EURAS System
    EURAS worldwideeuras.com    
EURAS System

SW01TV362N / SEAWAY [TV 36/37 (34-36) cm picture]

The EURAS repair tip database for professional technicians and service engineers supplies the following faults for SW01TV362N / SEAWAY.

List of fault symptoms:
  • No colour.
  • Blue screen.
  • No start-up. Display flashes .
  • Q602 trips repeatedly.
  • No HV.
  • No start-up from standby. LED is red . No line drive.
  • Dark stripes in picture after a few minutes. Growing thicker and distorting the picture.
  • Picture folds down at the bottom. Linearity and vertical position cannot be adjusted.
  • Unstable picture.
  • No function via 12/24V power supply.
  • Enter service mode.
  • Vertical deflection reduced to 2-4 cm.
  • Tripping.
  • Slow start-up.
  • Intermittently switches off and goes to standby. If switched on again, a digit key has to be pressed on RC.
  • Blue picture. Retrace lines.
  • No picture. Blank raster. Audio OK .
  • Strong continuous chirp from mains transformer with normal operation. Horizontal interference lines (pinch).
  • Appliance stuck in BG mode.
  • Squealing noise. at start-up.
  • Dead (intermittently).
  • No horizontal or vertical deflection. (SEAWAY - SW01TV362N information)
  • Vertical streaks.
  • Black vertical bar. on the left.
  • RC is defective.
  • TV does not switch on. Standby LED flickers.
  • No start-up.
  • Switches to standby (after warm-up).
  • No funciona. LED en rojo
  • 2-3 cm horizontal stripe in the middle of screen.
  • Vertical lines. Unstable picture.
  • No picture. Audio OK .
  • BU808DFI fails every so often.
  • Horizontal line.
  • Picture is instable, horizontal lines from the top to the bottom.
  • No start-up from standby.
  • Blue screen. Flyback lines.
  • PSU pulsates quickly at switch on.
  • Green picture. Flyback lines.
  • No functions.
  • Dead.
  • Switches to protection mode.
  • R809 and R821 smoking after a few minutes.
  • Does not start up. Standby LED is present at switch-on. LED becomes green for one sec., then it switches off.
  • Key-LED lights green for a short time, then becomes red.
  • 8V missing. (service info for SEAWAY -SW01TV362N)
  • Stuck in standby.
  • No start-up. LED is red .
  • Dark picture.
  • Line output transistor faulty.
  • HV output stage (BU808DFI) defective.

Tips are coming from EURAS customers, workshops and payed technicians from all over the world. SEAWAY SW01TV362N fails can be better solved.

If SEAWAY SW01TV362N fails, this information will help you. Here you can only see the symptom list, to access remedies, you must register.

With help of this list a solution is found often when SEAWAY SW01TV362N fails.


Additionally to repairtips or service information SW01TV362N is linked to 60 components (IC's and/or transformers) in the Tectra database, through which you can identify electrical compatibilities (crossreferences) in appliances.


Chassis information is available (which chassis is built in into SW01TV362N ).

EURAS system also knows 327 appliances having the same chassis as SW01TV362N and can easily list them.

For SW01TV362N there are 16 compatible appliances known and can be listed.


In the repair discussion pinboard for SW01TV362N there are 42 replies to questions asked about 16 different repair problems.
With access to EURAS you can all read them or enter your own questions and get help for SW01TV362N from EURAS technicians or other users.

Do want to see this remedies/cures for repairtips?   Register here for the EURAS System

Already registered? open SW01TV362N SEAWAY in EURAS

All details on the EURAS System: English | Deutsch | Français | Italiano | Español | Magyarul | Português | Polski | Română | Greek |


Back to EURAS Homepage >> All manufacturers >> SEAWAY tech tips  


(C) EURAS International Ltd.









Last updated: 20. Aug 2008 02:35:10 MET, doccode ISO9002AS168EKA200805C [cachelite] EURASMOP

Responsible for the content: EURAS International GmbH, Eime, Germany. All rights reserved, EURAS database V2.0 (C) 2002-2008. All brand- or productnames are copyrighted by the respective manufacturer of the appliance and are only being used for identification purposes.