 |
6659 / SBR [TV 70-74 (66-70) cm picture]
The EURAS repair tip database for professional technicians and service engineers
supplies the following faults for 6659 / SBR.
List of fault symptoms:
- No station tunning on 4 of the channels.
- Noisy audio. Alternator noise may be generated when using an xr car radio with an XM701 car amplifier.
- Flyback lines.
- No tuning.
- Distorted picture. at bottom.
- Contrast control. (6659 SBR repair tip)
- Blank raster.
- Insufficient height. Cramped at bottom.
- Vertical fault.
- Over a period of approx two hours picture gets progressively greener.
- No +12V on IC332.
- No colour. Audio OK .
- Various problems deleting picture which occur very intermittently and may disappear when warm.
- No frame sync.
- Dark raster. Audio OK .
- Intermittently does not start up or fails.
- Reduction in contrast level.
- No functions. after start-up (intermittently).
- Attempts to startup with no result.
- Black band at bottom of screen.
- No picture, just bright screen with white lines. Sound OK.
- Low brightness when first switched on, line shading and flyback lines.
- Vertical lines.
- No blue luminance.
- Teletext problems.
- Lower half of screen wrong colour. (6659 SBR repair tip)
- Black lines.
- Dark picture for first 10 mins.
- Intermittently starts and stops. E1 on display.
- Brightness and contrast problems.
- Print plate 256 divider U18.
- Appliance keeps searching for channels after switching on the T.V. (6659 tips)
- No luminance output from the TDA2560.
- No function, the power supply does not start up, the display indicates E1.
- Partial picture collapse.
- Power supply hiccups.
- Set switches off after approx three hours.
- The picture becomes greener over a period of two hours.
- Zigzags.
- Contrast and brightness problems.
- Black band across screen.
- LHS of screen is dark and gets lighter towards RHS with flyback lines present. (6659 tips)
- Replacement of tuner ECL2006 with UV418.
- No picture. intermittently.
- Screen is lit (no snow on raster).
- No start-up (intermittently).
- Intermittent colour.
- Width problems.
- Dark picture. No adjustment from RC. After approx 3 minutes brightness comes back to its preset value and can be controlled.
- Trapezoid shaped raster.
- Background-colour changes. (service info for SBR -6659)
- Trips.
- Appliance stuck on channel 1.
- No picture.
- No luminance.
- Blank screen.
- Reduced horizontal size.
- Ballooning effect.
- Display indicates E1.
- Field low and severe flyback lines.
- No picture. after warm-up (intermittently).
- Does not lock in on high frequency channels. Locks incorrectly in on low frequency channels.
- Randomly trips.
- No response to control panel or RC. No channel change. Picture OK.
- After approximately 20 minutes the raster is lost.
- Vertical collapse. intermittently.
- Poor REC/PB. Picture is too big.
- Dim blank raster.
- Safety test after repair.
- Colour varies.
- Vertical lines on left of picture.
- Contrast varies. (6659 SBR repair tip)
- Frame linearity problems. (6659 tips)
- No or low brightness.
- Slow start-up.
- Cycles on/off. intermittently.
- Processing of "non-standard" signals.
- Picture quality poor, smearing, glistening, milky whites or insufficient brightness.
- Tint alters.
- Lines on picture plus excessive brightness.
- No blue signal output of TDA3560.
- Horizontal stripe. intermittently (after a while).
- Sound ok, after about 30 mins there are lines on the screen, (no brightness or colour).
- The picture is too dark, the picture lightens after some time.
- The station storage breaks down with system TRD111.
- Picture quality poor, smearing, glistening or milky whites and insufficient brightness.
- Light-spot after switching-off.
- Light picture with min brightness and flyback lines. (6659 tips)
- Fine white lines.
- No audio. after warm-up.
- Picture and sound are missing. Raster OK.
- Flyback lines on one colour. (6659 tip from SBR)
- Squeaking.
- Switches on to channel 9
- Vertical foldover at bottom.
- Replacing TDA2523 with TDA2525.
- Vertical collapse.
- Replacement for U341 tuner. (6659 tips)
- E/W fault.
- Trips (intermittently).
- Dim picture.
- No RC functions.
- As soon as the TV is switched on the TV discharges the EHT.
- Deviation or intermittent operation of the tuning.
- Three types of line transformers.
- Insensitive after IF replacement.
- EHT arcs.
- After working normally for a short time, the TV switches off. (6659 tip from SBR)
- Blank raster. Audio OK .
- Hum when volume off also during low sound passages.
- Intermittently stops and starts again after a few secs.
- The stations run through when tuning the appliance.
- No picture. at bottom.
- No brightness.
- The top part of the picture is blanked out, only the bottom three inches having a picture.
- Sync IC (TDA3571BQ) replaces IC (TDA2571AQ).
- After 30 minutes lines appear on screen, luma and chroma are missing. Sound ok.
- Brightness fault.
- Stuck in standby. No display. LED lit. .
