EURAS System
    EURAS worldwideeuras.com    
EURAS System

CEP2576D00 / SANYO [TV 63 (59) cm picture]

The EURAS repair tip database for professional technicians and service engineers supplies the following faults for CEP2576D00 / SANYO.

List of fault symptoms:
  • A few colour lines on top of picture.
  • Blank raster, sound OK. OK if used with Scart input from VCR. (service info for SANYO -CEP2576D00)
  • No vertical deflection.
  • Reduced vertical size. (service info for SANYO -CEP2576D00)
  • Flyback lines. at top.
  • No E/W correction.
  • Excessive horizontal size. Pincushion distortion.
  • SERVICE mode:
  • Transistor Q650 (BU508A) is S/C.
  • No picture, just snow when tuning selected. No sound
  • Pincushion distortion. 5cm field collapse on each screen edges.
  • E/W fault. intermittently.
  • How to call up SERVICE mode.
  • E/W fault.
  • No HT or tube heaters.
  • R653 continues to fail.
  • Red, green and blue flyback lines.
  • Excessive brightness. Audio OK .
  • Switches to standby. Squealing noise.
  • Snow in E-E.
  • Fast hiccup when connecting TV. LED flashes.
  • Mains fuse blown. (CEP2576D00 SANYO repair tip)
  • Stuck in standby.
  • Shuts down (intermittently).
  • Corrupted data.
  • No function. No red LED. (CEP2576D00 tip from SANYO)
  • Very dark and greyish picture.
  • Attempts to start up, but does not succeed and switches to standby.
  • Clock flashing O S G text clock OK.
  • Vertical folover at bottom and insufficient height. Approx 20cm stripe on centre of screen.
  • No start up after being turned off for several hours. It eventually starts up when attempting to switch on several times.
  • Slow response to channel change, takes 20-30 secs to change.
  • Only three volume levels (zero-middle-maximum).
  • No start up. Fast tripping.
  • No function. Standby LED OFF. Pressing Standby, cracking from PTC.
  • Enter service mode.
  • Switching FET (BUZ90A) defective. (CEP2576D00 tips)
  • No horizontal or vertical deflection.
  • Collapses to a thin bowed horizontal line.
  • PSU switching transistor fails at start-up.
  • No picture. Audio OK .
  • Starts up, functions for a minute and immediately disconnects, remaining in standby.
  • White screen. Flyback lines. (CEP2576D00 tip from SANYO)
  • Doesn't function even if standby LED lights up. When pressing mains switch, attempts to start up but goes to standby. (SANYO - CEP2576D00 information)
  • No audio.
  • No picture, no sound, just snow when tuning selected.
  • Q600 blown up.
  • Dead.
  • Tuning drifts.
  • No raster.
  • Unstable picture. Difficulty in tuning. OK with scart. (CEP2576D00 tip from SANYO)
  • No luminance signal. In TXT only page no. is visible.
  • No vertical sync. In TXT only page no. visible.
  • Bright raster. Audio OK . (CEP2576D00 tip from SANYO)
  • Vertical collapse.
  • No picture. No sound. Rattles.
  • White streaks.
  • No picture.
  • Lines in picture. at top.
  • Unable to switch out of standby when cold.

With help of this list a solution is found often when SANYO CEP2576D00 fails.


Additionally to repairtips or service information CEP2576D00 is linked to 26 components (IC's and/or transformers) in the Tectra database, through which you can identify electrical compatibilities (crossreferences) in appliances.


Chassis information is available (which chassis is built in into CEP2576D00 ).

EURAS system also knows 23 appliances having the same chassis as CEP2576D00 and can easily list them.

For CEP2576D00 there are 5 compatible appliances known and can be listed.


In the repair discussion pinboard for CEP2576D00 there are 5 replies to questions asked about 7 different repair problems.
With access to EURAS you can all read them or enter your own questions and get help for CEP2576D00 from EURAS technicians or other users.

Do you want to see this remedies/cures for repairtips?   Register here for the EURAS System
Please note: access to the EURAS System can be granted only to professional household electronics repair shops/technicians/Video/TV which are authorized for service by a manufacturer, or can prove to be professionally certified to do repairs on electronic appliances. You will be asked for a statement and information accordingly during registration.

If you do not qualify as stated above and you have an appliance that needs technical service, we do recommend you to contact the manufacturer (for example through his website) or go to a professional household/TV/Video electronics repair shop close to you.

Already registered? open CEP2576D00 SANYO in EURAS

All details on the EURAS System: English | Deutsch | Français | Italiano | Español | Magyarul | Português | Polski | Română | Greek |


Back to EURAS Homepage >> All manufacturers >> SANYO tech tips  











Last updated: 01. Dec 2008 23:47:32 MET, doccode ISO9002AS168EKA200805C EURASMOP

Responsible for the content: EURAS International GmbH, Eime, Germany.
All brand- or productnames are copyrighted by the respective manufacturer of the appliance and are only being used for identification purposes.