VHR5200 / SANYO [Video recorder - VHS HiFi]

• PB output level 2 adjustment.
• Dead. (VHR5200 SANYO repair tip)
• Lines run from the top to the bottom of the picture and there is rhythmic tracking interference. (service info for SANYO -VHR5200)
• No tuning. in UHF.
• The fuse on the mains input panel keeps blowing.
• Noise in picture.
• No tape functions.
• White spots.
• Deviation adjustment. (with circuit diagram extract)
• Luminance signal recording current adjustment. (extract of circuit diagram attached)
• Carrier adjustment.
• Bias adjustment.
• Chrominance signal recording current adjustment. (+ extract of circuit diagram)
• E-E level adjustment. (with circuit diagram extract)
• Intermittently appliance switches to STOP from PLAY or REC.
• Intermittently keys trip.
• PB output level 1 adjustment.
• Intermittent white spots during playback.
• No sound REC, leaves previous sound.
• Sound disturbances on MW stations.
• Poor display.
• Appliance does not unlace the tape. Rewind only works sometimes. If PB is selected, it switches to stand by.
• No FF. No REW.
• PB level adjustment. (+ extract of circuit diagram)
• No picture. in REC.
• CCD level adjustment. (part of circuit diagram displayed)
• Tuning does not function correctly and E-E sound hums.
• No colour. in E-E.
• No PB. Pinch roller stops.
• Attempts to load at power on.
• During play the sound howls.
• 12V power supply is intermittent. (VHR5200 SANYO repair tip)
• Sometimes appliance does not REW. In the display REW is shown but the tape does not move.
• No REC. intermittently. (VHR5200 tips)
• Tuner/band change cannot be switched to UHF.
• Picture rolls. in E-E.
• The fast forward and fast rewind commands are accepted, but the appliance does not wind.
• RF AGC adjustment.
• No functions.
• Continuous loading.
• Head drum turns continuously at switch-on. Display and setting of clock OK. No further functions.
• Appliance does not lace up or will not unlace.
• Flashing display.
• Still vertical lock adjustment.
• Break-up of picture with lines flashing on screen.
• Appliance does not accept button commands.
• When switching from forward search to FF, mechanism jams causing loading block to chatter. (service info for SANYO -VHR5200)
• No audio. in E-E.
• No eject.
• Slow tracking adjustment. (part of circuit diagram displayed)
• No pinch roller solenoid operation.
• The sound goes out of tune.
• Loud squeaking during fast forward and rewind.
• CH1, CH2 switching position adjustment. (with circuit diagram extract)
• Intermittent capstan speed.
• Intermittently fails to lace up/unlace tape.
• PLAY does not function remains in E-E mode, capstan and head drum runs constantly. (VHR5200 tips)
• Occasionally the tape does not lace up or will not unlace.
• No display.
• Shortly after starting, the appliance switches to stop. (SANYO - VHR5200 information)
• No deck functions.
• No function during play operation.
• Very strong drop-outs during play.
• Faulty capstan speed during PB and REC.
• Blank raster. in E-E (intermittently).