- No E/W correction.
- Raster is blank, sound ok.
- No raster. after warm-up (intermittently).
- No start-up. (6659 SBR repair tip)
- PAL/SECAM transcoder
- Fails.
- Reduced brightness with limited adjustment possibility. Contrast and colour OK.
- Moving or stationary hum bars.
- Loss of line hold.
- Reduced vertical size. after warm-up.
- Dark picture.
- Sometimes no start up of PSU and/or drop outs.
- Dark picture. intermittently.
- No picture. If screen grid is turned up, vertical line appears.
- Picture rolls in at the bottom. Vertical linearity error.
- Dark picture. Lightens after a short time.
- No tuning. only on certain channels.
- Connection of a loop system to the TV.
- Service tips Japanese VCRs.
- No vertical synchronisation.
- No line synchronisation.
- No audio. No picture.
- Linearity distortion in centre of screen.
- Green picture after approx 2 hrs.
- No function, no start up of PSU, E1 on display.
- Lines across picture plus hissing or crackling.
- Constant tripping. (6659 tip from SBR)
- Intermittent dropouts.
- No red. intermittently. (6659 tips)
- No function. E1 on display.
- Venetian blind effect.
- Line synchronisation is missing or line collapse.
- No picture. Audio OK .
- Part field collapse.
- Low contrast in picture and impossible to adjust. Intermittent fault.
- Intermittently the background changes colour.
- No audio. Picture OK .
- In the tuning phase the TV does not stop. Receives VHF in UHF band.
- Switches off after some time, strange noise audible. (6659 tip from SBR)
- Does not stop at K5 and/or K21 in search mode. (SBR - 6659 information)
- The stations are out of tune when the appliance is switched on, the television is correctly tuned after approx 1 min.
- On reception of some UHF-channels, AFC does not work correctly. After opening the tuning tray, the picture is perfect.
- Bad luminance striations.
- Height problems.
- Loss of raster after approx twenty minutes. Sound remaining ok. (6659 tips)
- Brightness too high/flyback line visible.
- No vertical deflection.
- Lines on picture plus hissing or crackling.
- Cramped raster.
- Very intermittent hiccups.
- No picture. Lines on screen if left on for approx 30 mins.
- No synchronisation.
- Low brightness. Flyback lines. (6659 tips)
- No E/W correction. Excessive horizontal size.
- Purity is poor.
- Video is missing, small amount of chroma.
- Dead.
- No TXT.
- Picture is missing, sound ok.
- Dead or intermittently dead.
- No functions.
- Memory loss. (SBR - 6659 information)
- Lines folds over when cold. Ok again after approx. 1 min.
- Picture collapse.
- Hiccups from PSU when fluorescent light switched on/off.
- Remote telco decoder problems.
- Contrast problems.
- Poor picture quality, smearing, glistening, milky whites or insufficient brightness.
- Intermittently frame collapses. (SBR - 6659 information)
- Pincushion distortion. E/W fault.
- Poor picture.
- Lines in picture when using Japanese VCRs.
- Attempts to start up.
- TXT reception problems with K30/K35 chassis.
- Diamond-shaped distortion visible in vertical lines. Phenomenon relocates depending on brightness.
With help of this list a solution is found often when SBR 6659 fails.
|
Additionally to repairtips or service information 6659 is linked to 6 components (IC's and/or transformers) in the Tectra
database, through which you can identify electrical compatibilities (crossreferences) in
appliances.
|
Chassis information is available (which chassis is built in into 6659 ).
EURAS system also knows 255 appliances having the same chassis as 6659 and can easily list them.
For 6659 there are 3 compatible appliances known and can be listed.
In the repair discussion pinboard for 6659 there are 3 replies to questions asked about 1 different repair problems. With access to EURAS you can all read them or enter your own questions and get help for 6659 from EURAS technicians or other users.
Do you want to see this remedies/cures for repairtips? Register here for the EURAS System Please note: access to the EURAS System can be granted only to professional
household electronics repair shops/technicians/TV/Video which are
authorized for service by a manufacturer, or can prove to be professionally
certified to do repairs on electronic appliances. You will be asked for a
statement and information accordingly during registration.
If you do not qualify as stated above and you have an appliance that needs
technical service, we do recommend you to contact the manufacturer (for
example through his website) or go to a professional household/TV/Video
electronics repair shop close to you.
Already registered? open 6659 SBR in EURAS
All details on the EURAS System: English |
Deutsch |
Français |
Italiano |
Español |
Magyarul |
Português |
Polski |
Română |
Greek |
Back to EURAS Homepage >>
All manufacturers >>
SBR
tech tips
Last updated: 02. Dec 2008 02:13:19 MET, doccode ISO9002AS168EKA200805C EURASMOP
Responsible for the content: EURAS International GmbH, Eime, Germany.
All brand- or productnames are copyrighted by the respective manufacturer of the appliance and are only being used for identification purposes.
|
|