EURAS System
    EURAS worldwideeuras.com    
EURAS System

CEP2576D / SANYO [TV 63 (59) cm picture]

The EURAS repair tip database for professional technicians and service engineers supplies the following faults for CEP2576D / SANYO.

List of fault symptoms:
  • Fast hiccup when connecting TV. LED flashes.
  • White streaks.
  • No function. Standby LED OFF. Pressing Standby, cracking from PTC.
  • Dead.
  • SERVICE mode:
  • Very dark and greyish picture.
  • No picture. No sound. Rattles.
  • Q600 blown up.
  • Unable to switch out of standby when cold.
  • No picture, just snow when tuning selected. No sound
  • Enter service mode.
  • Tuning drifts.
  • No function. No red LED.
  • Starts up, functions for a minute and immediately disconnects, remaining in standby.
  • Vertical collapse.
  • No picture. Audio OK .
  • Doesn't function even if standby LED lights up. When pressing mains switch, attempts to start up but goes to standby.
  • No start up. Fast tripping.
  • White screen. Flyback lines. (CEP2576D SANYO repair tip)
  • Corrupted data.
  • Snow in E-E.
  • Attempts to start up, but does not succeed and switches to standby. (CEP2576D SANYO repair tip)
  • Only three volume levels (zero-middle-maximum).
  • PSU switching transistor fails at start-up.
  • Red, green and blue flyback lines.
  • Flyback lines. at top.
  • Pincushion distortion. 5cm field collapse on each screen edges.
  • Excessive brightness. Audio OK .
  • No vertical deflection.
  • A few colour lines on top of picture.
  • No picture, no sound, just snow when tuning selected.
  • E/W fault. intermittently.
  • Clock flashing O S G text clock OK.
  • Stuck in standby.
  • No picture.
  • Vertical folover at bottom and insufficient height. Approx 20cm stripe on centre of screen. (SANYO - CEP2576D information)
  • No raster.
  • No audio.
  • Mains fuse blown.
  • Slow response to channel change, takes 20-30 secs to change.
  • Excessive horizontal size. Pincushion distortion.
  • R653 continues to fail.
  • Transistor Q650 (BU508A) is S/C.
  • No HT or tube heaters.
  • No horizontal or vertical deflection.
  • Unstable picture. Difficulty in tuning. OK with scart.
  • No start up after being turned off for several hours. It eventually starts up when attempting to switch on several times.
  • Switching FET (BUZ90A) defective.
  • E/W fault.
  • Reduced vertical size.
  • Switches to standby. Squealing noise.
  • No E/W correction.
  • Lines in picture. at top.
  • Bright raster. Audio OK .
  • Collapses to a thin bowed horizontal line.
  • No vertical sync. In TXT only page no. visible.
  • Blank raster, sound OK. OK if used with Scart input from VCR. (CEP2576D SANYO repair tip)
  • Shuts down (intermittently).
  • No luminance signal. In TXT only page no. is visible.
  • How to call up SERVICE mode.

When SANYO CEP2576D fails , these symptoms are known and EURAS knows the remedy/solution.

Tips are coming from EURAS customers, workshops and payed technicians from all over the world. SANYO CEP2576D fails can be better solved.

If SANYO CEP2576D fails, this information will help you. Here you can only see the symptom list, to access remedies, you must register.

With help of this list a solution is found often when SANYO CEP2576D fails.


Additionally to repairtips or service information CEP2576D is linked to 26 components (IC's and/or transformers) in the Tectra database, through which you can identify electrical compatibilities (crossreferences) in appliances.


Chassis information is available (which chassis is built in into CEP2576D ).

EURAS system also knows 23 appliances having the same chassis as CEP2576D and can easily list them.

For CEP2576D there are 5 compatible appliances known and can be listed.


In the repair discussion pinboard for CEP2576D there are 5 replies to questions asked about 7 different repair problems.
With access to EURAS you can all read them or enter your own questions and get help for CEP2576D from EURAS technicians or other users.

Do you want to see this remedies/cures for repairtips?   Register here for the EURAS System
Please note: access to the EURAS System can be granted only to professional Video/technicians/household electronics repair shops/TV which are authorized for service by a manufacturer, or can prove to be professionally certified to do repairs on electronic appliances. You will be asked for a statement and information accordingly during registration.

If you do not qualify as stated above and you have an appliance that needs technical service, we do recommend you to contact the manufacturer (for example through his website) or go to a professional TV/Video/household electronics repair shop close to you.

Already registered? open CEP2576D SANYO in EURAS

All details on the EURAS System: English | Deutsch | Français | Italiano | Español | Magyarul | Português | Polski | Română | Greek |


Back to EURAS Homepage >> All manufacturers >> SANYO tech tips  











Last updated: 01. Dec 2008 23:03:23 MET, doccode ISO9002AS168EKA200805C EURASMOP

Responsible for the content: EURAS International GmbH, Eime, Germany.
All brand- or productnames are copyrighted by the respective manufacturer of the appliance and are only being used for identification purposes.