SW01TV551S / SEAWAY [TV]

• Does not start, fast pulsating also without deflection plug.
• Only 300 V at rectifier.
• E/W fault. (SEAWAY - SW01TV551S information)
• No line drive.
• Hum bar. No RC functions.
• Vertical collapse.
• Ticking noise. in standby.
• No picture. Audio and OSD OK .
• Enter service mode.
• Green LED flashing. (SW01TV551S tip from SEAWAY)
• PSU pulsates.
• No start-up from standby with RC.
• No picture. OSD OK .
• LED flashes. (SW01TV551S tip from SEAWAY)
• No start-up. Led briefly green then goes into standby again.
• Trips. Green LED flashes .
• Pincushion distortion (intermittently).
• Very bright picture content and blooming, even during AV.
• Reduced vertical deflection.
• No vertical deflection.
• Picture disappears with a flash. Sound stays and picture is back.
• Whistling from PSU.
• Wavy picture. (SW01TV551S SEAWAY repair tip)
• PSU pulsates. No functions. Standby LED flashes .
• Excessive horizontal size. Pincushion distortion. on sides. (SW01TV551S tip from SEAWAY)
• Switches to standby. after start-up.
• Annoying noise from PSU. Functions OK.
• Memory loss.
• Pincushion distortion.
• Shuts down.
• No picture.
• Stuck in standby.
• No blue.
• Reduced horizontal deflection.
• Vertical output stage fails repeatedly.
• No picture. No audio. PSU pulsates.
• Black screen with 3 colour lines on the first third at the top of the screen.
• Faulty OSD and/or Teletext.
• Annoying noise from PSU in standby. (SW01TV551S tips)
• PSU chirps.
• Slow start-up. Pulsating picture. Switches off by itself.
• No tuning menu. "Locked" appears, when Install option is selected.
• Line output transformer is defective.
• Display shows "locked" during programme search, though lock is cancelled.
• Dark screen. No contrast control. No brightness control.
• No start-up. (SEAWAY - SW01TV551S information)
• Switches to standby, LED is red for a short time and then pulsates green every second.
• No SECAM L standard.
• No start-up. Standby LED flashes .
• No start-up from standby. Green LED comes on then blinks red.
• LED stays green when switching to standby.
• Bright picture. Flyback lines. (SW01TV551S SEAWAY repair tip)
• PSU pumps after switch on. LED flickers green and picture and sound are missing. Blubber form the loudspeakers.
• Line output transistor fails repeatedly.
• Excessive horizontal size.
• Bright raster.
• Retrace lines. Blank raster.
• Dark screen. Audio OK .
• Reduced horizontal size. Stripes in picture. on the left.
• Erratic start-up.
• No functions. Chirping.
• Dead.
• No picture. OSD and TXT OK .
• Green light flashing on picture.
• Picture and menu has slightly shifted horizontally. After approx 10 minutes sound becomes lower, crackles and then disappears completely. If appliance is restarted, sound is available again and error repeats itself.
• No picture. Three colored streaks on upper half screen. Audio OK.
• 8V input voltage missing from stabiliser.