CBP2580A / SANYO [TV 63 (59) cm picture]

• Greyscale adjustment.
• Vertical centre adjustment.
• +B power supply adjustment.
• No start-up from standby.
• Faint horizontal line near top of picture, best seen on AV.
• No audio. No picture.
• Loud hum after 5-10 mins followed by low gain, distortion and no RC commands.
• Tripping.
• Vertical size adjustment.
• Initialization of new chip IC790.
• Trips on start-up, or switches off.
• AGC adjustment. (CBP2580A tip from SANYO)
• SERVICE mode description.
• No functions.
• Dead. No display.
• AGC adjustment.
• AFT adjustment.
• +B power supply adjustment.
• No sound or picture from antenna. From AV input OK.
• Initialisation of memory IC.
• HV and width adjustment.
• Switches immediately off (protective circuit). (service info for SANYO -CBP2580A)
• HV and width adjustment.
• Vertical size adjustment.
• TV switching to protect mode.
• Standby light flashing.
• Trips (at start-up).
• Enter service mode.
• AFT adjustment.
• Dead.
• Trips for a couple of minutes before coming ON.
• Focus adjustment.
• No start-up.
• Horizontal black lines in picture.
• Vertical centre adjustment.
• When turned on set trips several times.
• Intermittently trips at switch on, after few minutes OK.
• No TXT.
• Powers down if chassis disturbed.
• Line output transistor fails repeatedly.
• No control possible.
• Low gain after 5-10 mins.
• Greyscale adjustment.
• Horizontal centre adjustment.
• Horizontal centre adjustment.
• No vertical deflection.
• Goes to stand-by after switch ON.
• Excessive mains voltage.
• Stuck in standby.
• Focus adjustment.
• Stuck in standby. LED blinks .
• No start-up. Power LED lit .
• Intermittent start up with motorboating from speakers.