SW99TV20 / SEAWAY [TV]

• No synchronisation.
• No functions. Short ticking noise after switch on.
• Frame cramping after a few hours.
• No shutdown with RC. (SW99TV20 tips)
• No start-up.
• Stuck in standby. Line output transformer crackling. (SEAWAY - SW99TV20 information)
• Blank screen. EHT and sound present. After several minutes picture is visible.
• No luminance.
• No line lock.
• Switches to protection mode (after start-up). (service info for SEAWAY -SW99TV20)
• Dead. PSU blown.
• Lines in picture. at bottom (when cold).
• Dead. Power supply OK.
• Poor contrast, picture appears negative except for one inch at right hand side.
• No audio. Picture OK .
• Snow in picture.
• Programming fault.
• Intermittently dead. No line drive.
• No audio. via SCART. OK via tuner .
• Reduced vertical size. Vertical foldover at bottom.
• Field collapse noticed when A1 is advanced.
• Reduced raster size. No tuning.
• Dark/light shading.
• White screen. Flyback lines. Audio OK .
• No functions.
• No LED display. (SW99TV20 tips)
• Tripping. (SW99TV20 tips)
• No picture. Excessive RGB.
• No vertical deflection. intermittently.
• Occasionally dead.
• Weak line lock
• No start-up from standby.
• Partial frame collapse with foldover at bottom, or frame jumping.
• Lack of height and no picture; sound can be heard slightly.
• No audio. No picture.
• Flyback lines with bright white or varying brightness on picture, mainly when warm. (SEAWAY - SW99TV20 information)
• No start-up. intermittently (when cold).
• Vertical foldover. after warm-up.
• No channels.
• White screen. Retrace lines. at top.
• Reduced vertical deflection. after warm-up.
• Partial field collapse (SW99TV20 tip from SEAWAY)
• Chirping.
• Striations and flyback lines.
• No reception. (SW99TV20 SEAWAY repair tip)
• Line freq half speed.
• Switches off by itself.
• Dead. Standby LED lit .
• No picture. Audio OK .
• Insufficient height. When channel changing picture moves to top or bottom.
• Faint lines across screen with picture bowed at top and bottom. Hum bars on picture.
• Tripping. Standby LED flashes .
• Black band over image.
• Intermittent no line drive-set appears dead - or line frequency drifts. (service info for SEAWAY -SW99TV20)
• Striations on frame or ringing. (SW99TV20 tip from SEAWAY)
• No vertical deflection.
• Bright raster. No picture.
• Rainbow effect on screen. (service info for SEAWAY -SW99TV20)
• Three colour rings over whole picture.
• Line stage does not start up correctly.
• No start-up. intermittently.
• No start-up. Standby LED flashes .
• Only blurred, coloured haloes can be seen.
• Bright picture. Flyback lines.
• No picture, only snow. intermittently.
• Enter service mode.
• No RC functions.
• Loss and poor sync after few hours.
• Timer and power modes cannot be selected. (SW99TV20 SEAWAY repair tip)
• Lack of brightness.
• No start-up from standby with RC.
• Bright picture. intermittently.
• Vertical collapse. (service info for SEAWAY -SW99TV20)
• No start-up. Standby lights up 2 times shortly.
• Stuck in standby.
• Gradual field fold-over
• Vertical jitter.
• Poor synchronisation for approx 4 hours.
• Dark on left hand side.
• Can only be turned ON and OFF via RC.
• Dark picture (intermittently). Audio OK .
• Bright raster. Flyback lines. Reduced horizontal size.
• No tuning or erratic tuning.
• Unstable picture.
• Dead.
• IC801 (STRS5707) faulty.
• Switches to standby.
• Blank raster (intermittently). OK via SCART .
• No OSD.
• No start-up. when cold.
• Bright raster. PSU pulsates.
• Vertical collapse (intermittently).
• Power regulator fails to start up.