EURAS System
    EURAS worldwideeuras.com    
EURAS System

CEP2876D / SANYO [TV 70-74 (66-70) cm picture]

The EURAS repair tip database for professional technicians and service engineers supplies the following faults for CEP2876D / SANYO.

List of fault symptoms:
  • Dead.
  • Slow response to channel change, takes 20-30 secs to change. (CEP2876D tips)
  • Bright raster. Audio OK .
  • Switches to standby. Squealing noise.
  • Reduced vertical size.
  • No HT or tube heaters.
  • Attempts to start up, but does not succeed and switches to standby.
  • Enter service mode.
  • Flyback lines. at top.
  • White screen. Flyback lines.
  • Only three volume levels (zero-middle-maximum).
  • No vertical deflection.
  • Mains fuse blown.
  • No start up. Fast tripping.
  • Clock flashing O S G text clock OK.
  • White streaks.
  • Unstable picture. Difficulty in tuning. OK with scart.
  • A few colour lines on top of picture.
  • Pincushion distortion. 5cm field collapse on each screen edges.
  • Transistor Q650 (BU508A) is S/C.
  • Excessive horizontal size. Pincushion distortion.
  • No picture. No sound. Rattles.
  • No function. Standby LED OFF. Pressing Standby, cracking from PTC.
  • Very dark and greyish picture.
  • Excessive brightness. Audio OK .
  • Stuck in standby.
  • PSU switching transistor fails at start-up.
  • No vertical sync. In TXT only page no. visible.
  • E/W fault. intermittently.
  • Switching FET (BUZ90A) defective.
  • No function. No red LED.
  • E/W fault.
  • No luminance signal. In TXT only page no. is visible.
  • How to call up SERVICE mode. (CEP2876D SANYO repair tip)
  • Blank raster, sound OK. OK if used with Scart input from VCR.
  • Shuts down (intermittently).
  • No picture. Audio OK .
  • SERVICE mode:
  • Snow in E-E.
  • Q600 blown up.
  • Vertical collapse.
  • No raster.
  • No E/W correction. (CEP2876D tip from SANYO)
  • Doesn't function even if standby LED lights up. When pressing mains switch, attempts to start up but goes to standby.
  • No horizontal or vertical deflection.
  • Fast hiccup when connecting TV. LED flashes.
  • Starts up, functions for a minute and immediately disconnects, remaining in standby.
  • Collapses to a thin bowed horizontal line. (CEP2876D tips)
  • No start up after being turned off for several hours. It eventually starts up when attempting to switch on several times.
  • No picture.
  • No picture, just snow when tuning selected. No sound
  • Unable to switch out of standby when cold. (CEP2876D tips)
  • Vertical folover at bottom and insufficient height. Approx 20cm stripe on centre of screen.
  • No audio.
  • Red, green and blue flyback lines.
  • Tuning drifts.
  • No picture, no sound, just snow when tuning selected.
  • Lines in picture. at top.
  • Corrupted data. (service info for SANYO -CEP2876D)
  • R653 continues to fail.

When SANYO CEP2876D fails , these symptoms are known and EURAS knows the remedy/solution.

Tips are coming from EURAS customers, workshops and payed technicians from all over the world. SANYO CEP2876D fails can be better solved.

If SANYO CEP2876D fails, this information will help you. Here you can only see the symptom list, to access remedies, you must register.

With help of this list a solution is found often when SANYO CEP2876D fails.


Additionally to repairtips or service information CEP2876D is linked to 26 components (IC's and/or transformers) in the Tectra database, through which you can identify electrical compatibilities (crossreferences) in appliances.


Chassis information is available (which chassis is built in into CEP2876D ).

EURAS system also knows 23 appliances having the same chassis as CEP2876D and can easily list them.

For CEP2876D there are 5 compatible appliances known and can be listed.


In the repair discussion pinboard for CEP2876D there are 5 replies to questions asked about 7 different repair problems.
With access to EURAS you can all read them or enter your own questions and get help for CEP2876D from EURAS technicians or other users.

Do you want to see this remedies/cures for repairtips?   Register here for the EURAS System
Please note: access to the EURAS System can be granted only to professional technicians/household electronics repair shops/TV/Video which are authorized for service by a manufacturer, or can prove to be professionally certified to do repairs on electronic appliances. You will be asked for a statement and information accordingly during registration.

If you do not qualify as stated above and you have an appliance that needs technical service, we do recommend you to contact the manufacturer (for example through his website) or go to a professional household/TV/Video electronics repair shop close to you.

Already registered? open CEP2876D SANYO in EURAS

All details on the EURAS System: English | Deutsch | Français | Italiano | Español | Magyarul | Português | Polski | Română | Greek |


Back to EURAS Homepage >> All manufacturers >> SANYO tech tips  











Last updated: 01. Dec 2008 23:57:19 MET, doccode ISO9002AS168EKA200805C EURASMOP

Responsible for the content: EURAS International GmbH, Eime, Germany.
All brand- or productnames are copyrighted by the respective manufacturer of the appliance and are only being used for identification purposes.