SW99TV28 / SEAWAY [TV]

• Blank raster (intermittently). OK via SCART .
• Dead. PSU blown.
• Stuck in standby. (service info for SEAWAY -SW99TV28)
• Reduced raster size. No tuning.
• Switches off by itself.
• Vertical collapse (intermittently).
• Insufficient height. When channel changing picture moves to top or bottom.
• No vertical deflection.
• Lack of height and no picture; sound can be heard slightly. (SW99TV28 tip from SEAWAY)
• Vertical jitter.
• No picture, only snow. intermittently.
• Lack of brightness. (SEAWAY - SW99TV28 information)
• Lines in picture. at bottom (when cold).
• Dead. Standby LED lit .
• No tuning or erratic tuning.
• Vertical foldover. after warm-up. (SEAWAY - SW99TV28 information)
• Occasionally dead. (service info for SEAWAY -SW99TV28)
• Flyback lines with bright white or varying brightness on picture, mainly when warm.
• Bright raster. No picture.
• No LED display.
• Intermittent no line drive-set appears dead - or line frequency drifts.
• No luminance. (SEAWAY - SW99TV28 information)
• Bright picture. Flyback lines. (SW99TV28 tips)
• No audio. Picture OK .
• Snow in picture. (SW99TV28 tips)
• Switches to protection mode (after start-up).
• No channels.
• Bright picture. intermittently.
• Intermittently dead. No line drive.
• Partial field collapse
• Line freq half speed.
• Stuck in standby. Line output transformer crackling.
• No picture. Audio OK .
• Power regulator fails to start up.
• Dark/light shading.
• No start-up. intermittently.
• No RC functions.
• Programming fault.
• Unstable picture.
• Bright raster. PSU pulsates.
• No synchronisation.
• Weak line lock
• Dead. Power supply OK.
• Dead.
• IC801 (STRS5707) faulty.
• Faint lines across screen with picture bowed at top and bottom. Hum bars on picture. (SW99TV28 tip from SEAWAY)
• Timer and power modes cannot be selected.
• Can only be turned ON and OFF via RC.
• Bright raster. Flyback lines. Reduced horizontal size.
• White screen. Flyback lines. Audio OK .
• Enter service mode.
• Partial frame collapse with foldover at bottom, or frame jumping.
• No functions. Short ticking noise after switch on.
• Dark picture (intermittently). Audio OK .
• Tripping. Standby LED flashes .
• No start-up. (service info for SEAWAY -SW99TV28)
• Field collapse noticed when A1 is advanced.
• Tripping.
• Switches to standby. (SEAWAY - SW99TV28 information)
• Reduced vertical size. Vertical foldover at bottom.
• No start-up from standby.
• Striations on frame or ringing.
• No start-up. Standby LED flashes . (SW99TV28 tips)
• Blank screen. EHT and sound present. After several minutes picture is visible.
• Gradual field fold-over
• Line stage does not start up correctly.
• No vertical deflection. intermittently.
• No audio. No picture.
• No start-up from standby with RC.
• No shutdown with RC.
• Only blurred, coloured haloes can be seen. (SW99TV28 tip from SEAWAY)
• Three colour rings over whole picture.
• Reduced vertical deflection. after warm-up. (SW99TV28 tips)
• Striations and flyback lines.
• No audio. via SCART. OK via tuner .
• Dark on left hand side.
• Frame cramping after a few hours.
• Poor synchronisation for approx 4 hours.
• Vertical collapse.
• No functions. (service info for SEAWAY -SW99TV28)
• Black band over image.
• No start-up. Standby lights up 2 times shortly.
• No line lock.
• No picture. Excessive RGB.
• White screen. Retrace lines. at top.
• No start-up. intermittently (when cold).
• Poor contrast, picture appears negative except for one inch at right hand side.
• No OSD.
• Rainbow effect on screen. (SW99TV28 tip from SEAWAY)
• No reception.
• No start-up. when cold. (SW99TV28 tips)
• Loss and poor sync after few hours.
• Chirping.