EURAS System
    EURAS worldwideeuras.com    
EURAS System

CEP2596 / SANYO [TV]

The EURAS repair tip database for professional technicians and service engineers supplies the following faults for CEP2596 / SANYO.

List of fault symptoms:
  • How to call up SERVICE mode.
  • Flyback lines. at top.
  • No function. Standby LED OFF. Pressing Standby, cracking from PTC.
  • Shuts down (intermittently).
  • Switching FET (BUZ90A) defective. (CEP2596 SANYO repair tip)
  • No picture, just snow when tuning selected. No sound
  • Stuck in standby.
  • White streaks.
  • PSU switching transistor fails at start-up.
  • Pincushion distortion. 5cm field collapse on each screen edges.
  • No vertical deflection.
  • Snow in E-E.
  • Excessive brightness. Audio OK .
  • No start up after being turned off for several hours. It eventually starts up when attempting to switch on several times.
  • Blank raster, sound OK. OK if used with Scart input from VCR.
  • No picture.
  • Fast hiccup when connecting TV. LED flashes.
  • No horizontal or vertical deflection. (service info for SANYO -CEP2596)
  • No audio.
  • Attempts to start up, but does not succeed and switches to standby.
  • Vertical collapse.
  • White screen. Flyback lines.
  • No vertical sync. In TXT only page no. visible.
  • Slow response to channel change, takes 20-30 secs to change.
  • No E/W correction.
  • Collapses to a thin bowed horizontal line.
  • SERVICE mode:
  • No start up. Fast tripping. (SANYO - CEP2596 information)
  • Switches to standby. Squealing noise.
  • Doesn't function even if standby LED lights up. When pressing mains switch, attempts to start up but goes to standby. (CEP2596 tips)
  • Unstable picture. Difficulty in tuning. OK with scart.
  • Tuning drifts.
  • No luminance signal. In TXT only page no. is visible.
  • Transistor Q650 (BU508A) is S/C.
  • Corrupted data.
  • R653 continues to fail. (CEP2596 tips)
  • Mains fuse blown.
  • Excessive horizontal size. Pincushion distortion.
  • No picture. No sound. Rattles.
  • Lines in picture. at top.
  • No raster.
  • Unable to switch out of standby when cold.
  • No picture. Audio OK .
  • E/W fault. intermittently.
  • A few colour lines on top of picture.
  • Dead. (CEP2596 tip from SANYO)
  • No function. No red LED.
  • Clock flashing O S G text clock OK.
  • Red, green and blue flyback lines.
  • Q600 blown up.
  • Starts up, functions for a minute and immediately disconnects, remaining in standby.
  • Bright raster. Audio OK .
  • No picture, no sound, just snow when tuning selected.
  • Enter service mode.
  • Reduced vertical size. (service info for SANYO -CEP2596)
  • No HT or tube heaters.
  • Very dark and greyish picture.
  • E/W fault.
  • Vertical folover at bottom and insufficient height. Approx 20cm stripe on centre of screen.

If SANYO CEP2596 fails, this information will help you. Here you can only see the symptom list, to access remedies, you must register.

With help of this list a solution is found often when SANYO CEP2596 fails.


Additionally to repairtips or service information CEP2596 is linked to 26 components (IC's and/or transformers) in the Tectra database, through which you can identify electrical compatibilities (crossreferences) in appliances.


Chassis information is available (which chassis is built in into CEP2596 ).

EURAS system also knows 23 appliances having the same chassis as CEP2596 and can easily list them.

In the repair discussion pinboard for CEP2596 there are 5 replies to questions asked about 7 different repair problems.
With access to EURAS you can all read them or enter your own questions and get help for CEP2596 from EURAS technicians or other users.

Do you want to see this remedies/cures for repairtips?   Register here for the EURAS System
Please note: access to the EURAS System can be granted only to professional TV/technicians/household electronics repair shops/Video which are authorized for service by a manufacturer, or can prove to be professionally certified to do repairs on electronic appliances. You will be asked for a statement and information accordingly during registration.

If you do not qualify as stated above and you have an appliance that needs technical service, we do recommend you to contact the manufacturer (for example through his website) or go to a professional TV/household/Video electronics repair shop close to you.

Already registered? open CEP2596 SANYO in EURAS

All details on the EURAS System: English | Deutsch | Français | Italiano | Español | Magyarul | Português | Polski | Română | Greek |


Back to EURAS Homepage >> All manufacturers >> SANYO tech tips  











Last updated: 01. Dec 2008 16:56:23 MET, doccode ISO9002AS168EKA200805C EURASMOP

Responsible for the content: EURAS International GmbH, Eime, Germany.
All brand- or productnames are copyrighted by the respective manufacturer of the appliance and are only being used for identification purposes.