadcasting, NICAM Click Noise ccurs.
- Tuner sound is audible in AV1 or AV2. (SAMSUNG - CX5944W3XEG information)
- No start-up. LED is green. No line drive.
- No audio. No colour. No TXT.
- Left side of picture curled inwards.
- Does not start if it has been in standby mode for more than 15 mins.
- No E/W correction.
- Error codes.
- Intermittently dead with amber LED.
- No vertical deflection.
- HV check.
- Colour, contrast and brightness controls inoperative. Picture is inadequate.
- Red streakes in picture. (service info for SAMSUNG -CX5944W3XEG)
- PSU pulsates.
- White balance adjustment.
- No picture. after warm-up.
- No picture. at start-up (intermittently).
- No line drive. (CX5944W3XEG tip from SAMSUNG)
- Focus adjustment.
- No start-up from standby. (CX5944W3XEG SAMSUNG repair tip)
- Slow start-up.
- Intermittent display when line sync is way out.
- Compressed picture.
- Centre convergence adjustment. (extract of circuit diagram attached)
- No tuning.
With this service information, you may repair SAMSUNG CX5944W3XEG faster/better when it fails.
When SAMSUNG CX5944W3XEG fails , these symptoms are known and EURAS knows the remedy/solution.
Tips are coming from EURAS customers, workshops and payed technicians from all over the world. SAMSUNG CX5944W3XEG fails can be better solved. If SAMSUNG CX5944W3XEG fails, this information will help you. Here you can only see the symptom list, to access remedies, you must register. With help of this list a solution is found often when SAMSUNG CX5944W3XEG fails.
|
Additionally to repairtips or service information CX5944W3XEG is linked to 83 components (IC's and/or transformers) in the Tectra
database, through which you can identify electrical compatibilities (crossreferences) in
appliances.
|
Chassis information is available (which chassis is built in into CX5944W3XEG ).
EURAS system also knows 189 appliances having the same chassis as CX5944W3XEG and can easily list them.
In the repair discussion pinboard for CX5944W3XEG there are 78 replies to questions asked about 61 different repair problems. With access to EURAS you can all read them or enter your own questions and get help for CX5944W3XEG from EURAS technicians or other users.
Do you want to see this remedies/cures for repairtips? Register here for the EURAS System Please note: access to the EURAS System can be granted only to professional
technicians/TV/Video/household electronics repair shops which are
authorized for service by a manufacturer, or can prove to be professionally
certified to do repairs on electronic appliances. You will be asked for a
statement and information accordingly during registration.
If you do not qualify as stated above and you have an appliance that needs
technical service, we do recommend you to contact the manufacturer (for
example through his website) or go to a professional household/Video/TV
electronics repair shop close to you.
Already registered? open CX5944W3XEG SAMSUNG in EURAS
All details on the EURAS System: English |
Deutsch |
Français |
Italiano |
Español |
Magyarul |
Português |
Polski |
Română |
Greek |
Back to EURAS Homepage >>
All manufacturers >>
SAMSUNG
tech tips
Last updated: 02. Dec 2008 01:50:28 MET, doccode ISO9002AS168EKA200805C EURASMOP
Responsible for the content: EURAS International GmbH, Eime, Germany.
All brand- or productnames are copyrighted by the respective manufacturer of the appliance and are only being used for identification purposes.
|
|