CDR500 / SANSUI [CD player]

• No sound via both channels, occasionally only low clicking.
• Noise on both channels.
• No start-up. intermittently. (picture attached) (CDR500 tips)
• Sound is distorted and scratchy with rough amplitudes.
• Left channel is distorted in PB.
• The compartment functions with difficulty.
• No audio. on the left.
• Disk tray does not close or moves back out.
• Replacement CDM2 deck with CDM4 deck.
• Crackling or momentary disappearance of sound on both channels (first 5 minutes).
• In FF and REW laser looses focus and error is displayed.
• Stops or skips on no. 10.
• UP test program.
• Hums. You can only hear both channels very low and distortion.
• CD rotates at high speed, but is not played.
• Complete CDM-4's for replacement of 30188 and 30199.
• Disc still rotates after pressing STOP. No eject.
• Sound jumps, cannot be tuned correctly. (picture attached)
• No audio.
• No PB. No display (intermittently).
• Disk tray squeaks when opening and closing
• CD spins at high speed but TOC is not read.
• No play and often displays error.
• Squeaking noise (which disappears after a short time) after pushing in the compartment.
• Disk tray runs with difficulty.
• CD compartment is taken in, a fault report appears on the display.
• No audio on both channels.
• Slight distortion on the right channel.
• Specific rebuilt component code numbers.
• Spindle motor turns too fast.
• CD- player doe snot read in CD, display shows ERROR, CD runs with increased speed.
• Skips tracks. (extract of circuit diagram attached)
• loading and unloading faults.
• Hums, whistles and is distorted.
• No or poor audio.
• Difficulty when inserting, occasional error or appliance indicates 99 tracks/32 min on display.
• Poor tracking when warm (shows after approx 6 hours).
• The compartment does not close or comes back out again.
• Disc table runs erratically and appliance does not accept any functions, display is dark.
• Adapter for CD singles.
• Replacement item. (CDR500 tips)
• The sound is distorted or hum on one or both channels.
• Replacement SAA7011 with SAA7010.
• Display indication has disappeared or is only present sometimes.
• Disc starts then stops.
• The appliance does not start up or shows error. (service info for SANSUI -CDR500)
• No sound through the headphone jack. (CDR500 SANSUI repair tip)
• Erratic display. No display. intermittently.
• Playback is correct but pressing stop causes crackling.
• Distortion on one channel.
• Occasionally no PB and the index is not displayed.
• No audio. in PB.
• Difficulties starting, intermittent error, or 99 tracks/32 minutes on display.
• Disc runs, eye pattern is on pin 7 of the demodulator unit, but the tracking is not balanced.
• Sound hums after switching on and sound distorts through both channels in Play.
• Crackle and hiss from one or more channels.
• The disc turns for only one revolution and then stops because it does not read the track.
• Muted audio. intermittently (when cold).
• Faulty display operation. (CDR500 SANSUI repair tip)
• Motor holder has been changed, only the new holder is available.
• Does not read TOC.
• Occasionally error message displayed during initialisation sequence and a scratching noise in the sound.
• Whistling rafoc (oscillation).
• Channel 1 crackles and makes noise.