CBP2566 / SANYO [TV]

• 1H delay adjustment.
• Dead. LED lit. (service info for SANYO -CBP2566)
• Focus adjustment. (service info for SANYO -CBP2566)
• Computer controlled teletext frequency adjustment.
• Comes on then appears to go into A.V mode but in standby mode. With power supply in off position no RC function. (service info for SANYO -CBP2566)
• Intermittently the appliance switches to standby but the channel indicator remains.
• Side pincushion correction adjustment.
• Vertical centre and width adjustment.
• AGC adjustment.
• When PCC PCB is replaced a burn up can sometimes occur on the new PCB.
• HV confirmation.
• Bell filter adjustment.
• White balance adjustment. (SANYO - CBP2566 information)
• When TXT is selected TV does not switch to TXT but then TV does not change channel.
• Horizontal oscillation adjustment.
• No picture. No sound. LED display lit.
• Horizontal width confirmation.
• Tuning drifts.
• B-Y adjustment.
• Looks like an identification fault.
• FM output adjustment.
• Colour phase adjustment.
• Screen VR adjustment.
• Does not stop on auto search.
• When TXT is selected TV does not switch to TXT but TV does not change channel.
• Sub-contrast adjustment.
• Black lines across screen followed by picture fade out to magenta screen and then height reduced and loss of tuning
• B-Y adjustment. (CBP2566 tips)
• Lower half of frame severely stretched.
• Display reacts to RC, otherwise no function.
• Screen VR adjustment.
• Flaring, dim picture.
• Humming noise on sound.
• Bell filter adjustment.
• SECAM identification discriminator adjustment.
• Looks like an identification fault.
• 1H delay adjustment.
• CW oscillator adjustment. (CBP2566 tips)
• Horizontal oscillation adjustment.
• Buzz on sound at minimum volume, also present in mute mode.
• Ringing in verticals, also associated with colour phase, instability and ringing from flyback transformer. (CBP2566 SANYO repair tip)
• Black lines run over screen followed by picture fade out to magenta screen then height reduced and loss of tuning.
• AGC adjustment.
• After switch on goes into standby.
• CW oscillator adjustment. (SANYO - CBP2566 information)
• Focus adjustment.
• When pincushion correction PCB is replaced a burn up can sometimes occur on new PCB.
• After switch on no function. (CBP2566 tips)
• Side pincushion correction adjustment.
• HV confirmation.
• Sub colour adjustment.
• Horizontal width confirmation.
• Horizontal centre adjustment.
• Video OUT adjustment.
• Sub colour adjustment.
• From switch on goes into standby.
• Sub-contrast adjustment. (SANYO - CBP2566 information)
• Vertical centre and width adjustment.
• Intermittently goes to standby leaving channel number on which after a few seconds changes to av.
• Colour phase adjustment.
• Green tint to picture. (CBP2566 tips)
• Fails. Cannot be switched on by RC. Display available and reacts to RC.
• Information regarding different operating standards.
• White point adjustment. (CBP2566 tip from SANYO)
• Computer controlled teletext frequency adjustment.
• FM output adjustment.
• No function after switch on.
• Appears like an identification fault.
• Video OUT adjustment.
• Sub-brightness adjustment.
• Sub-brightness adjustment.
• Horizontal centre adjustment.