CEP2584 / SANYO [TV]

• No picture. Audio OK .
• Vertical folover at bottom and insufficient height. Approx 20cm stripe on centre of screen.
• PSU switching transistor fails at start-up.
• Collapses to a thin bowed horizontal line. (CEP2584 tips)
• Flyback lines. at top.
• Excessive brightness. Audio OK .
• Fast hiccup when connecting TV. LED flashes.
• No start up after being turned off for several hours. It eventually starts up when attempting to switch on several times.
• Stuck in standby.
• E/W fault. intermittently.
• No luminance signal. In TXT only page no. is visible.
• Bright raster. Audio OK .
• Corrupted data.
• No vertical sync. In TXT only page no. visible.
• White screen. Flyback lines.
• Unstable picture. Difficulty in tuning. OK with scart.
• Mains fuse blown.
• SERVICE mode:
• Slow response to channel change, takes 20-30 secs to change.
• Doesn't function even if standby LED lights up. When pressing mains switch, attempts to start up but goes to standby.
• No raster.
• Switches to standby. Squealing noise.
• Blank raster, sound OK. OK if used with Scart input from VCR.
• Vertical collapse. (CEP2584 tips)
• No picture, no sound, just snow when tuning selected.
• Excessive horizontal size. Pincushion distortion.
• No audio.
• Starts up, functions for a minute and immediately disconnects, remaining in standby.
• White streaks.
• R653 continues to fail.
• Reduced vertical size.
• No vertical deflection.
• Lines in picture. at top.
• No function. Standby LED OFF. Pressing Standby, cracking from PTC.
• Dead.
• Clock flashing O S G text clock OK.
• Switching FET (BUZ90A) defective.
• E/W fault.
• No function. No red LED.
• No picture. No sound. Rattles.
• No HT or tube heaters.
• No E/W correction.
• Enter service mode.
• Red, green and blue flyback lines.
• Pincushion distortion. 5cm field collapse on each screen edges.
• No start up. Fast tripping.
• Very dark and greyish picture.
• Unable to switch out of standby when cold.
• How to call up SERVICE mode.
• Q600 blown up. (CEP2584 SANYO repair tip)
• Shuts down (intermittently).
• Black and white picture at switch on from cold. After 15 mins colour OK.
• No picture.
• A few colour lines on top of picture.
• Snow in E-E.
• Attempts to start up, but does not succeed and switches to standby.
• No picture, just snow when tuning selected. No sound (SANYO - CEP2584 information)
• Transistor Q650 (BU508A) is S/C. (CEP2584 SANYO repair tip)
• Tuning drifts.
• No horizontal or vertical deflection.