 |
CEP2576DA / SANYO [TV 63 (59) cm picture]
The EURAS repair tip database for professional technicians and service engineers
supplies the following faults for CEP2576DA / SANYO.
List of fault symptoms:
- Pincushion distortion. 5cm field collapse on each screen edges.
- Excessive horizontal size. Pincushion distortion.
- Clock flashing O S G text clock OK. (CEP2576DA tips)
- How to call up SERVICE mode.
- Mains fuse blown.
- R653 continues to fail.
- Enter service mode. (SANYO - CEP2576DA information)
- Q600 blown up.
- Tuning drifts.
- White streaks.
- No audio.
- No picture, no sound, just snow when tuning selected.
- No picture.
- Unstable picture. Difficulty in tuning. OK with scart.
- Attempts to start up, but does not succeed and switches to standby.
- No start up. Fast tripping.
- No picture. Audio OK .
- E/W fault. intermittently.
- No function. No red LED.
- Doesn't function even if standby LED lights up. When pressing mains switch, attempts to start up but goes to standby.
- No function. Standby LED OFF. Pressing Standby, cracking from PTC.
- No vertical sync. In TXT only page no. visible.
- Starts up, functions for a minute and immediately disconnects, remaining in standby.
- No raster.
- No vertical deflection. (CEP2576DA SANYO repair tip)
- Very dark and greyish picture.
- Fast hiccup when connecting TV. LED flashes.
- No luminance signal. In TXT only page no. is visible.
- Reduced vertical size.
- Lines in picture. at top.
- Stuck in standby.
- Collapses to a thin bowed horizontal line.
- Corrupted data.
- No HT or tube heaters.
- SERVICE mode:
- No E/W correction.
- Excessive brightness. Audio OK .
- Red, green and blue flyback lines.
- Switching FET (BUZ90A) defective.
- Switches to standby. Squealing noise.
- Blank raster, sound OK. OK if used with Scart input from VCR. (CEP2576DA SANYO repair tip)
- No horizontal or vertical deflection.
- Vertical collapse.
- No start up after being turned off for several hours. It eventually starts up when attempting to switch on several times.
- No picture. No sound. Rattles.
- Bright raster. Audio OK .
- Slow response to channel change, takes 20-30 secs to change.
- Dead.
- E/W fault.
- Shuts down (intermittently).
- Flyback lines. at top.
- Only three volume levels (zero-middle-maximum).
- A few colour lines on top of picture.
- Snow in E-E.
- No picture, just snow when tuning selected. No sound (SANYO - CEP2576DA information)
- White screen. Flyback lines.
- Unable to switch out of standby when cold.
- Transistor Q650 (BU508A) is S/C.
- Vertical folover at bottom and insufficient height. Approx 20cm stripe on centre of screen.
- PSU switching transistor fails at start-up. (service info for SANYO -CEP2576DA)
When SANYO CEP2576DA fails , these symptoms are known and EURAS knows the remedy/solution.
Tips are coming from EURAS customers, workshops and payed technicians from all over the world. SANYO CEP2576DA fails can be better solved. If SANYO CEP2576DA fails, this information will help you. Here you can only see the symptom list, to access remedies, you must register. With help of this list a solution is found often when SANYO CEP2576DA fails.
|
Additionally to repairtips or service information CEP2576DA is linked to 26 components (IC's and/or transformers) in the Tectra
database, through which you can identify electrical compatibilities (crossreferences) in
appliances.
|
Chassis information is available (which chassis is built in into CEP2576DA ).
EURAS system also knows 23 appliances having the same chassis as CEP2576DA and can easily list them.
For CEP2576DA there are 5 compatible appliances known and can be listed.
In the repair discussion pinboard for CEP2576DA there are 5 replies to questions asked about 7 different repair problems. With access to EURAS you can all read them or enter your own questions and get help for CEP2576DA from EURAS technicians or other users.
Do you want to see this remedies/cures for repairtips? Register here for the EURAS System Please note: access to the EURAS System can be granted only to professional
TV/household electronics repair shops/Video/technicians which are
authorized for service by a manufacturer, or can prove to be professionally
certified to do repairs on electronic appliances. You will be asked for a
statement and information accordingly during registration.
If you do not qualify as stated above and you have an appliance that needs
technical service, we do recommend you to contact the manufacturer (for
example through his website) or go to a professional household/Video/TV
electronics repair shop close to you.
Already registered? open CEP2576DA SANYO in EURAS
All details on the EURAS System: English |
Deutsch |
Français |
Italiano |
Español |
Magyarul |
Português |
Polski |
Română |
Greek |
Back to EURAS Homepage >>
All manufacturers >>
SANYO
tech tips
Last updated: 01. Dec 2008 16:56:53 MET, doccode ISO9002AS168EKA200805C EURASMOP
Responsible for the content: EURAS International GmbH, Eime, Germany.
All brand- or productnames are copyrighted by the respective manufacturer of the appliance and are only being used for identification purposes.
|
|